Stability criteria for positive linear discrete-time systems

Positivity - We prove new characterisations of exponential stability for positive linear discrete-time systems in ordered Banach spaces, in terms of small-gain conditions. Such conditions have...     

Bei der Zuckerbestimmung

Ohne Zusammenfassung     

Negative luminescence from mid-wave infrared HgCdTe diode arrays

A self-referencing, optical modulation technique was used to measure the negative luminescence efficiencies of an array of mid-wave infrared HgCdTe photodiodes with cutoff wavelength 4.6 μm as a function of sample temperature. The internal efficiency at a wavelength of 4 μm was 93% at 295 K, and nearly independent of temperature in the 240–300 K range. This corresponds to an apparent temperature reduction >50 K at room temperature and >30 K at 240 K. Moreover, the reverse-bias saturation current density was only 0.13 A/cm². The measured transmission and emission spectra were simulated using empirical HgCdTe absorption formulas from the literature.     

Thin film synthesis and the influence of irradiation-induced defects on the superconductivity of La1.8Sr0.2CuO4

Thin superconducting films of La_1.8Sr_0.2CuO₄ have been prepared by magnetron sputter deposition and subsequent temperature treatment. The composition of the films has been determined by Rutherford backscattering and the structure by thin film X-ray diffraction. The onset of superconductivity was about 32 K and the midpoint near 28 K. Defect production in the films by He ion bombardment revealed a drasticT _c reduction with a sensitivity similar to that observed in the Chevrel phases. Oxygen implantation and subsequent annealing led to an enhancement of theT _c onset.     

Influence of organic modifiers on morphology and crystallization of poly(ϵ‐caprolactone)/synthetic clay intercalated nanocomposites

ε‐caprolactone was polymerized in the presence of neat montmorillonite or organomontmorillonites to obtain a variety of poly(ε‐caprolactone) (PCL)‐based systems loaded with 10 wt % of the silicates. The materials were thoroughly investigated by different X‐ray scattering techniques to determine factors affecting structure of the systems. For one of the nanocomposites it was found that varying the temperature in the range corresponding to crystallization of PCL causes reversible changes in the interlayer distance of the organoclay. Extensive experimental and literature studies on this phenomenon provided clues indicating that this effect might be a result of two‐dimensional ordering of PCL chains inside the galleries of the silicate. Small angle X‐ray scattering and wide angle X‐ray scattering investigation of filaments oriented above melting point of PCL revealed that polymer lamellae were oriented perpendicularly to particles of unmodified silicate, while in PCL/organoclay systems they were found parallel to clay tactoids. Calorimetric and microscopic studies shown that clay particles are effective nucleating agents. In the nanocomposites, PCL crystallized 20‐fold faster than in the neat polymer. The crystallization rate in nanocomposites was also significantly higher than in microcomposite. Further research provided an insight how the presence of the filler affects crystalline fraction and spherulitic structure of the polymer matrix in the investigated systems. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2350–2367, 2007     

Photoreactions of benzonitrile with cyclic enol ethers

Upon irradiation, cyclic enol ethers such as 1-methoxy-cyclopentene (4) mainly add across the cyano group of benzonitrile (1), under formation of 2-azabutadienes of an imidoester type. This is in agreement with the so-called Δ G-correlation which was reported earlier (ref. 5 and 6). 4-Phenyloxazole (9) is formed from 1 and 1,3-dioxole (5) probably by a similar photochemical process followed by electrocyclic ring opening and hydrolysis. The low yield of the latter photoreaction and the almost exergonic electron transfer between 5 and 1 may point to back electron transfer as the main energy wasting process. From 1 and 2,3-dihydrido-furan (2) only the ortho cycloadduct 6 has been isolated in low yields.