Sulfonated poly(aryl ether ketone)s containing naphthalene moieties obtained by direct copolymerization as novel polymers for proton exchange membranes

A series of sulfonated poly(aryl ether ketone)s (SPAEKs) were prepared by aromatic nucleophilic polycondensation of 2,6‐dihydroxynaphthalene with 5,5′‐carbonyl‐bis(2‐fluorobenzenesulfonate) and 4,4′‐difluorobenzophenone. The structure and degree of sulfonation (DS) of the SPAEKs were characterized using ¹H NMR spectroscopy. The experimentally observed DS values were close to the expected values derived from the starting material ratios. The thermal stabilities of the SPAEKs were characterized by thermogravimetric analysis, which showed that in acid and sodium salt forms they were thermally stable in air up to about 240 and 380 °C, respectively. Transparent membranes cast from the directly polymerized SPAEKs exhibited good mechanical properties in both dry and hydrated states. The dependence of water uptake and of membrane swelling on the DS at different temperatures was studied. SPAEK membranes with a DS from 0.72 to 1.60 maintained adequate mechanical properties after immersion in water at 80 °C for 24 h. The proton conductivity of SPAEK membranes with different degrees of sulfonation was measured as a function of temperature. The proton conductivity of the SPAEK films increased with increased DS, and the highest room temperature conductivity (4.2 × 10^?2 S/cm) was recorded for a SPAEK membrane with a DS of 1.60, which further increased to 1.1 × 10^?1 S/cm at 80 °C. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2866–2876, 2004     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

Approximating Clarke’s subgradients of semismooth functions by divided differences

We show that the algorithm presented in an earlier paper by Studniarski (Numer. Math., 55:685–693, 1989) can be applied, after only a small modification, to approximate numerically Clarke’s subgradients of semismooth functions of two variables. Results of computational testing of this modified algorithm are also reported.      

Aryl pyrrolidinones via radical 1,4-aryl migration and 5-endo-trig cyclisation of N-(2-bromoallyl)arylcarboxamides

Radical reaction of a series of N-(2-bromoallyl)arylcarboxamides led to the production of 4-arylpyrrolidin-2-ones and directly reduced materials in comparable yields. A cascade process, involving sequential 5-exo-trig spirocyclisation, β-scission, and 5-endo-trig cyclisation of the resulting acyl radical, is proposed to explain the pyrrolidinone products.     

A search for fractional electric charge in sea water

The magnetic levitation technique has been used to test for fractional electric charge in sea water, using steel balls coated with sea water residue by evaporation. The objective was to reach concentration levels below 1 g^?1 which might result from cosmic ray interactions. Four stages of increasing sensitivity are reported: (1) residue from direct evaporation of unprocessed sea water, (2) residue from sea water samples enriched by ion exchangen, (3) residue reduced by high temperature evaporation, and (4) hypothetical enrichment by dilution and separation of soluble residue. Stages 1–3 are based on the generally accepted preferential retention of fractional charge during evaporation, but stage 4 limits are subject to uncertainties in the enrichment process. No evidence for fractional charge was found in a total of about 130 samples tested in these four stages. Samples containing positive and negative ions were tested separately, and concentration limits are reported for each of the stages. Levels in the region 0.01–0.1g^?1 were reached in stage 3, and 0.001 g^?1 in stage 4.     

Full-Wave Analyses for a Multi-Layered Microstrip Patch Antenna

This paper describes numerical modelling of a dual band multi-layered microstrip patch antenna operating at 35GHz on an in-house semi-insulating GaAs substrate. The simulated and measured resonant frequencies at both lower and upper resonant frequencies will be compared to check the accuracy of the different numerical modelling techniques.     

Sulfonated poly(aryl ether ether ketone ketone)s containing fluorinated moieties as proton exchange membrane materials

A series of sulfonated poly(aryl ether ether ketone ketone)s statistical copolymers with high molecular weights were synthesized via an aromatic nucleophilic substitution polymerization. The sulfonation content (SC), defined as the number of sulfonic acid groups contained in an average repeat unit, could be controlled by the feed ratios of monomers. Flexible and strong membranes in sodium sulfonate form could be prepared by the solution casting method, and readily transformed to their proton forms by treating them in 2 N sulfuric acid. The polymers showed high T_gs, which increased with an increase in SC. Membranes prepared from the present sulfonated poly(ether ether ketone ketone) copolymers containing the hexafluoroisopropylidene moiety (SPEEKK‐6F) and copolymers containing the pendant 3,5‐ditrifluoromethylphenyl moiety (SPEEKK‐6FP) had lower water uptakes and lower swelling ratios in comparison with previously prepared copolymers containing 6F units. All of the polymers possessed proton conductivities higher than 1 × 10^?2 S/cm at room temperature, and proton conductivity values of several polymers were comparable to that of Nafion at high relative humidity. Their thermal stability, oxidative stability, and mechanical properties were also evaluated. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2299–2310, 2006