Microwave‐assisted polycondensation of 4‐octylaniline with dibromoarylene

The Pd‐catalyzed polycondensation of 4‐octylaniline with various dibromoarylenes was carried out under microwave heating. Microwave heating led to a decrease in the reaction time and an increase in the molecular weight of the polymers as compared to conventional heating. Microwave heating also allowed the catalyst loading to be reduced to 1 mol %, yielding polymerization results that were comparable to those under conventional heating and 5 mol % catalyst. Investigations regarding field‐effect transistors and organic photovoltaic cells using the obtained poly(arylamine) with azobenzene units revealed that increasing the molecular weight of the polymer led to improved device performance, including hole mobility and power conversion efficiency. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 536–542     

Fibre raman amplifier properties for applications to long-distance optical communications

This paper reviews recent theoretical and experimental studies on optical amplification by stimulated Raman scattering (Raman amplification) in single-mode optical fibres, and discusses its possible applications to long-distance optical communications. The fibre Raman amplifier can be used as an in-line optical amplifier in both repeaterless and non-regenerative all-optical repeater configurations. In the former application, signal transmission of over 400 km has been predicted theoretically, although high-power pump sources are considered to be required. In the latter configuration, in which optical fibre losses are compensated for by Raman gains, it has been shown that extremely long-distance transmission over more than 1000 km is feasible in terms of signal-to-noise ratio, where the distance achievable is mainly limited by the accumulation of Raman noise. Recent experimental demonstrations including bit-error rate measurements on the Raman amplified signal, and laser-diode pumped amplification, etc., are also reviewed. The results confirm the effectiveness of fibre Raman amplifiers in future long-haul systems.     

Fabrication and transport properties of multiwall carbon nanotube crossroads

A multiwall carbon nanotube crossroads has been fabricated by a manipulation technique using a glass microcapillary, and the low temperature transport properties investigated. The two-terminal conductance of an individual tube shows Tomonaga–Luttinger liquid behavior G∝T^α at high temperature and dI/dV ∝V ^α at low temperature. However, no evidence of such a power-law behavior is obtained in the four-terminal conductance at the junction, where the conductance shows an almost metallic behavior ‘corrected’ by weak localization. Weak localization would essentially appear in electron states at the junctions of MWNTs.     

Local structure analysis of smoky and colorless topaz using single crystal Al NMR

The angular dependence of the ²⁷Al NMR spectrum was measured for single crystals of smoky and colorless topaz, Al₂SiO₄(F,OH)₂. Smoky topaz was obtained by irradiating high energy neutrons to colorless topaz. The quadrupole coupling constant e²Qq/h and the asymmetry parameter η were obtained from the analysis of the angular dependences of quadrupole splitting of the ²⁷Al NMR spectrum. The local structures around the aluminum atoms in smoky and colorless topaz were discussed from the magnitude and the direction of the electric field gradient. The directions of principal axes of the EFG tensor of ²⁷Al were close to the directions of Al-O and Al-F bonds. The difference in the bond lengths between Al(1)-F(1) and Al(1)-F(2) was found to affect the x and y components of the EFG tensor.     

Evaluation of fine structure of tubular zeolite NaA membrane by FTIR-ATR and FIB-TEM.

A zeolite NaA (LTA) membrane supported by an alumina porous support tube for pervaporation (PV) dehydration of ethanol was characterized by transmission electron microscopy (TEM) using a focused ion beam (FIB) thin-layer specimen preparation technique and by Fourier transform infrared attenuated total reflectance method (FTIR-ATR) using a diamond prism as the waveguide. FIB-TEM clearly presented cross-section images up to about 15 microm depth from the membrane surface. FTIR-ATR monitored the Si-O asymmetric stretching vibration spectrum. The Si-O spectrum was compared with the TEM image and their relationships were discussed. By combining the two methods, we could study the thickness of surface LTA crystals, the grain boundary, the LTA/alumina interface structure and the crystallinity and density of materials inside of the alumina porous support. Consequently, fine structure changes of the LTA membrane corresponding to the hydrothermal synthesis condition could be sensitively detected.     

χ polarization induced in molecular glass of conjugated compound by all-optical poling

The paper presents the first report on χ⁽²⁾ polarization induced in molecular glass of conjugated compound by all-optical poling. Transparent thin film of molecular glass of 1,4-bis[2-[4-[N,N-di(p-tolyl)amino]phenyl]vinyl]benzene (BTAPVB) was prepared using a spin-cast technique. Dipolar as well as octupolar components in BTAPVB contributed to the formation of photoinduced χ⁽²⁾ polarization. Growth rate of χ⁽²⁾ polarization has good linear relation with E_ω⁴E_2ω, which suggested that the simultaneous processes of two-photon (ω + 2ω) and three-photon (ω + ω + ω) excitation on the same electronic level contributed to the formation of photoinduced χ⁽²⁾ polarization.     

Altered protein synthesis in rat kidney cells exposed to semiconductor materials

It is thought that the extensive industrial use of arsenic, gallium and indium, which have applications as the materials for III–V semiconductors, will increase human exposure to these compounds in the near future. We have undertaken the development of new biological indicators for assessing exposure to these elements. Element-specific alterations in protein synthesis patterns were expected to occur following exposure to arsenic compounds. We examined alterations in protein synthesis in primary cultures of rat kidney proximal tubule epithelial cells by sodium arsenite, gallium chloride and indium chloride, utilizing two-dimensional gel electrophoresis. After incubation with the chemicals for 20 h, newly synthesized proteins were labeled with [³⁵S]methionine. A protein with a molecular weight (M_r) of 30 000 was markedly induced on exposure to 10 μM arsenite or 300 μM gallium chloride, and synthesis of proteins with M_r values of 85 000, 71 000, 65 000, 51 000, 38 000 and 28 000 were also increased by exposure to arsenite and gallium chloride. No significant changes were observed upon exposure to indium. Some of these increased proteins could be heat-shock proteins.     

Existence of solution for Eguchi-Oki-Matsumura equation describing phase separation and order-disorder transition in binary alloys

In this paper we consider the Eguchi-Oki-Matsumura equation which consists of the fourth- and second-order coupled equations of parabolic type. It is shown that this system admits the unique global solution.     

Purification and characterization of gamma-enolase from various mammals.

The gamma subunit of enolase (gamma-enolase) was purified from the brain tissues of cow, dog, goat, pig, rabbit, and rat. The purification was achieved in only three steps: ammonium sulfate-precipitation, DE 53 cellulose ion-exchange chromatography, and polyacrylamide gel electrophoresis (PAGE) in a preparative mode. The purification procedure was comparatively more simple than previously reported methods, and the yield of gamma-enolase was sufficient for subsequent structural and immunological analyses. In all mammals, the purified gamma-enolase migrated in sodium dodecyl sulfate-PAGE (SDS-PAGE) with a molecular mass of 46 kilodaltons (kDa), and the immunological cross-reactivity between those gamma-enolases was very strong. The structural homology of these gamma-enolases was examined by peptide mapping using cyanogen bromide cleavage and subsequent two-dimensional electrophoresis. The resulting peptide patterns were highly similar and in cow, dog, and goat, the patterns were almost identical. These results indicate that structural homology, that is, the species non-specificity of gamma-enolase, appears to be very high.     

Bis(pentafluorophenyl) disulfide as a hydrogen abstractor and an electron acceptor from the resulting radical intermediate

The pentafluorobenzenethiyl radical is an efficient hydrogen abstractor from an activated methylene or methine group and bis(pentafluorophenyl) disulfide is an efficient electron acceptor from the resulting radical intermediate. Thus benzyl-OTBS ether was easily converted into the corresponding pinacol, and 2-phenyl-1,3-dioxanes are converted into the monobenzoates of diols.