Determination of partition coefficient and analysis of nitrophenols by three‐phase liquid‐phase microextraction coupled with capillary electrophoresis

A three‐phase hollow fiber liquid‐phase microextraction method coupled with CE was developed and used for the determination of partition coefficients and analysis of selected nitrophenols in water samples. The selected nitrophenols were extracted from 14 mL of aqueous solution (donor solution) with the pH adjusted to pH 3 into an organic phase (1‐octanol) immobilized in the pores of the hollow fiber and finally backextracted into 40.0 μL of the acceptor phase (NaOH) at pH 12.0 located inside the lumen of the hollow fiber. The extractions were carried out under the following optimum conditions: donor solution, 0.05 M H₃PO₄, pH 3.0; organic solvent, 1‐octanol; acceptor solution, 40 μL of 0.1 M NaOH, pH 12.0; agitation rate, 1050 rpm; extraction time, 15 min. Under optimized conditions, the calibration curves for the analytes were linear in the range of 0.05–0.30 mg/L with r²>0.9900 and LODs were in the range of 0.01–0.04 mg/L with RSDs of 1.25–2.32%. Excellent enrichment factors of up to 398‐folds were obtained. It was found that the partition coefficient (K_a/d) values were high for 2‐nitrophenol, 3‐nitrophenol, 4‐nitrophenol, 2,4‐dinitrophenol and 2,6‐dinitrophenol and that the individual partition coefficients (K_org/d and K_a/org) promoted efficient simultaneous extraction from the donor through the organic phase and further into the acceptor phase. The developed method was successfully applied for the analysis of water samples.     

Capillary electrophoresis for the analysis of antidepressant drugs: A review

Depression is a common mental disorder that may lead to major mental health problems, and antidepressant drugs have been used as a treatment of choice to mitigate symptoms of major depressive disorders by ameliorating the chemical imbalances of neurotransmitters in brain. Since abusing antidepressant drugs such as selective serotonin reuptake inhibitors and tricyclic antidepressant drugs can cause severe adverse effects, continuous toxicological monitoring of the parent compounds as well as their metabolites using numerous analytical methods appears pertinent. Among them, capillary electrophoresis has been popularly utilized since the method has a lot of advantages viz. using small amounts of sample and solvents, ease of operation, and rapid analysis. This review paper brings a survey of more than 30 papers on capillary electrophoresis of antidepressant drugs published approximately from 1999 until 2018. It focuses on the reported capillary electrophoresis techniques and their applications and challenges for determining antidepressant drugs and their metabolites. It is organized according to the commonly used capillary zone electrophoresis method, followed by non‐aqueous capillary electrophoresis and micellar electrokinetic chromatography, with details on breakthrough findings. Where available, information is given about the background electrolyte used, detector utilized, and sensitivity obtained.     

An efficient biosorption‐based dispersive liquid‐liquid microextraction with extractant removal by magnetic nanoparticles for quantification of bisphenol A in water samples by gas chromatography‐mass spectrometry detection

In this work, a simple, fast, sensitive, and environmentally friendly method was developed for preconcentration and quantitative measurement of bisphenol A in water samples using gas chromatography with mass spectrometry. The preconcentration approach, namely biosorption‐based dispersive liquid‐liquid microextraction with extractant removal by magnetic nanoparticles was performed based on the formation of microdroplet of rhamnolipid biosurfactant throughout the aqueous samples, which accelerates the mass transfer process between the extraction solvent and sample solution. The process is then followed by the application of magnetic nanoparticles for easy retrieval of the analyte‐containing extraction solvent. Several important variables were optimized comprehensively including type of disperser solvent and desorption solvent, rhamnolipid concentration, volume of disperser solvent, amount of magnetic nanoparticles, extraction time, desorption time, ionic strength, and sample pH. Under the optimized microextraction and gas chromatography with mass spectrometry conditions, the method demonstrated good linearity over the range of 0.5–500 µg/L with a coefficient of determination of R² = 0.9904, low limit of detection (0.15 µg/L) and limit of quantification (0.50 µg/L) of bisphenol A, good analyte recoveries (84–120%) and acceptable relative standard deviation (1.8–14.9%, n = 6). The proposed method was successfully applied to three environmental water samples, and bisphenol A was detected in all samples.     

Preparation and characterization of new sol–gel titanium(IV) butoxide–cyanopropyltriethoxysilane hybrid sorbent for extraction of polar aromatic amines

A new titanium(IV) butoxide-cyanopropyltriethoxysilane (Ti-CNPrTEOS) hybrid material was successfully synthesized for the use as sorbent for the extraction of polar aromatic amines. The sorbent was synthesized by hydrolysis and condensation of titanium(IV) butoxide and cyanopropyltriethoxysilane with the presence of hydrochloric acid as catalyst via sol–gel method. Several factors influencing the synthesized sorbent such as solvent selection, mol of water content, ratio of titanium(IV) butoxide and cyanopropyltriethoxysilane and aging temperature were investigated and optimized. The sorbents were characterized by fourier transform-infrared, field-emission scanning electron microscopy-energy, CHN elemental analysis and thermogravimetric analysis. The applicability of the sorbents for the extraction of polar aromatic amines by the batch sorption method was extensively studied and evaluated. Under the optimum synthesis conditions (tetrahydrofuran as solvent, 1.2 M of hydrochloric acid catalyst, 4 mol of water content with ratio of titanium(IV) butoxide and cyanopropylteriethoxysilane of 1:1 and aging temperature of 60 °C), the extraction showed high recovery towards the extraction of polar aromatic amines. The synthesized sorbent was successfully applied for the extraction of selected aromatic amines via batch sorption method in waste water samples prior to the gas chromatography-flame ionization detector separation. The synthesized sol–gel Ti-CNPrTEOS sorbent demonstrated the potential as an alternative extraction sorbent with higher selectivity towards polar aromatic amines.