A new method for atmospheric nitrogen dioxide measurements using the combination of a stripping coil and fluorescence detection.

A new stripping coil for the collection of nitrogen dioxide (NO2) has been developed to increase its versatility and efficiency. Nitrogen dioxide measurements based on quantitative collection through a reaction coil into an alkaline solution has been examined. Nitrogen dioxide is collected in a 0.1 N NaOH solution. This collection system has an efficiency of nearly 100%. The absorbed nitrogen dioxide has been measured by fluorescence detection with sub-ppbv detection limits. The excitation wavelength at 360 nm and the produced emission wavelength at 405 nm were suitable for nitrite ion measurements.     

Identification and determination of sulphamethazine and N4-acetylsulphamethazine in meat by high-performance liquid chromatography with photodiode-array detection

A simple and selective method for the determination of sulphamethazine (SMT) and its metabolite, N4-acetylsulphamethazine (N4-AcSMT), in meat by high-performance liquid chromatography (HPLC) with photodiode-array detection was developed. The drugs were extracted from meat with 0.2% metaphosphoric acid-methanol (6:4), followed by a Bond-Elut C18 clean-up procedure. The HPLC separation was carried out on a Supersphere RP-18e column (125 X 4.0 mm I.D.) using 0.05 M sodium dihydrogenphosphate (pH 4.5)-acetonitrile (8:2) as the mobile phase at a flow-rate of 0.5 ml/min, and monitored with a photodiode-array detector. The recoveries of SMT and N4-AcSMT from meat fortified at 0.5 micrograms/g were 90.1-93.3 and 93.0-94.4%, respectively, with coefficients of variation of 1.9-3.2 and 1.5-2.7%. The limits of detection were 0.02 micrograms/g for each drug. SMT was found in ten samples of imported meat (12.5%) at levels ranging from 0.05 to 1.05 micrograms/g.     

A comparison of supercritical carbon dioxide and organic solvents for the intercalation of 4-phenylazoaniline into a pillared clay mineral

The intercalation of 4-phenylazoaniline (PAA) in supercritical carbon dioxide (SC-CO(2)) into montmorillonite (TMA-Mnt) pillared with tetramethylammonium ions at 313 K and 15 MPa was investigated. The adsorption rate and equilibrium PAA uptake were compared with those in n-hexane, CCl(4) and benzene solutions at 313 K. The XRD and N(2) adsorption/desorption analyses showed that TMA-Mnt after adsorption of PAA in SC-CO(2) had the same pore structure as after adsorption of PAA in normal solvents. SC-CO(2) was found to be a good medium for PAA adsorption owing to its having a relatively high adsorption rate and the highest adsorptivity at the same PAA concentration. The properties of PAA adsorption on TMA-Mnt could be well elucidated by the difference in solubility parameters between liquid and solid phases.     

Spectrophotometric determination of boron with an azomethine H derivative

Summary An azomethine H derivative, 1-(2,4-dihydroxybenzylidene-amino)-8-hydroxynaphthalene-3,6-disulphonic acid (azomethine HR) was examined and proposed as a spectrophotometric reagent for boron, as compared with azomethine H. Azomethine HR reacts with boron in aqueous solution (pH 7.5) to form a yellow complex having an absorption maximum at 425 nm. The sensitivity is 3.5-fold greater than with azomethine H when the same reagent concentration is applied. Basic conditions for the determination of boron have been worked out. The method is applicable to sea and hot spring waters. The standard deviation is ±2.1%.

---

Spektralphotometrische Borbestimmung mit einem Azomethin H-Derivat

     

High-performance liquid chromatography of histamine and 1-methylhistamine with on-column fluorescence derivatization.

An on-column fluorometric derivatization method was developed for the determination of histamine and 1-methylhistamine (HMs) by high-performance liquid chromatography. The system for the derivatization consisted only of a commercially available single-plunger pump and a reversed-phase C18 column supported on synthetic polymer with a mobile phase of acetonitrile and alkaline borate buffer solution containing o-phthalaldehyde as a derivatization reagent. It required no additional reaction system as for a post-column derivatization method. Injected HMs might be derivatized to a fluorophore on the inlet site of the high-performance liquid chromatographic column, followed by chromatography on the same column. Optimization of the on-column reaction conditions resulted in a simple and sensitive analytical method for the determination of HMs with excellent reproducibility and linearity of 0.05-5 micrograms/ml of both HMs. Application of this method to the determination of HMs in food samples resulted in a limit of quantification of 0.05 mg/100 g and in a greater than 95% overall mean recovery at a fortification of 0.1 mg/g of both HMs. This method was furthermore applicable to the determination of histamine released from rat peritoneal mast cells.     

Adsorption of phosphate from seawater on calcined MgMn-layered double hydroxides

Adsorptive properties of MgMn-3-300 (MgMn-type layered double hydroxide with Mg/Mn mole ratio of 3, calcined at 300 degrees C) for phosphate were investigated in phosphate-enriched seawater with a concentration of 0.30 mg-P/dm3. It showed the highest phosphate uptake from the seawater among the inorganic adsorbents studied (hydrotalcite, calcined hydrotalcite, activated magnesia, hydrous aluminum oxide, manganese oxide (delta-MnO2)). The phosphate uptake by MgMn-3-300 reached 7.3 mg-P/g at an adsorbent/solution ratio of 0.05 g/2 dm3. The analyses of the uptakes of other constituents (Na+, K+, Ca(+, Cl-, and SO(2-)4) of seawater showed that the adsorbent had a markedly high selectivity for the adsorption of phosphate ions. Effects of initial phosphate concentration, temperature, pH, and salinity on phosphate uptake were investigated in detail by a batch method. The phosphate uptake increased slightly with an increase in the adsorption temperature. The adsorption isotherm followed Freundlich's equation with constants of logK(F)=1.25 and 1/n=0.65, indicating that it could effectively remove phosphate even from a solution of markedly low phosphate concentration as well as with large numbers of coexisting ions. The pH dependence showed a maximum phosphate uptake around pH 8.5. The pH dependence curve suggested that selective phosphate adsorption progresses mainly by the ion exchange of HPO(2-)4. The study on the effect of salinity suggested the presence of two kinds of adsorption sites in the adsorbent: one nonspecific site with weak interaction and one specific site with strong interaction. The effective desorption of phosphate could be achieved using a mixed solution of 5 M NaCl + 0.1 M NaOH (1 M = 1 mol/dm3), with negligible dissolution of adsorbent. The adsorbent had high chemical stability against the adsorption/desorption cycle; it kept a good phosphate uptake even after the repetition of the seventh cycle.     

Synthesis of o-LiMnO2 by Microwave Irradiation and StudyIts Heat Treatment and Lithium Exchange

Microwave irradiation of a suspension of γ-MnOOH in a 4 mol dm⁻³ LiOH solution brought about a rapid formation of semicrystalline orthorhombic LiMnO₂ (o-LiMnO₂) within 30 min at 120°C. Cubic Li_1.6Mn_1.6O₄ was obtained by heating o-LiMnO₂ at 400°C; lithium could be topotactically extracted from Li_1.6Mn_1.6O₄ with acid to form cubic H_1.6Mn_1.6O₄.     

Evidence of conformational equilibrium of 1-ethyl-3-methylimidazolium in its ionic liquid salts: Raman spectroscopic study and quantum chemical calculations

Raman spectra of liquid 1-ethyl-3-methylimidazolium (EMI+) salts, EMI(+)BF4-, EMI(+)PF6-, EMI(+)CF3SO3-, and EMI(+)N(CF3SO2)2-, were measured over the frequency range 200-1600 cm(-1). In the range 200-500 cm(-1), we found five bands originating from the EMI+ ion at 241, 297, 387, 430, and 448 cm(-1). However, the 448 cm(-1) band could hardly be reproduced by theoretical calculations in terms of a given EMI+ conformer, implying that the band originates from another conformer. This is expected because the EMI+ involves an ethyl group bound to the N atom of the imidazolium ring, and the ethyl group can rotate along the C-N bond to yield conformers. The torsion energy for the rotation was then theoretically calculated. Two local minima with an energy difference of ca. 2 kJ mol(-1) were found, suggesting that two conformers are present in equilibrium. Full geometry optimizations followed by normal frequency analyses indicate that the two conformers are those with planar and nonplanar ethyl groups against the imidazolium ring plane, and the nonplanar conformer is favorable. It elucidates that bands at 241, 297, 387, and 430 cm(-1) mainly originate from the nonplanar conformer, whereas the 448 cm(-1) band does originate from the planar conformer. Indeed, the enthalpy for conformational change from nonplanar to planar EMI+ experimentally obtained by analyzing band intensities of the conformers at varying temperatures is practically the same as that evaluated by theoretical calculations. We thus conclude that the EMI+ ion exists as either a nonplanar or planar conformer in equilibrium in its liquid salts.     

Preparation of porous clay minerals with organic-inorganic hybrid pillars using solvent-extraction route

A microporous clay mineral with organic-inorganic hybrid pillars was synthesized using a hydrochloric acid (HCl)/ethanol extraction method after intercalation of tetraethoxysilane (TEOS) or TEOS/methyltriethoxysilane (MTS) into the cetyltrimetylammonium ion (CTA)-exchanged vermiculite. The products retained their layered structure, due to the formation of stable pillars by the polymerization of hydrolyzed TEOS and MTS during the HCl/ethanol treatment. The BET surface areas, which increased to above 500 m2g(-1) with an increase in the HCl concentration up to 0.4 moldm(-3), are nearly equal to that of the calcined product obtained by the conventional method. However, the pore sizes of HCl/ethanol-treated materials were narrower than those of the calcined product, owing to the formation of the polysiloxane networks in the gallery. A water adsorption study showed that the product treated with a TEOS/MTS mixture had a hydrophobic surface as a result of the successful incorporation of methyl groups at the surface of the pillars. This novel method is advantageous for the synthesis of organophilic pillared clays with different kinds of organic materials in the interlayers.