Study on crystalline properties of Er-Si-O compounds in relation to Er-related 1.54 μm photoluminescence and electrical properties

Er-Si-O crystalline compounds, which exhibit superlattice structures and sharp and strong Er-related 1.54 μm photoluminescence (PL) spectra at room temperature have been formed by self-assembling growth mechanism. Oxidation of the starting materials which have Si and Er at an atomic ratio of 2:1 are prepared and then oxidation and succeeding high-temperature annealing in Ar above 1250 °C cause a self-assembled superlattice-structured Er-Si-O crystalline compounds. The control of the ratio of Si and Er, as well as the following oxidation and annealing processes, is found to be sensitive to the crystalline properties, PL spectra and electrical properties. In this study, Er-Si-O crystalline thin films are formed on Si substrates by sol-gel and MOMBE methods, and their crystalline properties such as crystalline orientation and concentration ratio of Er, Si and O are investigated. Crystalline Er-Si-O films of high orientation are successfully grown on Si(1 0 0) and its inclined surface. The PL and excitation spectra, fluorescence decay and the electrical properties are found to be strongly related to the crystalline properties. Excess O causes a broader 1.54 μm PL spectra, slower fluorescence decay, lower carrier-mediated excitation and higher resistivity. A precise control of O is found to be necessary to grow superlattice-structured Er-Si-O compounds, which are semiconducting and are excitable via carrier-mediated excitation mechanism.     

Light Diffraction of Aligned Polymer Fibers Periodically Dispersed by Phase Separation of Liquid Crystal and Polymer

We have confirmed light diffraction of aligned polymer fibers obtained by a phase separation of an anisotropic-phase solution of liquid crystal and polymer. He—Ne laser light passing through the polymer fibers was scattered in the axis vertical to the fibers, and had two peaks of light intensity symmetrical to the center of the transmitting laser spot. The two peaks were found to be caused by light diffraction due to the periodic polymer-fiber dispersion because the peaks corresponded to values calculated by intervals between the fibers. The periodical fiber networks are considered to be formed by anisotropic spinodal decomposition. This effect can be used to measure the dispersion order of the polymer fibers. © 2004 The Optical Society of Japan     

Large-volume injection electrothermal AAS combined with tungsten-treated pyrolytic graphite furnace: determination of cadmium in tap, snow and river water samples with phosphate modifier.

A large-volume (100 microl) injection-ETAAS with W-treated PG furnace combined with a phosphate modifier was applied to the determination of unpolluted levels of Cd in tap, snow and river-water samples. The limit of detection of 1.1 ng l(-1) was observed for a 4 w/v% NH4H2PO4 modifer. Matrix interference studies were tested for major ion species well found in fresh water. The direct determination of Cd in certified river water (12 +/- 2 ng l(-1)) was carried out and the observed value was in agreement with the certified one. The good recoveries of Cd added to real environmental water samples were also observed. This method was applied to the determination of Cd in unpolluted environmental water samples.     

Cerasome as an Organic-Inorganic Vesicular Nanohybrid: Characterization of Cerasome-Forming Lipids having a Single or a Dual Trialkoxysilyl Head

Morphological characterization of the organic-inorganic vesicular nanohybrids, Cerasomes, was performed in aqueous media from two aspects. Firstly, a novel Cerasome-forming lipid having two triethoxysilyl groups in the head moiety was synthesized and the physical property of the Cerasome was investigated. While the morphological stability of the Cerasomes, as evaluated from the vesicular collapse behavior against a micelle-forming nonionic surfactant, Triton-X 100, was extremely higher than that of the conventional phospholipid liposome, the stabilities were comparable to each other for the Cerasomes derived from the dual- and single-head lipids. On the other hand, the surface property of the Cerasome formed with the dual-head lipid more closely resembled the colloidal silica particles rather than that derived from the single-head lipid, as suggested by zeta-potential measurements. Secondly, the effect of the media pH on the morphological stability of the Cerasome formed with the single-head lipid was evaluated and appeared as a time difference in obtaining the morphological stability of the Cerasome. These morphological characteristics of the Cerasomes could be mainly owing to the development of the siloxane network on the vesicular surface.     

Non-destructive rapid analysis of brominated flame retardants in electrical and electronic equipment using Raman spectroscopy.

Using Raman spectroscopy without any preparation, we analyzed the brominated flame retardant, polybromodiphenyl ethers (PBDEs), which has been prohibited by the European Union. The typical Raman bands of PBDEs, which are clearly different from those of other brominated flame retardants, are from 100 to 300 cm(-1). In our analysis, the detection limit was about 100 ppm, and the analysis took about 1 min, whereas the usual method of solvent extraction using gas chromatography/mass spectroscopy takes 50 h.     

Structural characterization of polypyrrole in the solid state by high resolution 15N NMR spectroscopy [II]

The solid-state ¹⁵N CP/MAS NMR spectra and ¹⁵N spin-lattice relaxation times (T₁) of doped and dedoped ¹⁵N-labeled polypyrroles prepared by electrochemical polymerization, have been measured by means of high-resolution solid-state ¹⁵N NMR. The ¹⁵N signal of polypyrrole consists of four peaks decomposed by line shape analysis. The four peaks obtained have been assigned to the various structures of polypyrrole. Further, the half-width of the ¹⁵N NMR spectra of polypyrroles is discussed as related to the electrical conductivity. © 1995 John Wiley & Sons, Inc.     

Magneto-Optical Measurement of Organic Conductor Using Rotational Cavity System

We have developed a new magneto-optical measurement system using a rotational cavity system equipped with a millimeter vector network analyzer and a 14 T solenoid type super conducting magnet. The measurement can be performed in the transmission configuration down to 1.6 K. The results of the precise angular dependence measurement of quasi-one-dimensional organic conductor (DMET)₂I₃ using the new system are shown, and its Fermi surface will be discussed in connection with the previous reports.     

Structure and optical properties of lead iodide based two-dimensional perovskite compounds containing fluorophenethylamines

Phenethylammonium-based perovskites, which can be regarded as a semiconductor/insulator multiple quantum well consisting of lead halide semiconductor layers sandwiched between phenethylammonium insulator layers were prepared. To investigate the effects of the electronic state and the orientation of organic insulator layers on the optical properties of layered perovskites, fluorine substituted analogues were also prepared. The structure and optical properties were investigated by the XRD, UV–Vis absorption, and fluorescence measurements. The exciton absorption peak was shifted by the substitution of fluorine atoms in organic ammonium compounds. It became clear that the optical properties of two-dimensional perovskite compounds were controlled by the substitution of fluorine atoms.     

Effect of d-limonene on the amounts of ethanol and indomethacin penetrated from aqueous gel ointments to rat skin.

The amounts of d-limonene, ethanol and indomethacin (IMC) which were transferred from aqueous gel ointments to the skin were determined in rats. The concentration of IMC in the skin correlated well with the plasma concentration of IMC percutaneously absorbed from the gel ointment. The increase of d-limonene concentration in the gel ointments was directly proportional to the accumulation of ethanol in the skin. The amount of ethanol in the skin was closely associated with the percutaneous absorption of IMC. As a possible mechanism for enhancement action of d-limonene and ethanol, it was considered that, at first, d-limonene penetrates into the skin under coexistence with ethanol and may change the barrier structure of the stratum corneum. The transfer of ethanol to the skin is thereby enhanced under the coexistence of d-limonene in the skin. Thus, the permeation of IMC can be promoted due to its affinity with ethanol.