Nuclear spin-lattice relaxation mechanisms in kaolinite confirmed by magic-angle spinning

Spin-lattice relaxation mechanisms in kaolinite have been reinvestigated by magic-angle spinning (MAS) of the sample. MAS is useful to distinguish between relaxation mechanisms: the direct relaxation rate caused by the dipole-dipole interaction with electron spins is not affected by spinning while the spin diffusion-assisted relaxation rate is. Spin diffusion plays a dominant role in ¹H relaxation. MAS causes only a slight change in the relaxation behavior, because the dipolar coupling between ¹H spins is strong. ²⁹Si relaxes directly through the dipole-dipole interaction with electron spins under spinning conditions higher than 2 kHz. A spin diffusion effect has been clearly observed in the ²⁹Si relaxation of relatively pure samples under static and slow-spinning conditions. ²⁷Al relaxes through three mechanisms: phonon-coupled quadrupole interaction, spin diffusion and dipole-dipole interaction with electron spins. The first mechanism is dominant, while the last is negligibly small. Spin diffusion between ²⁷Al spins is suppressed completely at a spinning rate of 2.5 kHz. We have analyzed the relaxation behavior theoretically and discussed quantitatively. Concentrations of paramagnetic impurities, electron spin-lattice relaxation times and spin diffusion rates have been estimated.     

Enantiomeric purity determination of malic acid in apple juices by multi-beam circular dichroism detection

A multi-beam circular dichroism (CD) detector which is easily constructed by inserting inexpensive optics into a conventional photo-diode array detector has an advantage of simultaneous detection of the absorbance and CD. The enantiomeric purity determination of malic acid in beverages was performed by this detection system. Malic acid when complexed with Cu(II) was found to have an absorbance maximum at around 750 nm. The L-malic acid-Cu(II) complex showed a positive Cotton effect in its absorbance band and its anisotropy factor (delta epsilon/epsilon) was relatively large at about 1/170. This complex was retained on a reversed-phase column with the addition of racemic 2-hydroxy-3-methylbutyric acid to the mobile phase as the ligand. A plot of the relative peak areas between the CD and the absorption (delta abs/abs) versus optical purity showed good linearity with a correlation coefficient of 0.999, and the precision expressed as the relative standard deviation of the errors from the regression line was +/-2.7% (2sigma). The accuracy of the proposed method was assessed by capillary electrophoresis. Eight commercially available juice products were analyzed using this method. Five of them were thought to be adulterated with synthetic malic acid.     

Adsorption of pertechnetate ion on active carbon from acids and their salt solutions

The adsorbability of pertechnetate ion (TcO ₄ ^– ) reached 96% for an active carbon at the 0.1 g/50 ml concentration level, increasing with diminution of acid and its salt concentrations, and depending on the type of anions present. With constant anion concentration, TcO ₄ ^– adsorbability rose with decreasing pH in the acidic region, followed in the region around neutrality by a plateau, and in the basic region by an appreciable decline of TcO ₄ ^– adsorbability. In the acidic region, part of once-adsorbed TcO ₄ ^– appeared to be displaced by other anions. Reversibility was noted between the adsorption and desorption of TcO ₄ ^– .     

Novel self-assembled monolayers of disulfides with bicyclo[2.2.2]octane moieties of Au(111)

A series of disulfides containing bicyclo[2.2.2]octane moieties have been synthesised and their self-assembled monolayers (SAMs) on Au(111) have been characterized using scanning tunnelling microscopy (STM).     

Synthesis and structure of 16 pi octaalkyltetraphenylporphyrins

The oxidized octaethyltetraphenylporphyrin (1, OETPP) and the corresponding newly prepared octaisobutyltetraphenylporphyrin (3, OisoBuTPP) could be isolated from the reaction of OETPPLi2 (or OisoBuTPPLi2) with SOCl2. The X-ray analysis and the characteristic UV-vis spectra of 1 and 3 revealed that these are the first examples of 16 pi nonaromatic porphyrins.     

Bromination by means of sodium monobromoisocyanurate (SMBI)

A variety of aromatic compounds with both activating and deactivating substituents were brominated with sodium monobromoisocyanurate (SMBI) 1, diethyl ether, diethyl ether-methanesulfonic acid, trifluoroacetic acid, or sulfuric acid were employed as solvents. Thus nitrobenzene was conveniently brominated in sulfuric acid, benzene was readily monobrominated in diethyl ether-methanesulfonic acid, and phenol was selectively brominated at the ortho position under mild conditions in refluxing diethyl ether. With substituents that are easily protonated, trifluoroacetic acid may be employed as solvent in the reaction with 1, in contrast NBS was ineffective in trifluoroacetic acid. This renders 1 a superior reagent relative to NBS. In addition to aromatics, alkenes, ketones and esters were also brominated with 1. Diethyl malonate was brominated with 1 and then subjected to a Bingel reaction with NaH to afford the desired methanofullerene in reasonable yield.     

New alkaline earth aluminum hydride with one-dimensional zigzag chains of [AlH6]: synthesis and crystal structure of BaAlH5

The title hydride and its deuteride were successfully synthesized. The crystal structure of the deuteride was determined by time-of-flight neutron powder diffraction. BaAlD(5) crystallizes with a new orthorhombic structure in space group Pna2(1) (No. 33), cell parameters a = 9.194(1) A, b = 7.0403(9) A, and c = 5.1061(6) A, Z = 4. BaAlH(5) is the first example that contains one-dimensional zigzag chains of [AlH(6)] along the crystallographic c axis.     

Application of europium(III) extraction with organophosphinic acid to liquid membrane transport

The extraction behavior of Eu(III) has been studied using di(2,4,4-trimethylpentyl)phosphinic acid (DTMPPA, HA) in kerosene. Europium was extracted as Eu(HA₂)₃ with the extraction constant of 2.0·10^–3. This extraction system was applied to the transport of Eu(III) across a DTMPPA liquid membrane supported on porous polytetrafluoroethylene. Europium was quantitatively moved through the liquid membrane containing 0.1M (HA)₂ as a mobile carrier from the feed solution of pH above 3 into the product solution of 0.1M HNO₃, yielding a concentration factor of ten. The transport rate increased with increasing pH and DTMPPA concentration.     

The role of the solvent in equilibrium and kinetic aspects of metal chelate extractions

Equilibria and kinetics for the extraction of nickel(II) and copper(II) by 2-hydroxy-5-nonylbenzophenone oxime (LIX 65N) in seven organic solvent systems were studied in order to test the validity of several hypotheses related to the role of the solvent in equilibrium and kinetic aspects of metal chelate extraction. For the nickel—LIX 65N system, the extraction constant is essentially independent of the solvent system, whereas for the copper—LIX 65N system, the extraction constant is not independent of solvent; this indicates that while the stoichiometry of the nickel chelate remains the same in all solvents, that of copper does not. The observed rate constant for the nickel—LIX 65N extraction was found to vary inversely with the LIX 65N distribution constant as predicted from a mechanism involving slow formation of the 1:1 complex. The observed reaction rate constant for the copper—LIX 65N varied inversely with the square of the distribution constant, also in accordance with the previously postulated mechanism of the slow formation of the 2:1 copper complex. This study, therefore, unequivocally eliminates the interfacial mechanism in favor of the homogeneous chemical reaction mechanism for the extraction of metal ions by LIX 65N, as well as by other similar high-molecular-weight extractants.