Developing the Low-Temperature Oxidation Mechanism of Cyclopentane: An Experimental and Theoretical Study

At present, the reactivity of cyclic alkanes is estimated by comparison with acyclic hydrocarbons. Due to the difference in the structure of cycloalkanes and acycloalkanes, the thermodynamic data obtained by analogy are not applicable. In this study, a molecular beam sampling vacuum ultraviolet photoionization time-of-flight mass spectrometer (MB-VUV-PI-TOFMS) was applied to study the low-temperature oxidation of cyclopentane (CPT) at a total pressure range from 1–3 atm and low-temperature range between 500 and 800 K. Low-temperature reaction products including cyclic olefins, cyclic ethers, and highly oxygenated intermediates (e. g., ketohydroperoxide KHP, keto-dihydroperoxide KDHP, olefinic hydroperoxides OHP and ketone structure products) were observed. Further investigation of the oxidation of CPT – electronic structure calculations – were carried out at the UCCSD(T)-F12a/aug-cc-pVDZ//B3LYP/6-31+ G(d,p) level to explore the reactivity of O₂ molecules adding sequentially to cyclopentyl radicals. Experimental and theoretical observations showed that the dominant product channel in the reaction of CPT radicals with O₂ is HO₂ elimination yielding cyclopentene. The pathways of second and third O₂ addition – the dissociation of hydroperoxide – were further confirmed. The results of this study will develop the low-temperature oxidation mechanism of CPT, which can be used for future research on accurately simulating the combustion process of CPT.     

坚硬顶板爆破切顶在沿空留巷中的应用研究

当煤层上方为坚硬顶板时,在工作面回采期间容易出现大面积悬顶,导致巷旁充填体出现大变形破坏,极大威胁采煤安全.为解决这一问题,以某矿1205工作面沿空留巷为工程背景,分析了爆炸围岩裂隙范围和坚硬顶板破断特征,建立了切顶卸压围岩结构力学模型,研究表明,相邻炮孔爆炸后,炮孔间裂隙互相贯穿,降低了顶板强度,同时当切顶角为15°时,巷道稳定性较好.工程实践结果表明:采用爆破切顶技术后,顶板下沉量减小了62.3%,较好地保证了围岩稳定性.     

基于XPS对硫铁矿去除SeO2-3的机理研究

硒是动植物及人体生长必需的十五种微量元素之一，具有清除体内自由基、抗氧化、增强免疫力等功能，但其安全剂量的范围却很窄。利用扫描电子显微镜（SEM）和X射线衍射仪（XRD）对湿法球磨制备的硫铁矿形貌进行了表征。SEM观测发现加乙醇助磨后的硫铁矿为粒径大小较均匀的球形颗粒团聚体，粒径范围在17～200 nm之间，平均粒径138 nm。XRD衍射图谱中的特征峰与FeS₂衍射图谱中各峰位置基本一致，因此判定硫铁矿中主要化学组分为FeS₂，且图谱中基本没有杂峰，表明制备过程中并未混入杂质，样品纯度较高。实验结果表明，该法制备的硫铁矿具有颗粒粒径小、比表面积大、反应活性高等优点。研究中利用X射线光电子能谱仪（XPS）对硫铁矿去除水体中SeO2-₃的机理进行了研究。研究结果表明, （1）在较为广泛的实验pH范围（pH 2.2～11.5），硫铁矿均能有效去除水体中SeO2-₃，去除效率（除pH值7.8以外）均达到90%以上；（2）硫铁矿与SeO2-₃发生反应后，其主要组成元素的XPS特征峰结合能有所减小，表明硫铁矿表面发生了一定化学变化；（3）酸碱环境下硫铁矿去除SeO2-₃的机理不完全相同，酸性环境下，硫铁矿对SeO2-₃的去除是单纯的氧化还原过程，即硫铁矿中被酸活化的S2-₂将SeO2-₃还原为单质Se(0)，并且酸性越强，SeO2-₃去除效果越好；碱性环境下，SeO2-₃的去除过程中氧化还原与络合反应并存，硫铁矿表面有络合态Fe(OH)SeO₃和单质Se(0)两种存在形态，且碱性越强，络合态Fe(OH)SeO₃含量越高。以上研究结果为硫铁矿去除固定水体和土壤中以SeO2-₃为代表的可变价金属阴离子提供重要理论依据和应用基础。     

Ultrahigh Loading Copper Single Atom Catalyst for Palladium-free Wacker Oxidation

Wacker oxidation is an industry-adopted process to transform olefins into value-added epoxides and carbonyls. However, traditional Wacker oxidation involves the use of homogeneous palladium and copper catalysts for the olefin addition and reductive elimination. Here, we demonstrated an ultrahigh loading Cu single atom catalyst(14% Cu, mass fraction) for the palladium-free Wacker oxidation of 4-vinylanisole into the corresponding ketone with N-methylhydroxylamine hydrochloride as an additive under mild conditions. Mechanistic studies by ¹⁸O and deuterium isotope labelling revealed a hydrogen shift mechanism in this palladium-free process using N-methylhydroxylamine hydrochloride as the oxygen source. The reaction scope can be further extended to Kucherov oxidation. Our study paves the way to replace noble metal catalysts in the traditional homogeneous processes with single atom catalysts.     

A New Quassinoid from Brucea javanica

Chemistry of Natural Compounds - A new quassinoid, dehydrobruceantinol B (1), was isolated from the seeds of Brucea javanica, together with two known compounds, bruceantinol (2) and bruceine A (3)....     

利用沙漠沙低温合成高长径比莫来石晶须

利用沙漠沙独特的化学组成特性和矿物特性,将沙漠沙荒料作为硅源,工业Al(OH)3作为铝源制备莫来石晶须.改变硅源/铝源配比和合成温度,结合XRD、SEM、TEM研究莫来石生长环境和自由生长形态的变化.研究结果表明:当沙漠沙与Al(OH)3的质量比为35/65时,在1200℃的低温下就能获得平均值>60的高长径比莫来石晶须;随着煅烧温度的升高,莫来石晶须长径比不断增大,当温度升至1300℃,平均长径比>94.随着合成温度的升高,莫来石的形成经过了一次莫来石和二次莫来石化两个阶段;若配方中Al2 O3处于过饱和状态,样品中刚玉相会随着煅烧温度的升高出现先增多后降低的变化现象.     

Chemical versus Electrochemical Synthesis of Carbon Nano‐onion/Polypyrrole Composites for Supercapacitor Electrodes

The development of high‐surface‐area carbon electrodes with a defined pore size distribution and the incorporation of pseudo‐active materials to optimize the overall capacitance and conductivity without destroying the stability are at present important research areas. Composite electrodes of carbon nano‐onions (CNOs) and polypyrrole (Ppy) were fabricated to improve the specific capacitance of a supercapacitor. The carbon nanostructures were uniformly coated with Ppy by chemical polymerization or by electrochemical potentiostatic deposition to form homogenous composites or bilayers. The materials were characterized by transmission‐ and scanning electron microscopy, differential thermogravimetric analyses, FTIR spectroscopy, piezoelectric microgravimetry, and cyclic voltammetry. The composites show higher mechanical and electrochemical stabilities, with high specific capacitances of up to about 800 F g^?1 for the CNOs/SDS/Ppy composites (chemical synthesis) and about 1300 F g^?1 for the CNOs/Ppy bilayer (electrochemical deposition).     

Vinylic MIDA Boronates: New Building Blocks for the Synthesis of Aza‐Heterocycles

A two‐step synthesis of structurally diverse pyrrole‐containing bicyclic systems is reported. ortho‐Nitro‐haloarenes coupled with vinylic N‐methyliminodiacetic acid (MIDA) boronates generate ortho‐vinyl‐nitroarenes, which undergo a “metal‐free” nitrene insertion, resulting in a new pyrrole ring. This novel synthetic approach has a wide substrate tolerance and it is applicable in the preparation of more complex “drug‐like” molecules. Interestingly, an ortho‐nitro‐allylarene derivative furnished a cyclic β‐aminophosphonate motif.