Hybrid abstractions of affine systems

This paper considers the problem of building a set of hybrid abstractions for affine systems in order to compute over approximations of the reachable space. Each abstraction is based on a decomposition of the continuous state space that is defined by hyperplanes generated by linear combinations of two vectors. The choice of these vectors is based on consideration of the dynamics of the system and uses, for example, the left eigenvectors of the matrix that defines these dynamics. We show that the reachability calculus can then be performed on a combination of such abstractions and how its accuracy depends on the choice of hyperplanes that define the decomposition.     

基于MATLAB的异步电动机线性化控制系统的仿真

从异步电动机在同步旋转坐标系下的状态方程出发，在一定的条件下，对其系数矩阵简化．推出异步电动机的线性化控制模型．并基于该模型得出异步电动机的线性化控制系统．以给定电机为例，对该模型的有效性、响应用MATLAB进行仿真分析．验证的结果说明上述模型具有实用价值．     

RO-heparin Inhibits L-Selectin-mediated Neutrophils Adhesion to Vascular Endothelium Under Flow Conditions

Introduction Migrationandrecruitmentofleukocytesfromblood toinflammatorylesionsitesaresequentiallyregulated byadhesionmoleculesandtheirreceptors[1].These lectinfamilyplaysamajorroleininitiatingattachement ofneutrophilstotheactivatedendothelium.P selectin,…     

Optical spectroscopy of single InAs/InP quantum dots around λ=1.55 μm

We discuss the preparation and spectroscopic characterisation of a single InAs/InP quantum dot suitable for long-distance quantum key distribution applications around λ=1.55 μm. The dot is prepared using a site-selective growth technique which allows a single dot to be deposited in isolation at a controlled spatial location. Micro-photoluminescence measurements as a function of exciton occupation are used to determine the electronic structure of the dot. Biexciton emission, shell filling and many-body re-normalization effects are observed for the first time in single InAs/InP quantum dots.     

AFM of adsorbed polyelectrolytes on cellulose I surfaces spin-coated on silicon wafers

Thin layers of cellulose I nanocrystals were spin-coated onto silicon wafers to give a flat model cellulose surface. A mild heat treatment was required to stabilize the cellulose layer. Interactions of this surface with polyelectrolyte layers and multilayers were probed by atomic force microscopy in water and dilute salt solutions. Deflection–distance curves for standard silicon nitride tips were measured for silicon, cellulose-coated silicon, and for polyelectrolytes adsorbed on the cellulose surface. Transfer of polymer to the tip was checked by running deflection–distance curves against clean silicon. Deflection–distance curves were relatively insensitive to adsorbed polyelectrolyte, but salt addition caused transfer of cationic polyelectrolyte to the tip, and swelling of the polyelectrolyte multilayers.     

化学键合吸附剂的合成及吸附行为

在无定型硅胶上化学键合十八烷基三氯硅烷，键合率17%-20％，粒度5μm-10μm，以此键合的吸附剂可有效地吸附香烟烟气中的焦油、亚硝胺，吸附率分别为15%-18％和37%-43％，研究了化学键合吸附剂的粒度和加入量对吸附性能的影响。     

Study of the acidity of H3PW12O40 supported on activated carbon by microcalorimetry and methanol dehydration reaction

H₃PW₁₂O₄₀/activated carbon catalysts have been studied by microcalorimetry and by the dehydration of methanol to dimethyl ether. It has been shown that the acidity of the polyacid is greatly reduced upon grafting on activated carbon. The decrease is so high that, at low polyanion loadings, the catalysts are relatively inactive in the dehydration of methanol to dimethyl ether.     

Column selection and method development for the separation of nucleoside phosphotriester diastereoisomers, new potential anti-viral drugs. Application to cellular extract analysis

Analytical HPLC methods using derivatized cellulose and amylose chiral stationary phases used in normal and reversed-phase modes were developed for the diastereoisomeric separation of mononucleotide prodrugs (pronucleotides) of 3'-azido-2',3'-dideoxythymidine (AZT). The resolutions were performed with two silica-based celluloses using normal and reversed-phase methodologies: Tris-3,5-dimethylphenylcarbamate (Chiralcel OD-H and Chiracel OD-RH) and Tris-methylbenzoate (Chiralcel OJ and OJ-R). Two amyloses phases, Tris-3,5-dimethylphenylcarbamate (Chiralpak AD) and Tris-(S)-1-phenylethylcarbamate (Chiralpak AS), were used in normal-phase mode. Additionally, we developed separation using two stationary phases with immobilized cyclodextrins in reversed-phase and polar-organic modes. The mobile phase and the chiral stationary phase were varied to achieve the best resolution. Different types and concentration of aliphatic alcohols, acetonitrile or water in the mobile phase were also tested for the different separation modes. An optimal baseline separation (Rs > 1.5) was readily obtained with all silica-based celluloses and amyloses using a normal-phase methodology. The different columns gave complementary results in term of resolution. Limits of detection and quantification were 0.12-0.20 and 0.40-0.67 microm, respectively. This analytical method was applied in a preliminary study for the pronucleotide 2 quantification in cellular extract.