Glottal airflow and transglottal air pressure measurements for male and female speakers in soft, normal, and loud voice

Measurements on the inverse filtered airflow waveform (the "glottal waveform") and of estimated average transglottal pressure and glottal airflow were made from noninvasive recordings of productions of syllable sequences in soft, normal, and loud voice for 25 male and 20 female speakers. Statistical analyses showed that with change from normal to loud voice, both males and females produced loud voice with increased pressure, accompanied by increased ac flow and increased maximum airflow declination rate. With change from normal voice, soft voice was produced with decreased pressure, ac flow and maximum airflow declination rate, and increased dc and average flow. Within the loudness conditions, there was no significant male-female difference in air pressure. Several glottal waveform parameters separated males and females in normal and loud voice. The data indicate higher ac flow and higher maximum airflow declination rate for males. In soft voice, the male and female glottal waveforms were more alike, and there was no significant difference in maximum airflow declination rate. The dc flow did not differ significantly between males and females. Possible relevance to biomechanical differences and differences in voice source characteristics between males and females and across loudness conditions is discussed.     

Dual quartz crystal microbalance compensation using a submerged reference crystal. Effect of surface roughness and liquid properties

Absolute resonant frequency measurements were made on gold-coated AT-cut quartz crystals with one face in contact with a series of liquids. The effect of surface roughness and liquid properties (viscosity and density) was analyzed in terms of a “trapped liquid” model. In this model, liquid present in surface imperfections is viewed as rigidly coupled mass. In some of the literature this density-dependent, but not viscosity-dependent, term is viewed as being additive to the hydrodynamic shift seen for a smooth surface. Data obtained using 1 μm and 5 μm surface finish crystals are inconsistent with the predictions of the trapped liquid model. This suggests hydrodynamic coupling between liquid internal and external to the crevices. Despite the lack of a theoretical model for the liquid motion, it is possible to compensate for frequency variations resulting from changing liquid properties and for roughness effects by making direct measurements of the resonant frequency difference between two crystals exposed to the same solution. This novel procedure works to the extent that the two crystals have similar surface topographies. Compensation is excellent for 1 μm finish crystals and good for 5 μm finish crystals.     

Spectroelectrochemical characterisation of poly[Ni(saltMe)]-modified electrodes

Electrogenerated polymers based on the nickel(II) complex 2,3-dimethyl-N,N'-bis(salicylidene)butane-2,3-diaminatonickel(II), poly[Ni(saltMe)], were characterised by in situ FTIR and UV/Vis spectroscopy and ex-situ EPR spectroscopy in order to gain insights into film structure, electronic states and charge conduction. The role of the nickel ions during film oxidation was probed by using EPR to study naturally abundant Ni and 61Ni-enriched polymers. The data from all the spectroscopic techniques are consistent, and clearly indicate that polymerisation and redox switching are associated with oxidative ligand based processes; coulometry suggests that one positive charge was delocalised through each monomer unit. EPR provided evidence for the non-direct involvement of the metal in polymer oxidation: the polymer is best described as a polyphenylene-type compound (conducting polymer), rather than an aggregation of nickel complexes (redox polymer), and the main charge carriers are identified as polarons. An explanation for the high electrochemical stability and conductivity of poly[Ni(saltMe)] with respect to that of poly[Ni(salen)] is proposed. based on stereochemical repulsion between monomeric units; this can impose a less compact supramolecular structure on polymers with bulkier substituents.     

Gallium cluster "magic melters"

Calorimetry measurements (using a method based on multicollision induced dissociation) have been performed for unsupported gallium clusters, Gan+ (n = 30-50 and 55). Melting transitions have been identified from spikes in the heat capacities recorded as a function of temperature. There are enormous fluctuations in the melting temperatures and the heats of fusion with cluster size. Clusters with n = 31, 33, 37, and 45-47 are "magic melters" with particularly well-defined melting transitions. There is a strong correlation between the heats of fusion, entropies of fusion, and the stabilities of the clusters. However, these quantities are not strongly correlated with the melting temperatures.     

Interactions of nitrosonium salts with crown ethers

Interactions of nitrosonium tetrafluoroborate and hexafluorophosphate with 18-crown-6, 15-crown-5, and 12-crown-4 in dichloromethane, acetonitrile, and nitromethane have been probed by a combination of proton magnetic resonance spectroscopy, infrared spectroscopy, and conductance measurements. The stoichiometrics of the crown ether-nitrosonium salt complexes were one mole of 18-crown-6 per mole of nitrosonium salt and two moles of 12-crown-4 per mole of nitrosonium salt in all solvents. For 15-crown-5, the one-to-one stoichiometry observed in acetonitrile and nitromethane changed to two moles of crown ether per mole of nitrosonium salt in dichloromethane. The nature of these complexes is discussed. Treatment of a solution of equimolar nitrosonium hexafluorophosphate and 18-crown-6 in dichloromethane with water produced hydronium hexafluorophosphate-18-crown-6 complex.     

Nucleation and growtn of polythiophene films on gold electrodes

The nucleation and growth of polythiophene films on gold electrodes has been studied using potentiostatic steps. The mechanism has been deduced and estimates made of the kinetic parameters. Dissolution of the gold substrate at potentials where thiophene polymerisation occurs is suppressed by the initial rapid formation of a monolayer of polymer. The data indicate that formation of bulk film occurs by the instantaneous nucleation and three-dimensional growth of polymer on top of this monolayer. Rate constants for growth parallel to the surface on the bare gold substrate and the covering polymer layer are surprisingly very similar. Growth perpendicular to the surface is slightly more rapid, typically by a factor of 1.5–3, although it is less dependent on potential. The high density of nuclei results in their overlap at an early stage, after which growth is only possible perpendicular to the surface. Within a narrow potential range, the observation of maxima and minima in current-time transients is interpreted in terms of the “death” and “rebirth” of growing centres.     

Ion recognition properties of poly[Cu(3-MeOsalpd)] films

Poly[Cu(3-MeOsalpd)] films with good physical, chemical and electrochemical stability may be potentiodynamically electrodeposited with high deposition efficiency from acetonitrile solutions of the monomer. Comparative coulometric assays with the Ni-based analogue show that the metal in the salen motif does play a role in the electronic structure of the polymer, but that the electroactive response is ligand (not metal) based. The dynamics of redox switching are ultimately limited by coupled electron/counter ion diffusion, but this process is sufficiently rapid that it influences the voltammetric response only for thick films (Γ >420?nmol?cm^?2) at high scan rates. Redox cycling in monomer-free electrolyte shows a voltammetric signature that responds, via interaction with the pseudo-crown ether receptor sites, to the presence of Li⁺, K⁺, Mg²⁺ and Ba²⁺ ions in solution. The most prominent change is associated with the first anodic peak in the i-E signature. For each of the metal ions considered, this peak potential responds logarithmically to concentration in a manner that varies with individual complexed cation and film thickness and to an extent greater than predicted by the Nernst equation. The film characteristics offer some analytical promise, including a trade-off between sensitivity and dynamic range and signal amplification, possibly due to supramolecular effects.     

An Activatable AIEgen Probe for High‐Fidelity Monitoring of Overexpressed Tumor Enzyme Activity and Its Application to Surgical Tumor Excision

Monitoring fluctuations in enzyme overexpression facilitates early tumor detection and excision. An AIEgen probe (DQM‐ALP) for the imaging of alkaline phosphatase (ALP) activity was synthesized. The probe consists of a quinoline‐malononitrile (QM) core decorated with hydrophilic phosphate groups as ALP‐recognition units. The rapid liberation of DQM‐OH aggregates in the presence of ALP resulted in aggregation‐induced fluorescence. The up‐regulation of ALP expression in tumor cells was imaged using DQM‐ALP. The probe permeated into 3D cervical and liver tumor spheroids for imaging spatially heterogeneous ALP activity with high spatial resolution on a two‐photon microscopy platform, providing the fluorescence‐guided recognition of sub‐millimeter tumorigenesis. DQM‐ALP enabled differentiation between tumor and normal tissue ex vivo and in vivo, suggesting that the probe may serve as a powerful tool to assist surgeons during tumor resection.     

Functions on tableau frames

In a previous paper the authors used an algorithm for a bijection from the set F of all functions with nonnegative integral values defined on a Young tableau frame Φ onto the set E of all reverse plane partitions (rpp) on Φ in their new proof of R.P. Stanley's generating function for rpp. The algorithm gave new and clear combinatorial significance to the hook numbers of Φ as lengths of zigzag paths but left open the question of invariance of the bijection under interchange of the roles of rows and columns.Here this invariance is proved and the bijection is generalized to allow the entries to be in any linearly ordered additive group. The new algorithms involve n-tuples of paths and use the discreteness of the frame to introduce quantum falls or rises in the entries. New light is shed by considering a tableau frame to be a union of certain rectangles and the hook number of a node to be the number of these rectangles containing the node.