苯丙氨酸改性树枝状聚赖氨酸的合成及表征

以双芴甲氧羰基赖氨酸(Di- Fmoc -Lysine)为支化单元采用固相多肽合成技术制备了一种树枝状聚赖氨酸.该聚合物表面活性氨基通过与芴甲氧羰基苯丙氨酸(Fmoc- Phe)反应获得表面完全替代的苯丙氨酸改性树枝状聚赖氨酸.产物的分子量和结构经MS和NMR进行了表征.研究结果表明,利用该方法得到的产物分子量单一,是一种潜在的理想非病毒治疗载体.     

一阶导数分光光度法测定血中一氧化碳含量的研究

本文通过理论推导及实验证明CO饱和血与正常血一阶导数的振幅高度比为一常数。将CO中毒检血氨稀释液取一半通CO至饱和,与另一半分别加入Na_2S_2O_4后在500～600nm测定一阶导数光谱在579nm处量出振幅值经计算可得CO在血中含量。     

Linear alkyl benzene sulphonate (LAS) degradation by immobilized Pseudomonas aeruginosa under low intensity ultrasound

We studied the LAS degradation of immobilized Pseudomonas aeruginosa with low-intensity ultrasonic and the influence of original LAS concentration, pH, rotary velocity and different conditions of low-intensity ultrasonic irradiation on the degradation of LAS. In our experiment, the degradation rate of LAS was the main index. We found that low-intensity ultrasonic irradiation could improve the metabolism of microorganism cells and promote the LAS biodegradation of immobilized cells. In the experiment, 50 mg/l LAS were used to simulate wastewater, and low-intensity ultrasonic was considered. We found the influence was obvious, and the optimal degradation rate was acquired when the conditions of ultrasonic were frequency 24 kHz, power 8 W, stimulation time 5 s, intermissive time 30 s, and total time 10 min. The LAS degradation rate of immobilized cells with ultrasonic were respectively 40% and 9.5% higher than that of the suspending cells and immobilized cells without irradiation.     

Dehydrogenation of ethylbenzene with CO2 over Cr-MCM-41 catalyst

M-MCM-41 catalysts (M: V, Cr, Fe, and Ga) prepared by direct hydrothermal synthesis (DHT) have been tested for dehydrogenation of ethylbenzene with CO₂. The synthesized materials were characterized by X-ray diffraction (XRD), N₂ adsorption (77 K), and diffuse reflectance UV–vis spectroscopic measurements. Cr-MCM-41 showed the highest activity among M-MCM-41 catalysts tested, resulting in the production of styrene with the conversion of 65% and the selectivity above 90%. The rate of styrene formation increased with increasing Cr loading up to 1.7 wt.%. It is suggested that Cr(VI)O₄ in tetrahedral coordination is formed as an active monochromate species and reduced to Cr(III)O₆ in octahedral coordination as a less active polychromate species during the reaction. Deactivated catalyst was regenerated by a treatment with gaseous oxygen or CO₂, during which redistribution as well as reoxidation of polymeric Cr(III)O₆ octahedra to monomeric Cr(VI)O₄ tetrahedra was observed. The rate of CO formation increased together with that of styrene formation, while the rate of H₂ formation decreased, with increasing partial pressure of CO₂. It was confirmed that reverse water-gas shift reaction took place over Cr-MCM-41 by a separate experiment. The rate of CO formation during the dehydrogenation of ethylbenzene with CO₂ over Cr-MCM-41 was well accounted for by assuming parallel occurrence of two reactions, i.e., direct oxidative dehydrogenation of ethylbenzene with CO₂ and simple dehydrogenation of ethylbenzene thermodynamically assisted by reverse water-gas shift reaction.     

二次乳化法(W/O)/W制备蛋白质流通色谱固定相的研究

以甲基丙烯酸缩水甘油酯为单体,二甲基丙烯酸乙二醇酯为交联剂,甲苯与正庚烷为有机致孔剂,20%的甘油水溶液为内水相(超孔致孔剂),利用二次乳化法制备了(W/O)/W乳液,通过紫外光引发悬浮聚合生成两类孔型高分子微球(BiPB).BiPB孔径为双峰分布,范围分别在10~100nm和1000~7300nm之间;而其体积平均粒径、比表面积、湿密度、静态吸附容量与不含超孔的微孔介质(MiPB)接近.修饰相同二乙胺密度的BiPB和MiPB介质虽在较低流速(5cm/min)下有相近的动态吸附容量,但在高流速(40cm/min)下BiPB的动态吸附容量约为MiPB的动态吸附容量的3倍,表明BiPB介质的超孔结构对孔内传质的强化作用,因而其更适合于高速的蛋白质色谱分离.     

基于MXenes的功能纤维的制备及其在智能可穿戴领域的应用

在电子信息和物联网技术的推动下,人类对可穿戴电子器件和智能织物的需求愈发突出,功能纤维作为智能可穿戴设备的重要载体,近年来获得快速发展。功能纤维的性能很大程度上取决于纤维的基础构筑单元。过渡金属碳/氮化物(MXenes)作为一种新兴的二维材料,凭借其高电导率、优异的可加工性能、可调节的表面特性以及出色的机械强度等优点,受到了极大的关注,也逐渐成为构筑功能纤维的重要单元。本文将主要综述MXenes的湿化学、熔融盐、无氟试剂刻蚀等方法和力学、电学、光学和化学稳定性等性能,阐述基于该材料制备的功能纤维在传感、储能以及其他智能领域的应用,最后讨论了基于MXenes材料的功能纤维的未来应用前景和技术挑战。     

The influence of silicone shell on double-layered microcapsules in intumescent flame-retardant natural rubber composites

The mechanisms of the thermal degradation of polyhedral oligomeric octaphenylsilsesquioxane (OPS), octa(nitrophenyl)silsesquioxane (ONPS), and octa(aminophenyl)silsesquioxane (OAPS) were investigated. The –NO₂ or –NH₂ substituents on the phenyl group affected the mechanism of the POSS thermal degradation. The thermal stabilities of OPS, ONPS, and OAPS were characterized by TG and FTIR. Thermal degradation of OPS included mainly the degradation of caged polyhedral oligomeric silsesquioxane structures and phenyl groups. Nitro or amino substituents decreased its thermal stability. The thermal degradation processes of OPS, ONPS, and OAPS differed. Phenyl groups and cyclobutadiene were observed in the OPS degradation products. Oxygen radicals that caused intensive CO₂ release between 350 and 450 °C were generated by the degradation of ONPS –NO₂. OAPS released mainly aminophenyl groups at 370 °C, whereas a small number of phenyl groups decomposed at 500 °C. The OAPS reactivity could enhance the thermal stability of POSS structure in the polyimide OAPS composites.     

基于MCM-41硬模板的镍铁磁性纳米管的合成及其磁性研究

以Si-MCM-41为硬模板,利用介孔材料的吸附作用,将Fe3+和Ni 2+按一定比例定量吸附组装到介孔材料的孔壁上;然后通过程序升温在900℃条件下高温焙烧,并经氢氟酸处理,得到直径大约为3.0nm的中空铁氧体纳米管.分别利用傅立叶变换红外光谱仪、扫描电镜、透射电镜、X射线衍射仪分析了合成材料的结构、组成、形貌;采用振动样品磁强计测定了其磁性能.结果表明,合成的镍铁氧体纳米管具有良好的管状形貌,其结构与分子筛MCM-41的结构相似,并具有良好的磁学性能.这说明MCM-41分子筛孔道结构具有可复制性,本研究可望为制备具有适当长径比的一维纳米磁性材料打下良好基础.     

Nitrogen doped porous carbon as excellent dual anodes for Li- and Na-ion batteries

Biomass-derived carbon materials have obtained great attention due to their sustainability,easy availability,low cost and environmentally benign.In this work,bamboo leaves derived nitrogen doped hierarchically porous carbon have been efficiently synthesized via an annealing approach,followed by an etching process in HF solution.Electrochemical measurements demonstrate that the unique porous structure,together with the inherent high nitrogen content,endow the as-derived carbon with excellent lithium/sodium storage performance.The porous carbon annealed at 700℃presents outstanding rate capability and remarkable long-term stability as anodes for both lithium-ion batteries and sodium-ion batteries.The optimized carbon delivers a high discharge capacity of 450 mAh/g after 500 cycles at the current density of 0.2 A/g for LIBs,and a discharge capacity of 180 mAh/g after 300 cycles at the current density of 0.1 A/g for SIBs.     

Iron-catalyzed propylene epoxidation by nitrous oxide: studies on the effects of alkali metal salts

SBA-15-supported iron catalysts with and without alkali metal salt modifications were studied for propylene oxidation by nitrous oxide. The reaction route could be dramatically changed from allylic oxidation to epoxidation by modification of the FeOx/SBA-15 catalyst with alkali metal salts. The KCl-1 wt % FeOx/SBA-15 (K/Fe = 5) catalyst exhibited the best catalytic performances for propylene epoxidation, over which ca. 50% propylene oxide selectivity could be gained at a 10% propylene conversion at 648 K. Characterizations with diffuse reflectance UV-Vis, XANES, and Raman spectroscopic techniques revealed that the modification with KCl increased the dispersion of the iron species and changed the local coordination of iron into a tetrahedral configuration on the inner surface of SBA-15. This tetrahedrally coordinated iron site, which was probably stabilized by potassium ions, was proposed to account for the epoxidation of propylene by nitrous oxide. At the same time, the reactivity of lattice oxygen was inhibited, and the acidity of the FeOx/SBA-15 was eliminated. These changes should also contribute to the increase in the selectivity to propylene oxide. The counteranions in the alkali metal salts exerted a significant influence on the catalytic behaviors probably via an electronic effect.