Interactions between a nonionic gemini surfactant and cyclodextrins investigated by small-angle neutron scattering

The microstructure of complexes between hydroxypropyl-cyclodextrins (HPCDs) (alpha, beta, and gamma) and a novel gemini surfactant has been investigated by small-angle neutron scattering (SANS). This nonionic hetero-gemini surfactant (denoted NIHG750) contains two hydrophobic groups and two hydrophilic groups. One is a methyl-capped polyoxyethylene chain with 16 oxyethylene units and the other is a secondary hydroxyl group. Various form factor models have been considered for fitting the SANS data. Spherical aggregates (25 to 40 A) with a size slightly larger than that of NIHG750 micelles (about 23 A) appear in mixed systems. These could be micellar aggregates partly covered with a few cyclodextrin molecules. In addition, the results indicate rod formation (r approximately 8 A, L approximately 70 A) for the NIHG-HPCD complexes. This result is consistent with the threading of HPCDs onto NIHG750 to such an extent that the surfactant molecule takes an extended conformation at high levels of HPCD. Also, the results indicate that HPCDs may interact with the oxyethylene groups of the spherical micellar aggregates leading to an increase in micelle size and a gradual transformation to rod-shaped aggregates. The tendency to form rods increases in the order gamma-CD相似文献   

Hybrid fluorocarbon-hydrocarbon CO2-philic surfactants. 2. formation and properties of water-in-CO2 microemulsions

Hybrid fluorocarbon-hydrocarbon (F-H) sulfate surfactants are shown to be efficient stabilizers in water-in-CO2 (w/c) microemulsions. The chain structure and F-H ratio affect the regions of P-T phase stability and aggregation structure in these w/c phases. High-pressure near-infrared spectroscopy and small-angle neutron scattering measurements of microemulsified water provide evidence for the stabilization of w/c microemulsion droplets. The relative lengths of the two chains were found to influence the favored aggregation structure: for symmetric chain surfactants (F8H8, F7H7) spherical reverse micelles are present, but for asymmetric chain surfactants (F7H4, F8H4) extended cylinder aggregates form. These changes in aggregation are consistent with different surfactant packing parameters owing to the controlled variations in molecular structure. Furthermore, the general order of w/c phase transition pressures (F8H8 < F7H7 and F8H4 < F7H4) is in line with estimations of surfactant fractional free volume, as proposed by Johnston et al. (J. Phys. Chem. B 2004, 108, 1962-1966). Studies of adsorption at the poly(dimethylsiloxane)-water interface are shown to be valuable for assessing the CO2-philicity of new surfactants. All in all, the symmetric F8H8 and F7H7 analogues are seen to be the most efficient compounds from this class for applications in CO2.     

Poly(butyl methacrylate-g-methoxypoly(ethylene glycol)) and poly(methyl methacrylate-g-methoxypoly(ethylene glycol)) graft copolymers: preparation and aqueous solution properties

A series of water-soluble, amphiphilic graft copolymers has been prepared by free-radical copolymerization of methoxypoly(ethylene glycol) macromonomers, with either methyl methacrylate or butyl methacrylate as the comonomers, in water/ethanol solvent mixtures. Lower molecular weight copolymers were obtained by increasing the concentration of the initiator, azobisisobutyronitrile (AIBN), used in the polymerization reaction. However, the route used also led to the formation of significant quantities of tetramethylsuccinodinitrile, a toxic byproduct resulting from the cage reaction of AIBN. Static fluorescence measurements using pyrene as a probe, along with 1H NMR experiments, showed that the graft copolymers form aggregates in water at very low concentrations (approximately 0.01 g l(-1)) with the pendant hydrophilic graft chains forming a stabilizing shell around the hydrophobic backbone. An increase in the hydrophile-lipophile balance of the graft copolymers was found to lead to smaller aggregates with lower aggregation numbers and highly swollen hydrophilic shells, as revealed by small angle neutron scattering (SANS).     

The structure of metallomicelles

The morphology of micelles formed by two novel metallosurfactants has been studied by small-angle neutron scattering (SANS) and small-angle-X-ray scattering (SAXS). The two surfactants both contain a dodecyl chain as the hydrophobic moiety, but differ in the structure of the head group. The surfactants are Cu(II) complexes of monopendant alcohol derivatives of a) the face-capping macrocycle 1,4,7-triazacyclanonane (tacn), and b) an analogue based upon the tetraazamacrocycle 1,4,7,10-tetraazacyclododecane. Here, neutron scattering has been used to study the overall size and shape of the surfactant micelles, in conjunction with X-ray scattering to locate the metal ions. For the 1,4,7,10-tetraazacyclododecane-based surfactant, oblate micelles are observed, which are smaller to the prolate micelles formed by the 1,4,7-triazacyclononane analogue. The X-ray scattering analysis shows that the metal ions are distributed throughout the polar head-group region, rather than at a well-defined radius; this is in good agreement with the SANS-derived dimensions of the micelle. Indeed, the same model for micelle morphology can be used to fit both the SANS and SAXS data.     

Effect of ethanol on the interaction between poly(vinylpyrrolidone) and sodium dodecyl sulfate

The effect of ethanol on the interaction between the anionic surfactant sodium dodecyl sulfate (SDS) and the nonionic polymer poly(vinylpyrrolidone) (PVP) has been investigated using a range of techniques including surface tension, fluorescence, electron paramagnetic resonance (EPR), small-angle neutron scattering (SANS), and viscosity. Surface tension and fluorescence studies show that the critical micelle concentration (cmc) of the surfactant decreases to a minimum value around 15 wt % ethanol; that is, it follows the cosurfactant effect. However, in the presence of PVP, the onset of the interaction, denoted cmc(1), between the surfactant and the polymer is considerably less dependent on ethanol concentration. The saturation point, cmc(2), however, reflects the behavior of the cmc in that it decreases upon addition of ethanol. This results in a decrease in the amount of surfactant bound to the polymer [C(bound) = cmc(2) - cmc] at saturation. The viscosity of simple PVP solutions depends on ethanol concentration, but since SANS studies show that ethanol has no effect on the polymer conformation, the changes observed in the viscosity reflect the viscosity of the background solvent. There are significant increases in bulk viscosity when the surfactant is added, and these have been correlated with the polymer conformation extracted from an analysis of the SANS data and with the amount of polymer adsorbed at the micelle surface. Competition between ethanol and PVP to occupy the surfactant headgroup region exists; at low ethanol concentration, the PVP displaces the ethanol and the PVP/SDS complex resembles that formed in the absence of the ethanol. At higher ethanol contents, the polymer does not bind to the ethanol-rich micelle surface.     

Enhanced ethanol sensing properties of WO3 modified TiO2 nanorods

Pristine and WO₃ decorated TiO₂ nanorods (NRs) were synthesised to investigate n-n-type heterojunction gas sensing properties. TiO₂ NRs were fabricated via hydrothermal method on fluorine-doped tin oxide coated glass (FTO) substrates. Then, tungsten was sputtered on the TiO₂ NRs and thermally oxidised to obtain WO₃ nanoparticles. The heterostructure was characterised by X-ray diffraction (XRD), scanning electron microscopy (SEM), and energy-dispersive X-ray (EDX) spectroscopy. Fabricated sensor devices were exposed to VOCs such as toluene, xylene, acetone and ethanol, and humidity at different operation temperatures. Experimental results demonstrated that the heterostructure has better sensor response toward ethanol at 200 °C. Enhanced sensing properties are attributed to the heterojunction formation by decorating TiO₂ NRs with WO₃.     

Flowerlike hybrid horseradish peroxidase nanobiocatalyst for the polymerization of guaiacol

In this study, the catalytic activity and stability of flowerlike hybrid horseradish peroxidase (HRP) nanobiocatalyst (HRP-Cu ²⁺ ) obtained from Cu ²⁺ ions and HRP enzyme in the polymerization reaction of guaiacol were analyzed. We demonstrated that HRP-Cu ²⁺ and hydrogen peroxide (H ₂ O ₂ ) initiator showed significantly increased catalytic activity and stability on the polymerization of guaiacol compared to that of free HRP enzyme. Poly(guaiacol) was observed with quite high yields (88%) and molecular weights (38,000 g/mol) under pH 7.4 phosphate-buffered saline (PBS) conditions at 60 °C with 5 weight% of HRP-Cu ²⁺ loading. HRP-Cu ²⁺ also shows very high thermal stability and works even at 70 °C reaction temperature; free HRP enzyme denatures at that temperature. Furthermore, HRP-Cu ²⁺ provided considerable repeated use and showed some degree of catalytic activity, even after the fourth recycle, in the polymerization of guaiacol.     

Chemical composition,antimicrobial, and lipase enzyme activity of essential oil and solvent extracts from Serapias orientalis subsp. orientalis

The volatile components of essential oil (EO), SPME, and SPME of solvent extracts ( n -hexane, methanol, and water) obtained from fresh Serapias orientalis subsp. orientalis ( Soo ) were analyzed by GC-FID/MS. EO of Soo gave 11 compounds in the percentage of 99.97%; capronaldehyde (37.01%), 2-( E )-hexenal (23.19%), and n -nonanal (19.05%) were found to be major constituents. SPME GC-FID/MS analyses of fresh plant and solvent extracts of Soo revealed 7, 12, 7, and 4 compounds within the range of 99.7% to 99.9%. Limonene (76.5%, 41.7%, and 61.3%) was the major compound in SPMEs of the n -hexane and methanol extracts. α -Methoxy- p -cresol (52.9%) was the main component in its water extract. The antimicrobial activity of EO and the solvent extracts of Soo were screened against 9microorganisms. EO showed the best activity against Mycobacterium smegmatis , with 79.5 µg/mL MIC value. The n -hexane, methanol, and water extracts were the most active against the Staphylococcus aureus within the range of 81.25–125.0 µg/mL (MIC). IC ₅₀ values for the lipase enzyme inhibitory activity of EO and solvent extracts ( n -hexane, methanol, and water) were determined to be 59.87 µg/mL, 64.03 µg/mL, 101.91 µg/mL, and 121.24 µg/mL, respectively.     

Observation of D+(s)K- and evidence for D+(s)pi- final states in neutral B decays

We report the first observation of a B meson decay that is not accessible by a direct spectator process. The channel B(0)-->D(+)(s)K- is found in a sample of 85 x 10(6) BB; events, collected with the Belle detector at KEKB, with a branching fraction B(B(0)-->D(+)(s)K-)=(4.6(+1.2)(-1.1)+/-1.3) x 10(-5). We also obtain evidence for the B0-->D(+)(s)pi(-) decay with branching fraction B(B0-->D(+)(s)pi(-))=(2.4(+1.0)(-0.8)+/-0.7) x 10(-5). This value may be used to extract a model-dependent value of |V(ub)|.     

Measurement of branching fractions for B-->eta(c)K(*) decays

We report measurements of branching fractions for charged and neutral B-->eta(c)K decays where the eta(c) meson is reconstructed in the K(0)(S)K+/-pi(-/+), K+K-pi(0), K(*0)K-pi(+), and pp; decay channels. The neutral B0 channel is a CP eigenstate and can be used to measure the CP violation parameter sin(2phi(1). We also report the first observation of the B0-->eta(c)K(*0) mode. The results are based on an analysis of 29.1 fb(-1) of data collected by the Belle detector at KEKB.