Calculation of the dynamic temperature characteristics of a heated graphite tube used in electrothermal atomic absorption measurements

A method and computer program were developed for calculating the temperature of any part of a graphite furnace tube at any instant of time after onset of the heating cycle. Results for tubes of the Massman design show large differences in spatial temperature distributions during and at the end of the heating cycle when equilibrium is reached. When constant current is applied to contoured tubes, greater heating rates at the tube centres are obtained than with standard tubes.     

Ultraviolet protection factors for clothing: an intercomparison of measurement systems

In recent years the need to standardize measurement protocols for quantifying the degree of ultraviolet radiation (UVR) protection provided by clothing has led to the introduction of a number of standards around the world. To date, these standards have specified spectral measurements of UVR transmission by clothing and fabrics. Development of a standard test method has become an important part of the testing process, and this article presents results from an intercomparison involving 10 independent testing laboratories and 11 different UVR transmission measurement instruments. In addition to comparing the measured ultraviolet protection factors (UPF), this intercomparison also incorporates detailed scan results from all 10 laboratories and highlights differences in performance of the various instruments in different wavelength regions. Careful examination of these differences can indicate where changes to the systems could be made to allow improvements both in equipment performance and in agreement of the final results. The variability in the measurements of UPF in this study suggest that the protection categories in standards may need to be broadened.     

A glow discharge lamp with supplementary excitation by a radio—frequency discharge-preliminary measurements

The emission radiant output of an ordinary glow discharge plasma was increased by several factors through secondary inductively coupled RF excitation produced by an external coil and a 136.2MHz oscillator. The gain factor was determined at several glow discharge currents and voltages in copper alloys and cast iron samples. Improved linear calibration curves were obtained because the RF-boosted glow discharge source decreased the effect of self-absorption.     

Kinetic temperatures and electron densities in the plasma of a side view Grimm-type glow discharge

A special source in which the Grimm-type plasma is viewed side-on for spectroscopic measurements was constructed. The kinetic gas temperatures and electron densities were derived from the line profiles of Ar I 415.8 nm and He I 447.1 nm respectively.     

Distribution of metastable argon atoms in the modified Grimm-type electrical discharge

The absorbance by metastable argon atoms of the Ar 696.543 nm line in the modified Grimm-type electrical discharge source was measured at different discharge conditions and at distances varying from 0.25 to 6 mm from the cathode. A uranium/argon hollow cathode lamp was used as primary source, which gave an argon gas temperature of 850 K when run at 12 mA. A maximum absorbance of 0.57 was found 3 mm from the cathode at 600 V, 80 mA. The magnitude of absorbance increases with discharge current while the position of maximum absorbance shifts away from the cathode with increase in discharge voltage. The quenching of metastable atoms by nitrogen is demonstrated.The spatial distribution of the intensity of four different types of spectral lines is shown. The approximate number densities of the different particles are 10¹²cm^?3 for metastable argon atoms, 10¹⁶cm^?3 for neutral argon atoms, 10¹³ cm^?3 for sputtered copper atoms and 10¹⁴cm^?3for electrons.     

Experimental characteristics of direct current and high frequency boosted hollow cathode lamps

Two types of boosted output hollow cathode lamps, viz. direct current and high frequency boosted lamps, were investigated and the characteristics compared. Both lamps are demountable and use the same water-cooled cathode holder. Remarkably similar results were obtained for both types of booster discharges with respect to intensity enhancement of various spectral lines of a number of elements, and with respect to line widths, which were measured with a Fabry-Perot interferometer for strontium only. The interferometer measurements also revealed that although the gain in total intensity for Sr is only about a factor of 8, the gain in intensity at line centre is approximately a factor 40. Although the intensity enhancement caused by the booster discharges is relatively small (～ a factor of 10) for resonance lines in the visible region, the absolute intensities of these lines are much higher than those of lines in the ultraviolet.     

An investigation into the role of metastable argon atoms in the afterglow plasma of a low pressure discharge

An investigation into the behaviour of metastable argon atoms in a low pressure (250 Pa) pulsed electrical discharge was undertaken in an effort to find the cause of the persisting emission from sputtered metal atoms in the afterglow of an atomic fluorimeter. Results obtained by time-resolved emission and absorption measurements of several argon and copper spectral lines indicate that low energy electrons in the afterglow are converted to high energy electrons via the recombination of electrons with argon ions and the subsequent collisions of pairs of metastable argon atoms. The high energy electrons excite the sputtered metal atoms to give rise to a slow decaying emission tail in the afterglow. A probable change in the electron energy distribution in the afterglow may also have an effect on the observed emission. This phenomenon may be reduced by the use of a suitable quenching gas.     

The Improvement of Signal to Noise Ratio Using a Pulsed Hollow Cathode Lamp and Gated Detector for Atomic Fluorescence Measurements

An expression for the maximum increase in signal to noise ratio obtainable with a pulsed hollow cathode lamp as primary source for atomic fluorescence measurements is derived under certain assumptions. Experience with copper and calcium hollow cathode lamps showed that by using these lamps in the pulsed mode in conjunction with a gated detector, the increase in signal to noise ratios obtained are less than a factor of 5, due to self-absorption broadening of the primary source emission lines.     

Development of a sensitive and specific liquid chromatography/mass spectrometry method for the determination of tenofovir in human plasma

A sensitive and specific method for the quantitation of tenofovir (TFV) in human plasma by liquid chromatography/electrospray ionization mass spectrometry was developed and validated. Plasma samples were prepared by solid-phase extraction performed on Waters Oasis cation-exchange cartridges (30 mg). Chromatographic separation was performed isocratically on a reversed-phase Waters Atlantis dC18 column (2.0x100 mm, 3 microm). The mobile phase consisted of a hydroxylamine/acetic acid buffer (pH 6.75) and methanol (93:7, v/v). The acquisition was performed in selected ion monitoring mode for the protonated molecular ions [M+H]+ of m/z 288.2 for TFV and 212.2 for the internal standard, zalcitibine. The method was fully validated to determine its specificity, recovery, linearity and sensitivity, accuracy and precision. The analytical range was set at 1-750 ng/mL using a 200 microL plasma sample, with a mean coefficient of determination (r2) of 0.9969. The mean accuracies for the calibration standards ranged from -5.0 to 4.3%, while the precisions were within 1.2 and 6.4%. Intra-assay and inter-assay mean accuracies for three quality control concentrations (2, 60, and 600 ng/mL) ranged from -6.1 to 10.7%, while the precisions were within 1.3 and 9.1%. TFV was shown to be stable under normal storage and assay conditions; no degradation was seen when stored at -20 degrees C or -80 degrees C for up to 6 months, and after 16 h at room temperature in the injection matrix. The present method provides an accurate, precise, and sensitive tool for TFV quantitation and was successfully applied to an external proficiency-testing program and pharmacokinetic analysis.     

Shelf-Life Stability of Ready-to-Use Green Rooibos Iced Tea Powder—Assessment of Physical,Chemical, and Sensory Properties

Green rooibos extract (GRE), shown to improve hyperglycemia and HDL/LDL blood cholesterol, has potential as a nutraceutical beverage ingredient. The main bioactive compound of the extract is aspalathin, a C-glucosyl dihydrochalcone. The study aimed to determine the effect of common iced tea ingredients (citric acid, ascorbic acid, and xylitol) on the stability of GRE, microencapsulated with inulin for production of a powdered beverage. The stability of the powder mixtures stored in semi-permeable (5 months) and impermeable (12 months) single-serve packaging at 30 °C and 40 °C/65% relative humidity was assessed. More pronounced clumping and darkening of the powders, in combination with higher first order reaction rate constants for dihydrochalcone degradation, indicated the negative effect of higher storage temperature and an increase in moisture content when stored in the semi-permeable packaging. These changes were further increased by the addition of crystalline ingredients, especially citric acid monohydrate. The sensory profile of the powders (reconstituted to beverage strength iced tea solutions) changed with storage from a predominant green-vegetal aroma to a fruity-sweet aroma, especially when stored at 40 °C/65% RH in the semi-permeable packaging. The change in the sensory profile of the powder mixtures could be attributed to a decrease in volatile compounds such as 2-hexenal, (Z)-2-heptenal, (E)-2-octenal, (E)-2-nonenal, (E,Z)-2,6-nonadienal and (E)-2-decenal associated with “green-like” aromas, rather than an increase in fruity and sweet aroma-impact compounds. Green rooibos extract powders would require storage at temperatures ≤ 30 °C and protection against moisture uptake to be chemically and physically shelf-stable and maintain their sensory profiles.