THE EFFECTS OF THROMBOXANE INHIBITORS ON THE MICROVASCULAR AND TUMOR RESPONSE TO PHOTODYNAMIC THERAPY

Abstract— Vascular stasis and tissue ischemia are known to cause tumor cell death in several experimental models after photodynamic therapy (PDT); however, the mechanisms leading to this damage remain unclear. Because previous studies indicated that thromboxane release is implicated in vessel damage, we further examined the role of throm-boxane in PDT. Rats bearing chondrosarcoma were injected with 25 mg/kg Photofrin® (intravenously) 24 h before treatment. Light (135 J/cm ² , 630 nm) was delivered to thc tumor area after injection of one of the following inhibitors: (1) R68070: a thromboxane synthetase inhibitor; (2) SQ-29548: a thromboxane receptor antagonist; and (3) Flunarizine: an inhibitor of platelet shape change. Systemic thromboxane levels were determined. Vessel constriction and leakage were evaluated by intravital microscopy. Tumor response was assessed after treatment. Thromboxane levels were decreased more than 50% with SQ-29548 as compared to controls. Thromboxane levels in animals given R68070 and Flunarizine remained at baseline levels. SQ-29548 and R68070 reduced vessel constriction compared to controls, while Flunarizine totally prevented vessel constriction. R68070 and SQ-29548 inhibited vessel permeability compared to PDT controls; Flunarizine did not. Animals given these inhibitors showed markedly reduced tumor cure. These results indicate that the release of thromboxane is linked to the vascular response in PDT.     

Site-directed photochemical disruption of the actin cytoskeleton by actin-binding Rose Bengal-conjugates

The in situ light-induced, non-enzymatic digestion of cytoskeletal actin by a xanthene dye conjugated to heavy meromyosin, anti-actin antibodies and/or anti-myosin antibodies is reported. The dye Rose Bengal was conjugated to either anti-actin antibodies, anti-myosin antibodies or heavy meromyosin. Under our experimental conditions, visible light induced the non-enzymatic breakdown of cytoskeletal actin when mammalian tissue culture cells were probed either with Rose Bengal-conjugated anti-actin and/or anti-myosin antibodies. Similar results were obtained when tissue culture cells were probed with Rose Bengal-conjugated heavy meromyosin before irradiation with visible light. The in situ photochemical reaction depended on the presence of actin-binding Rose Bengal-conjugates.     

Capillary electrophoresis in aqueous-organic media. Ionic strength effects and limitations of the Hubbard-Onsager dielectric friction model

The mobilities of three aromatic sulfonates, ranging in charge from -1 to -3, were investigated by capillary electrophoresis using buffers containing 0 to 75% ethanol or 2-propanol. Absolute mobilities were determined by extrapolation of the effective mobilities to zero ionic strength according to the Pitts' equation. For all buffers studied, ions of higher charge experienced larger ionic strength effects. The resulting ionic strength-induced selectivity alterations were more dramatic when organic solvents were present in the media. Furthermore, for different organic modifier types and contents, the magnitude of the ionic strength effect was governed to a large extent by the 1/(eta epsilon 1/2) dependence in the electrophoretic effect of the Pitts' equation. Addition of ethanol or 2-propanol to the electrophoretic media resulted in changes in the absolute mobilities of the ions. These solvent-induced mobility changes are attributed to dielectric friction. As predicted by the Hubbard-Onsager model, dielectric friction increased with increasing organic content and with increasing analyte charge. As a result, dramatic changes in the relative absolute mobilities were observed, such as a reversal in migration order between sulfonates of -1 and -3 charge in 75% 2-propanol. Within the alcohols, the Hubbard-Onsager model was successful at predicting the relative mobility trends upon changing solvent. However, the relative trends observed between acetonitrile-water and alcohol-water media were not consistent with the model. This may be explained by the continuum nature of the model, whereby the different ion-solvent interactions characteristic to each solvent class are not taken into account.     

Electronic Structure of [Ta(5)(NH)(4)Cl(17)](6-): A Cluster with a Distorted Square Pyramidal Ta(5) Core

We report approximate molecular orbital calculations on the [Ta(5)(NH)(4)Cl(17)](6-) cluster synthesized by Simon and Meyer. The cluster is based on a "flattened" square pyramid of tantalum atoms, basal bridging imides, and terminal chlorides. This cluster was of interest to us due to the unusual presence of imide ligands, the distorted nature of the metal core, and the possible resemblance to B(5)H(9). Our calculations indicate that metal-metal bonding is limited to Ta(apical)-Ta(basal) bonding, with no significant bonding between the basal metal atoms. The imide ligands, which bridge the base of the pyramid, were found to have a significant amount of capping character. The metal-metal bonding orbitals have some unusual features due to the pyramid's distortion. Additionally, the flattened nature of the pyramid leads to an interesting energy ordering of the metal-metal bonding orbitals.     

Ditungsten Siloxide Hydrides, [(silox)(2)WH(n)()](2) (n = 1, 2; silox = (t)BuSiO), and Related Complexes

The addition of 4.0 equiv of Na(silox) to Na[W(2)Cl(7)(THF)(5)] afforded (silox)(2)ClW&tbd1;WCl(silox)(2) (1, 65%). Treatment of 1 with 2.0 equiv of MeMgBr in Et(2)O provided (silox)(2)MeW&tbd1;WMe(silox)(2) (2, 81%). In the presence of 1 atm of H(2), reduction of 1 with 2.0 equiv of Na/Hg in DME provided (silox)(2)HW&tbd1;WH(silox)(2) (3, 70%), characterized by a hydride resonance at delta 19.69 (J(WH) = 325 Hz, (1)H NMR). Exposure of 2 to 1 atm of H(2) yielded 3 and CH(4) via (silox)(2)HW&tbd1;WMe(silox)(2) (4); use of D(2) led to [(silox)(2)WD](2) (3-d(2)). Exposure of 3 to ethylene ( approximately 1 atm, 25 degrees C) in hexanes generated (silox)(2)EtW&tbd1;WEt(silox)(2) (5), but solutions of 5 reverted to 3 and free C(2)H(4) upon standing. NMR spectral data are consistent with a sterically locked, gauche, C(2) symmetry for 1-5. Thermolysis of 3 at 100 degrees C (4 h) resulted in partial conversion to (silox)(2)HW&tbd1;W(OSi(t)Bu(2)CMe(2)CH(2))(silox) (6a, approximately 60%) and free H(2), while extended thermolysis with degassing (5 d, 70 degrees C) produced a second cyclometalated rotational isomer, 6b (6a:6b approximately 3:1). When left at 25 degrees C (4 h) in sealed NMR tubes, 6 and free H(2) regenerated 3. Reduction of 1 with 2.0 equiv of Na/Hg in DME also afforded 6a (25%). When 3 was exposed to approximately 3 atm of H(2), equilibrium amounts of [(silox)(2)WH(2)](2) (7) were observed by (1)H NMR spectroscopy (3 + H(2) right harpoon over left harpoon 7; 25.9-88.7 degrees C, DeltaH = -9.6(4) kcal/mol, DeltaS = -21(2) eu). Benzene solutions of 3 and 1-3 atm of D(2) revealed incorporation of deuterium into the silox ligands, presumably via intermediate 6. In sealed tubes containing [(silox)(2)WCl](2) (1) and dihydrogen (1-3 atm), (1)H NMR spectral evidence for [(silox)(2)WCl](2)(&mgr;-H)(2) (8) was obtained, suggesting that formation of 3 from 1 proceeded via reduction of 8. Alternatively, 3 may be formed from direct reduction of 1 to give [(silox)(2)W](2) (9), followed by H(2) addition. Hydride chemical shifts for 7 are temperature dependent, varying from delta 1.39 (-70 degrees C, toluene-d(8)), to delta 3.68 (90 degrees C). (29)Si{(1)H} NMR spectra revealed a similar temperature dependence of the silox (delta 12.43, -60 degrees C, to delta 13.64, 45 degrees C) resonances. These effects may arise from thermal population of a low-lying, deltadelta, paramagnetic excited state of D(2)(d)() [(silox)(2)W](2)(&mgr;-H)(4) (DeltaE approximately 2.1 kcal/mol, chi(7a) approximately 0.03), an explanation favored over thermal equilibration with an energetically similar but structurally distinct isomer (e.g., [(silox)(2)WH(2)](2)(&mgr;-H)(2), DeltaG degrees approximately 0.69 kcal/mol, chi(7b) approximately 0.25) on the basis of spectral arguments. Extended Hückel and ab initio molecular orbital calculations on model complexes [(H(3)SiO)(2)W](2)(&mgr;-H)(4) (staggered bridged 7a', EHMO), [(H(3)SiO)(2)WH(2)](2) (all-terminal 7b', EHMO), [(H(3)SiO)(2)W](2) (9', EHMO), (HO)(4)W(2)(H(4)) (staggered-bridged 7", ab initio), and (HO)(4)W(2)(H(4)) (bent-terminal 7, ab initio) generally support the explanation of a thermally accessible excited state and assign 7 a geometry intermediate between the all-terminal and staggered-bridged forms.     

Development of a custom high-throughput preparative liquid chromatography/mass spectrometer platform for the preparative purification and analytical analysis of compound libraries

Solution-phase parallel synthesis has had a profound impact on the speed of compound synthesis delivering relatively pure compounds (>80%) in short order. However, to develop structure activity relationships (SAR) for a compound series, each library member should preferably be >95% pure. Historically, achieving and quantifying such high-purity criteria for each library member proved to be the slow step for most lead discovery groups. To address this issue, significant modifications have been made to a commercial Agilent preparative LC/MS system to allow for the general mass-guided purification of diverse compound libraries. The custom modifications include (1) the "DMSO slug" approach for the purification of samples with poor solubility; (2) an active splitter to reduce system back-pressure, reduce the delay volume, and allow for a variable split ratio; (3) a sample loading pump for the quick purification of large, dilute samples; (4) a preparative column-selection valve to quickly change column selectivity or sample loading; and (5) an analytical injector with a separate flow path for crude reaction or fraction analyses.     

A copper-catalyzed C-N bond formation involving sp-hybridized carbons. A direct entry to chiral ynamides via N-alkynylation of amides

A copper-catalyzed new C-N bond formation involving a sp-hybridized carbon is described here leading to a facile entry for syntheses of chiral ynamides. This direct N-alkynylation of amides should have a significant impact on the future development of synthetic methodologies employing ynamides.     

Synthesis of the methanesulfonates of α-(4-chlorophenyl)-α-[1-(2-chlorophenyl)emenyl]-1H-1,2,4-triazole-1-ethanol and α-[1-(2-chlorophenyl)ethenyl]-α-(2,4-difluorophenyl)-1H-1,2,4-triazole-1-ethanol,alpha styryl carbinol antifungal agents

The methanesulfonates of (α-(4-chlorophenyl)-α-[1-(2-chlorophenyl)ethenyl]-1H-1,2,4-triazole-1-ethanol and α-[1-(2-chlorophenyl)ethenyl]-α-(2,4-difluorophenyl)-1H-1,2,4-triazole-1-ethanol ( 1a, b ) are orally effective α-styryl carbinol derivatives developed for the treatment and prevention of systemic fungal infections. Practical new processes amenable for the large-scale production of these compounds are described. Of note is the selection of dichlorostyrene as a convenient precursor of the styryl portion, modification of a sensitive Grignard addition into a realistic preparative reaction and the use of 1,2,4-triazole simultaneously as a base transfer agent and nucleophile.     

Photolithographic Patterning and Doping of Silica Xerogel Films

This study shows that conventional photolithography can be applied for patterning native or organic dye-doped silica films (0.5 m thick) obtained via a base-catalyzed sol-gel process. Photoresist was spin-coated onto high optical quality xerogel films, soft-baked, exposed to UV irradiation through a photomask, and developed with a commercial photoresist developing solution. Etching away of the photoresist-unprotected areas of the silica films was carried out with a dilute HF solution, while the remaining unexposed photoresist was removed with acetone. Interdigitated array patterns with features as small as 0.5 mm show a smooth surface and extremely sharp interfaces. Densification of the films at 550°C for 2 h decreases the film thickness by 11%, increases the refractive index from 1.420 to 1.456, and allows for well-defined patterning down to length scales of 10 m. Since the densification conditions are incompatible with organic dopants, it is demonstrated that sol-gel films can be doped after pattering (post-doping) by adsorption of cationic dyes from solution. Scanning electron microscopy reveals that the microstructure of patterned sol-gel films is similar to that of bulk monoliths, indicating that the photolithographic procedure is not harmful to the film quality. All patterned films demonstrate highly regular light diffraction patterns.     

Direct observation of insertion events at rac-(C2H4(1-indenyl)2)Zr(MeB(C6F5)3)-polymeryl intermediates: distinction between continuous and intermittent propagation modes

The propagating species for 1-hexene, propene, and ethene polymerization as catalyzed by [rac-(C2H4(1-indenyl)2)Zr(CH3)][CH3B(C6F5)3] has been intercepted at T < -40 degrees C and characterized by NMR methods. Observation of the propagating species permits direct monitoring of initiation, propagation, and termination processes by NMR. Detailed examination of alkene incorporation into Zr-polymeryl species using 13C-labeled 1-alkenes supports a continuous insertion mechanism whereby the anion re-coordinates after each alkene insertion.