Interfacial adsorption state of protonated lipophilic porphyrins in a liquid-liquid system by using reflection spectrometry.

Analysis by reflection spectrometry was performed to clarify the interfacial adsorption of protonated lipophilic tetraphenylporphyrin derivatives in a dodecane-aqueous sulfuric acid system, and to confirm the utility of partial reflection spectroscopy. Interfacial adsorption was not observed for porphyrins substituted at the 2,6 positions of meso-phenyl groups, suggesting that the substituents prevent porphyrins from forming aggregates by steric hindrance. Polymorphous J-aggregates of acid dications were produced by tetra-p-tolylporphyrin with a saturated interfacial molecular density of 1.0 x 10(-10) mol cm(-2), which could yield 48 degrees as a mean tilting angle of the pyrrole ring plane from the interface normal. Partial-reflection spectrometry can provide sensitive detection and molecular orientation analysis of interfacial adsorbates.     

Hückel and Möbius cyclic conjugated molecules

Generalized graphs represent Hückel-type and Möbius-type polycyclic conjugated systems. We show that the number of generalized graphs with different spectra for a given parent graph is not larger than 2 ^N(R) and is equal to 2 ^N(R) if no two rings are equivalent,N(R) being the number of rings (fundamental circuits) in the parent graph. We demonstrate that the rule for the stability of generalized graphs, proved in a previuos paper, and the information on the relative magnitudes of the effects of individual circuits enable one to predict the stabilities of generalized graphs without performing numerical calculations.     

Argon sorption and partial molar volume in poly(ethyl methacrylate) above and below the glass transition temperature

Sorption and dilation isotherms for argon in poly(ethyl methacrylate) (PEMA) are reported for pressures up to 50 atm over the temperature range 5–85°C. At temperatures below the glass transition (T_g=61°C), sorption isotherms are well described by the dual-mode sorption model; and isotherms above T_g follow Henry's law. However, isotherms for dilation due to sorption are linear in pressure at all temperatures over the range investigated. Partial molar volumes of Ar in PEMA are obtained from these isotherms. The volumes are approximately constant above T_g (about 40 cm³/mol), whereas the volumes below T_g are smaller and dependent on both temperature and concentration (19–26 cm³/mol). By analyzing the experimental data according to the dual-mode sorption and dilation model, the volume occupied by a dissolved Ar molecule and the mean size of microvoid in the glass are estimated to be 67 129 ų, respectively. The cohesive energy density of the polymer is also estimated as 61 cal/cm³ from the temperature dependence of the dual-mode parameters.     

Major-to-ultratrace elements in bone-marrow fluid as determined by ICP-AES and ICP-MS.

The major-to-ultratrace elements in human bone-marrow fluid were determined by ICP-AES (inductively coupled plasma atomic emission spectrometry), and ICP-MS (inductively coupled plasma mass spectrometry). The bone-marrow fluid sample was centrifuged prior to acid digestion to exclude the bone piece from bone marrow, and then digested with nitric acid. As a result, 20 elements could be determined over the concentration range from 1610 microg g(-1) for Na to 0.00043 microg g(-1) for W. It was found that Fe, Zn and Sb were enriched by ca. 264-, 7- and 15-fold, respectively, in bone-marrow fluid, compared to those in human blood serum. Alkali metals (K, Rb, Cs), except for Na, were also significantly enriched in bone-marrow fluid. Furthermore, the concentrations of various elements, such as Fe, P, Al, Zn, Cu, Se, Zr, Sn, Ag and W, were significantly higher than those in open seawater.     

Viscoelasticity and birefringence of polyisoprene

The complex Young's modulus, E^*(ω), and the complex strain-optical coefficient, O^*(ω), which is the ratio of the birefringence to the strain, were measured for polyisoprene (PIP) over a frequency range of 1 ～ 130 Hz and a temperature range of 22 ～ ?100°C. The imaginary part of O^*, O″, was positive at low frequencies and negative at high frequencies. The real part, O′, was always positive and showed a maximum. The complicated behavior of O^* could be understood by the assumption that E^* = E_R^* + E_G^* and O^* = C_RE_R^* + C_GE_G^*, where E_R^* and E_G^* were complex quantities and C_R and C_G were constants. The C_R value, equal to the ordinary stress-optical coefficient measured in the rubbery plateau zone, was 2.0 × 10^?9 Pa^?1. The C_G value, defined as the ratio O″/E″ in the glassy zone, was ?1.1 × 10^?11 Pa^?1. The E_G^*, which was the major component of E^* in the glassy zone, showed almost the same frequency dependence as that of polystyrene and polycarbonate. The E_R^*, which was dominant in the rubbery zone, was described well by the bead-spring theory. The temperature dependence of the E_G^* was stronger than that of the E_R^*. This difference caused the breakdown of the thermorheological simplicity for E^* and O^* around the glass-to-rubber transition zone. © 1995 John Wiley & Sons, Inc.     

Compact,wide aperture X-ray preionized XeCl laser with high specific optical power

An X-ray preionized, discharge-pumped XeCl laser with a variable beam cross-section of up to 6×6 cm² is described. It uses flat electrodes and the beam width is determined by X-ray collimation. Its operation characteristics concerning reduced electric field strength (E/p) and X-ray dose are discussed in detail. The inductance of the discharge loop is minimized using a water capacitor arrangement. A very high specific optical power (90 MW/l) is achieved in an active volume of 1.2 l. The pulse energy exceeds 5 J in a 45 ns pulse (FWHM). Komatsu Ltd., Manda 1200, Hiratsuka-shi, Kanagawa 254, Japan Institute of Optics and Fine Mechanics, Department of Plasma Physics, Academia Sinica, Shanghai, P.R. China     

Factors affecting polyhydroxybutyrate biosynthesis in the marine photosynthetic bacteriumRhodopseudomonas sp. strain W-1S

Applied Biochemistry and Biotechnology - A marine photosynthetic bacterium,Rhodopseudomonas sp. strain W-1S, accumulated polyhydroxybutyrate (PHB) to 56% of the dry cell weight under microaerobic...     

Transformation of Cinchona alkaloids into 1-N-oxide derivatives by endophytic Xylaria sp isolated from Cinchona pubescens

The microbial transformation of four Cinchona alkaloids (quinine, quinidine, cinchonidine, and cinchonine) by endophytic fungi isolated from Cinchona pubescens was investigated. The endophytic filamentous fungus Xylaria sp. was found to transform the Cinchona alkaloids into their 1-N-oxide derivatives.     

Preparation and characterization of novel polyaryloxydiphenylsilanes with high glass transition temperature by melt polycondensation of dianilinodiphenylsilane with bisphenols

Novel polyaryloxydiphenylsilanes with reduced viscosities of 0.31–0.65 dL/g were obtained by the melt polycondensation of dianilinodiphenylsilane with three bisphenols, 2,2-bis (4-hydroxyphenyl)-1,1,1,3,3,3-hexafluoropropane, 3 (4-hydroxyphenyl)-1,1,3-trimethyl-5-indanol, and 9,9-bis (4-hydroxyphenyl) fluorene, at 200–320°C in vacuo. These polymers are all amorphous and readily soluble in a wide variety of organic solvents such as chlorinated and aromatic hydrocarbons, cyclic ethers, and polar aprotic solvents. Because of their bulky and/or rigid ring structures, polyaryloxydiphenylsilanes containing diphenylhexafluoropropane, phenylindane, and diphenylfluorene units in the main chain have high glass transition temperatures of 106, 112, and 172°C, respectively. They are thermally stable showing almost no weight loss up to 350°C in air. Colorless, transparent, but brittle films are obtained from these polymers by solution casting. Ultraviolet transmission is sharply cut off by these polyaryloxydiphenylsilane films at ca. 300 nm, and the cut-off wavelength depends on the bisphenols used.