Analysis of ion binding on humic substances and the determination of intrinsic affinity distributions

Humic substances are characterized by a variable electric potential and by a variety of binding sites leading to chemical heterogeneity. Binding of ions to these substances is influenced by both factors. A methodology based on acid—base titrations at several salt levels is presented that allows for the assessment of an appropriate electrostatic double-layer model and the intrinsic proton affinity distribution. The double-layer model is used for the conversion of pH to pH_S for each data point, where H_S is the proton concentration in the diffuse layer near the binding site. It is shown that with an appropriate double-layer model the proton binding curves at different salt levels converge into one “master curve” when plotted as a function of pH_S. The intrinsic proton affinity distribution can then be derived from the “master curve” using the LOGA method. A rigorous analysis of metal binding to humic substances is complex and in practice is not feasible. Under two different (simplifying) assumptions, namely fully coupled and uncoupled binding, it is shown how intrinsic metal ion affinity distributions can be obtained. Model calculations show that apparent metal ion affinity distributions do not resemble the intrinsic metal ion affinity distribution.     

Modeling of confinement-induced phase transitions for surfactant layers on amphiphilic surfaces

A self-consistent field model is used to consider a solution of positively charged surfactants up to its critical micellization concentration adsorbing onto two surfaces in close proximity. Each surface mimics a polystyrene sulfonate interface; that is, hydrophobic properties are combined with a (fixed) negative charge. We observe large and sudden changes in adsorption as a function of separation, which are not normally considered when interpreting surface force measurements. The parameters are chosen such that the adsorbed surfactant layer is of a monolayer type when the surfaces are far apart. A typical interaction curve is presented for a fixed surfactant chemical potential, which is extracted from the set of adsorption isotherms each with a fixed slit width. When the slit width approaches the thickness of the two surfactant layers, a first-order phase transition takes place, which is driven by the unfavorable hydrophobic-water contacts. At the transition, the average orientation of the surfactants switches from a high concentration of tails at the surface to a bilayer configuration where tail profiles from both sides merge in the center. The headgroups are pulled slightly away from the surface. The interaction force jumps from a weak electrostatic repulsion at large distances (two effectively positively charged surface layers repel each other) to a strong electrostatic attraction at short distances (the central surfactant bilayer is attracted to the oppositely charged surfaces). The amount of adsorbed surfactants tend to decrease with decreasing distance between the surfaces but suddenly increases at the transition. Because of this, we anticipate that in surface force experiments, for example, there is a hysteresis associated with this transition: the forces and also the adsorbed amounts depend not only on the distance between the surfaces but also on the history if nonsufficient equilibration times are implemented.     

Adsorption of humic acid on goethite: isotherms, charge adjustments, and potential profiles

The adsorption of natural organic matter (NOM) on mineral (hydr)oxide plays an important role in the evaluation of the speciation of toxic metal ions in the environment. Because both NOM and mineral oxide have variable charges that adjust upon adsorption, a good understanding of proton binding is required before the binding of metal ions can be understood. In this study, the adsorption of purified Aldrich humic acid (PAHA) on goethite was examined as a function of the environmental conditions (pH, salt concentration, and free concentration of PAHA) together with the proton adsorption to PAHA, goethite, and their mixtures. The induced charges on both components were separated on the basis of the difference between the charge/pH curves of the mixture and those of the single components. The electrostatic potential profile across the adsorbed layer was obtained as a numerical solution of the Poisson-Boltzmann equation using the charge density of the adsorbed PAHA and the goethite surface. From the quantitative evaluation of the induced charge on both components, it is revealed that the degree of the charge adjustment is related to the electrostatic affinity between the PAHA segments and the goethite surface, the electrostatic repulsion between the PAHA segments, and the electrostatic shielding by salt ions. Considering the charge distribution of the adsorbed PAHA at the goethite surface, it is concluded that the change of the charge adjustment is sensitive to that of the conformation of the adsorbed PAHA. From the detailed inspection of the assumptions made and the comparison with the reported theoretical calculations, the obtained potential profiles are considered to broadly reflect the true potential profiles. Because a charge adjustment is not frequently considered in detail in relation to the NOM adsorption on metal (hydr)oxides, the obtained results can form the basis for the further development of modeling of the adsorption of NOM on (hydr)oxide surfaces.     

Influence of NaCl on the behavior of PEO-PPO-PEO triblock copolymers in solution, at interfaces, and in asymmetric liquid films

The solution behavior of the polymeric surfactant Pluronic F127 (PEO(99)PPO(65)PEO(99)) and its adsorption behavior on aqueous-silica and aqueous-air interfaces, as well as the disjoining pressure isotherms of asymmetric films (silica/aqueous film/air) containing F127, are studied. The interfacial properties of adsorbed F127 layers (the adsorbed amount Gamma and the thickness h) as well as the aqueous wetting film properties [film thickness (h) and refractive indexes] were studied via ellipsometry. The solution properties of F127 were investigated using surface tensiometry and light scattering. The interactions between the air-water and silica-water interfaces were measured with a thin film pressure balance technique (TFB) and interpreted in terms of disjoining pressure as a function of the film thickness. The relations between the behaviors of the asymmetric films, adsorption at aqueous air, and aqueous silica interfaces and the solution behavior of the polymeric surfactant are discussed. Special attention is paid to the influence of the concentrations of F127 and NaCl. Addition of electrolyte lowers the critical micelle concentration, diminishes adsorption on silica, and increases the thickness of the asymmetric film.     

Heterocoagulation of Hydrophobic Particle and Bubble during Microflotation

The laws of the interaction between a gas bubble and a hydrophobic solid particle were studied. The range of the system parameters that can ensure the heterocoagulation of the particle and the bubble was determined.     

Confinement-induced symmetry breaking of interfacial surfactant layers

Interaction forces between mesoscopic objects are fundamental to soft-condensed matter and are among the prime targets of investigation in colloidal systems. Surfactant molecules are often used to tailor these interactions. The forces are experimentally accessible and for a first theoretical analysis one can make use of a parallel-plate geometry. We present molecularly realistic self-consistent field calculations for an aqueous nonionic surfactant solution near the critical micellization concentration, in contact with two hydrophobic surfaces. The surfactants adsorb cooperatively, and form a monolayer onto each surface. At weak overlap the force increases with increasing compression of the monolayers until suddenly a symmetry braking takes place. One of the monolayers is removed jump-like and as the remaining monolayer can relax, some attraction is observed, which gives way to repulsion at further confinement. The restoring of symmetry at strong confinement occurs as a second-order transition and the force jumps once again from repulsion to attraction. It is anticipated that the metastable branch of the interaction curve will be probed in a typical force experiment. Under normal conditions pronounced hysteresis in the surface force is predicted, without the need to change the adsorbed amount jump-like.     

Titration microcalorimetry of poly(vinylpyrrolidone) and sodium dodecylbenzenesulphonate in aqueous solutions

Microcalorimetric titrations are carried out on solutions containing the anionic surfactant sodium dodecylbenzenesulphonate (SDBS), and mixtures of SDBS and the uncharged polymer poly(vinylpyrrolidone) (PVP). Measurements are taken at different temperatures. Micellisation of SDBS is driven by hydrophobic bonding. The interaction enthalpy of mixed PVP/SDBS systems shows clearly a consecutive endothermic and exothermic region with increasing surfactant concentration. The endothermic part can be looked upon as an incremental binding isotherm and reflects the number of surfactant molecules involved in the association process. The exothermic region features inverse hydrophobic bonding behaviour. This is related to the flexible nature of the adsorbent, i.e. the polymer. Electrostatic repulsion between neighbouring surfactant molecules causes at increased surfactant concentrations structural rearrangements of the polymer-surfactant complexes. This is accompanied by losing inter- and intrachain linking and entropy gain since the expanded complexes can move more freely. Additional surfactants continue to adsorb on the vacant hydrophobic adsorption sites. The influence of the initial amount of polymer and the electrolyte concentration support our proposals.     

Adsorption of Cationic Surfactants on Silica Surface: 1. Adsorption Isotherms and Surface Charge

Adsorption isotherms of cationic surfactant, dodecylpyridinium chloride, on an Aerosil OX50 and isotherms of surface charge against the background of 0.001- and 0.1-M KCl solutions at pH 7 and 9 were measured and analyzed. Different forms of adsorption isotherms of surfactants at low and high electrolyte concentrations are explained from differences in the formation of the surface charge of Aerosil. Comparison of the isotherms of surfactant adsorption and surface charge allowed us to make conclusions about the surfactant orientation and structure of an adsorption layer, as well as to determine the fraction of surfactant molecules in the first and second adsorption layers.     

Comparison of strontium retardation for kaolinite,illite, vermiculite and allophane

Journal of Radioanalytical and Nuclear Chemistry - Adsorption and retardation of Sr2+ by four clays were investigated, which were evaluated by using the distribution coefficient (K D ) and average...     

Thinning of wetting films formed from aqueous solutions of non-ionic surfactant

We investigated the thinning of wetting films formed from aqueous solution of non-ionic triblock copolymer Pluronic F127 on the surface of silica using a home-made thin film balance and time-resolved ellipsometry. Imaging ellipsometry was used to visualize the film structures at subsequent stages of their development. The results unambiguously show that the time required for the formation of steady films strongly depends on the electrolyte concentration. When increasing the latter from 10(-4) to 0.1 M, this time typically increases with several orders of magnitude, from a few minutes to several hours. Moreover, for sufficiently large amounts of salt, two characteristic relaxation regimes can be clearly identified. After initial quick thinning, further thinning slows down enormously. These typical kinetic regimes are thought to result from the coupled dependencies of the bulk and interfacial properties of F127 on salt concentration. Possible explanations of the phenomenon are discussed.