Silicon-Based Integrated Optic Pressure Sensor Using Intermodal Interference between TM-Like and TE-Like Modes

In this paper, a silicon-based integrated optic pressure sensor using an intermodal interference between the fundamental TM-like and TE-like modes is described. The sensor consists of a micromachined rectangular diaphragm and a straight polystyrene optical waveguide passing over the diaphragm. Its sensitivity is theoretically known to be strongly dependent on the position of the waveguide over the diaphragm. To experimentally investigate such dependence, we fabricated a sensor with a 1.2 mm ×10 mm ×20 μm diaphragm, over which waveguides were placed at 50 μm intervals. The measured phase sensitivity was 98 mrad/kPa for the waveguide nearest to the diaphragm edge. The measurement was also carried out for the other waveguides. As theoretically expected, the largest sensitivity was obtained for the waveguide nearest to the edge.     

Isolation of mitogenic substance from sclerotia of Sclerotinia sclerotiorum IFO 9395 extracted with phosphate buffer.

The buffer extracts (3S) of sclerotia of Sclerotinia sclerotiorum IFO 9395 contained mitogenic substance(s) to murine splenocytes (Shinohara et al. Chem. Pharm. Bull., 38, 2219 (1990)). Although the native 3S was slightly mitogenic, heating of 3S induced significant mitogenic activity. To isolate the mitogen, we separated 3S by ion-exchange and gel filtration chromatographies. The isolated mitogen, named sclerogen, has a molecular mass of 32 kilodaltons (kDa) on sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) and the isoelectric point (pI) of 5.9 by chromatofocusing. Sclerogen was significantly mitogenic in vitro against murine splenocytes after heat denaturation, and also showed the augmentation of the primary mixed lymphocyte reaction (MLR) in vitro. However, sclerogen did not show the activation of an alternative pathway of complement and hemagglutination activity. These results suggest that sclerogen is a unique mitogen which differs from lectins and shows mitogenicity after heat denaturation.     

Constructing finitely presented monoids which have no finite complete presentation

Squier (1987) showed that if a monoid is defined by a finite complete rewriting system, then it satisfies the homological finiteness condition FP₃, and using this fact he gave monoids (groups) which have solvable word problems but cannot be presented by finite complete systems. In the present paper we show that a monoid cannot have a finite complete presentation if it contains certain special elements. This observation enables us to construct monoids without finite complete presentation in a direct and elementary way. We give a finitely presented monoid which has (1) a word problem solvable in linear time and (2) linear growth but (3) no finite complete presentation. We also give a finitely presented monoid which has (1) a word problem solvable in linear time, (2) finite derivation type in the sense of Squier and (3) the property FP_∞, but (4) no finite complete presentation.     

Linear and Nonlinear Optical Properties Of Racemic (±)2-(α-Methylbenzylamino)-5-Nitropyridine Single Crystals

Linear and nonlinear optical properties of racemic (±)2-(α-methylbenzylamino)-5-nitropyridine ((±)MBANP) single crystals have been comprehensively investigated and compared with those of the enantiomorph (–)2-(α-methylbenzylamino)-5-nitropyridine ((–)MBANP) crystals. (±)MBANP crystal exhibits very high chemical and physical stability, but relatively small nonlinear optical coefficients (d₃₁ = 6.8 pm/V, d₃₂ = 4.7 pm/V, d₃₃ = 0.84 pm/V). A comparison between the nonlinear optical coefficients of (±)MBANP and (–)MBANP demonstrates the validity of the oriented-gas model in molecular crystals that neglects all the contributions from intermolecular interaction.     

Wavelength dependence in photochemical vapor deposition of aluminum film using dimethylaluminum hydride

In photochemical vapor deposition of aluminum film on silicon using dimethylaluminum hydride, (CH₃)₂AlH, a surface reaction dominated below a (CH₃)₂AlH pressure of 0.3 m Torr at 200°C, which was induced only with the 160 nm band emitted from a deuterium lamp. A gas-phase reaction occurred above 0.3 mTorr at 200°C, which could be induced by both 160 nm and 240 nm emission bands from the lamp. To distinguish between surface ad gas-phase reactions, a thickness profile was used. At 240°C the surface reaction could be induced even by the 240 nm band, while the deposits formed under illumination of the two bands were thinner than those obtained with only the 240 nm band, indicating occurrence of vacuum ultraviolet (VUV)-enhanced desorption. The mechanism responsible for the observed wavelength dependence in unclear. The electrical resistivity of the films deposited at 200°C was 4.5 μΩ cm, which did not change with wavelength.     

Determination of midodrine in human plasma by high-performance liquid chromatography with fluorescence detection.

A simple and sensitive fluorometric high-performance liquid chromatographic method was developed for the determination of midodrine in human plasma. After liquid-liquid extraction from plasma, the drug and 2-phenylglycinol (internal standard) were convened into the corresponding fluorescent derivatives by reaction with 3,4-dihydro-6,7-dimethoxy-4-methyl-3-oxoquinoxaline-2-carbonyl chloride, a fluorescence derivatization reagent for amines. The derivatives were separated within 30 min on a reversed-phase column using isocratic elution with acetonitrile-methanol-water (10:30:60, v/v) and were detected spectrofluorometrically at 485 nm with excitation at 400 nm. The detection limit for midodrine was 0.3 pmol (76 pg) per mL plasma at a signal-to-noise ratio of 3.     

Stability analysis of abnormal multiplication of plankton using parameter identification technique

This paper presents the mathematical approach for the abnormal multiplication of plankton. An abnormal multiplication can be expressed as an unstable problem and the stability of the system is investigated by introducing eigenvalues of a mathematical equation. The stability of the system can be judged by an eigenvalue based on the Lyapunov's stability theory. In this paper, the Arnoldi‐QR method is used to obtain eigenvalues and eigenvectors of the system. The mode superposition method is employed to create spatial distribution needed to analyse the stability. To obtain the objective eigenvalue, the parameter identification technique is employed. The finite element method is used for the discretization in space. Lake Kasumigaura, which is located in Ibaraki Prefecture in Japan, is selected and actual data in 1975, 1976, 1991 and 2000 are used in order to investigate the stability of the specified lake in Japan. Copyright © 2004 John Wiley & Sons, Ltd.