Highly efficient recycling of a "sandwich" type polyoxometalate oxidation catalyst using solvent resistant nanofiltration

A "sandwich" type polyoxometalate catalyst ([MeN(n-C8H17)3]12[WZn3(ZnW9O34)2]) was very efficiently recycled by nanofiltration with almost quantitative retention, using an alpha-alumina supported mesoporous gamma-alumina membrane.     

1H-CRAMPS Solid-State NMR and X-Ray Crystal Studies of Inclusion Complexes Formed from 3,3′-bis(9-Hydroxy-9-fluorenyl)-2,2′-binaphthyl Hosts with Acetone

The crystal structures of inclusion compounds of 3,3-bis(9-hydroxy-9-fluorenyl)-2,2-binaphthyl host (1) and its chloro (2) or bromo (3) derivatives substituted in 2,7-positions of the fluorene units with acetone guests (1A–3A) were determined by X-ray studies as well as by ¹H-CRAMPS solid-state NMR. Using this NMR technique allows identification of differently bound guest molecules due to their different chemical shifts caused by the influence of the ring current effects of the host aryl units.     

Finding the αn-th largest element

We describe an algorithm for selecting the n-th largest element (where 0<<1), from a totally ordered set ofn elements, using at most (1+(1+o(1))H())·n comparisons whereH() is the binary entropy function and theo(1) stands for a function that tends to 0 as tends to 0. For small values of this is almost the best possible as there is a lower bound of about (1+H())·n comparisons. The algorithm obtained beats the global 3n upper bound of Schönhage, Paterson and Pippenger for <1/3.     

Different chemical dynamics for different conformers of biological molecules: photoionization of glycine

Single-photon ionization dynamics of two conformers of glycine is studied by classical trajectory simulations using the semiempirical PM3 potential surface in "on the fly" calculations. Initial conditions for the trajectories are weighted according to the Wigner distribution function computed for the initial vibrational ground state. Vertical ionization in the spirit of the classical Franck-Condon principle is assumed. The dynamics of the two conformers are compared during the first 10 ps. The comparison shows very different dynamical behavior for the two conformers. In particular, the chemical fragmentation pathways differ in part. Also, one of the conformers gives much higher rates of conformational transitions, while the other conformer gives larger chemical fragmentation yields. The example shows significantly different chemical dynamics for two conformers close in energy and separated by a low barrier.     

Photoionization dynamics of glycine adsorbed on a silicon cluster: "on-the-fly" simulations

Dynamics of glycine chemisorbed on the surface of a silicon cluster is studied for a process that involves single-photon ionization, followed by recombination with the electron after a selected time delay. The process is studied by "on-the-fly" molecular dynamics simulations, using the semiempirical parametric method number 3 (PM3) potential energy surface. The system is taken to be in the ground state prior to photoionization, and time delays from 5 to 50 fs before the recombination are considered. The time evolution is computed over 10 ps. The main findings are (1) the positive charge after ionization is initially mostly distributed on the silicon cluster. (2) After ionization the major structural changes are on the silicon cluster. These include Si-Si bond breaking and formation and hydrogen transfer between different silicon atoms. (3) The transient ionization event gives rise to dynamical behavior that depends sensitively on the ion state lifetime. Subsequent to 45 fs evolution in the charged state, the glycine molecule starts to rotate on the silicon cluster. Implications of the results to various processes that are induced by transient transition to a charged state are discussed. These include inelastic tunneling in molecular devices, photochemistry on conducting surfaces, and electron-molecule scattering.     

Very Simple One-Step Synthesis of Vinylphosphonates and Enamine Phosphonates by Direct Addition of Organolithium Reagents to 1-Alkynylphosphonates

Abstract

Direct addition of organolithium to 1-alkynylphosphonates (1) afforded vinylphosphonates and enamine phosphonates (2) in good to excellent yields. The reaction was carried out in dry THF at low temperature and proved to be completely stereoselective (syn addition). Alkyl, aryl, and haloalkyl groups were attached to the alkynyl entity, so the resulting vinylphosphonates contained various functional groups. The stereochemistry of the products as well as mechanism of the reaction were determined based on ¹H and ¹³C NMR. The synthesis of enamine phosphonates in the absence of complicated, highly expensive organometallic catalysis has not been previously reported.     

Longitudinal Relaxation Enhancement in 1H NMR Spectroscopy of Tissue Metabolites via Spectrally Selective Excitation

Nuclear magnetic resonance spectroscopy is governed by longitudinal (T₁) relaxation. For protein and nucleic acid experiments in solutions, it is well established that apparent T₁ values can be enhanced by selective excitation of targeted resonances. The present study explores such longitudinal relaxation enhancement (LRE) effects for molecules residing in biological tissues. The longitudinal relaxation recovery of tissue resonances positioned both down‐ and upfield of the water peak were measured by spectrally selective excitation/refocusing pulses, and compared with conventional water‐suppressed, broadband‐excited counterparts at 9.4 T. Marked LRE effects with up to threefold reductions in apparent T₁ values were observed as expected for resonances in the 6–9 ppm region; remarkably, statistically significant LRE effects were also found for several non‐exchanging metabolite resonances in the 1–4 ppm region, encompassing 30–50 % decreases in apparent T₁ values. These LRE effects suggest a novel means of increasing the sensitivity of tissue‐oriented experiments, and open new vistas to investigate the nature of interactions among metabolites, water and macromolecules at a molecular level.     

Inverse Monte Carlo renormalization group transformations for critical phenomena

We introduce a computationally stable inverse Monte Carlo renormalization group transformation method that provides a number of advantages for the calculation of critical properties. We are able to simulate the fixed point of a renormalization group for arbitrarily large lattices without critical slowing down. The log-log scaling plots obtained with this method show remarkable linearity, leading to accurate estimates for critical exponents. We illustrate this method with calculations in two- and three-dimensional Ising models for a variety of renormalization group transformations.     

A water-soluble and "self-assembled" polyoxometalate as a recyclable catalyst for oxidation of alcohols in water with hydrogen peroxide

We have demonstrated that a simply prepared water-soluble polyoxometalate, Na12[WZnZn2(H2O)2(ZnW9O34)2], synthesized from readily available zinc and tungsten salts in the presence of nitric acid, is an effective catalyst for selective alcohol oxidation with hydrogen peroxide in biphasic (water-alcohol) reaction media. Experiments have shown that the "self-assembled" catalyst in its mother liquor was as active as the isolated catalyst. The aqueous catalyst solution is easily separated from the water-insoluble products and can be recycled without loss in activity or selectivity.     

Dynamic evolution of economically preferred facilities

In a sustained development scenario, it is often the case that an investment is to be made over time in facilities that generate benefits. The benefits result from joint synergies between the facilities expressed as positive utilities specific to some subsets of facilities. As incremental budgets to finance fixed facility costs become available over time, additional facilities can be opened. The question is which facilities should be opened in order to guarantee that the overall benefit return over time is on the highest possible trajectory. This problem is common in situations such as ramping up a communication or transportation network where the facilities are hubs or service stations, or when introducing new technologies such as alternative fuels for cars and the facilities are fueling stations, or when expanding the production capacity with new machines, or when facilities are functions in a developing organization that is forced to make choices of where to invest limited funding.