Embedded eigenvalues of Sturm Liouville operators

In this work we study the behavior of embedded eigenvalues of Sturm-Liouville problems in the half axis under local perturbations. When the derivative of the spectral function is strictly positive, we prove that the embedded eigenvalues either disappear or remain fixed. In this case we show that local perturbations cannot add eigenvalues in the continuous spectrum. If the condition on the spectral function is removed then a local perturbation can add infinitely many eigenvalues.     

Phenol biosensor based on electrochemically controlled integration of tyrosinase in a redox polymer

An amperometric biosensor for the detection of phenolic compounds was developed based on the immobilization of tyrosinase within an Os-complex functionalized electrodeposition polymer. Integration of tyrosinase within the redox polymer assures efficient catechol recycling between the enzyme and the polymer bound redox sites. The non-manual immobilization procedure improves the reproducibility of fabrication process, greatly reduces the desorption of the enzyme from the immobilization layer, and, most importantly prevents fast inactivation of the enzyme by its substrate due to fast redox cycling. A two-layer sensor architecture was developed involving ascorbic acid oxidase entrapped within an electrodeposition polymer in a second layer on top of the redox polymer/tyrosinase layer. Using this sensor architecture it was possible to eliminate the current interference arising from direct ascorbate oxidation up to a concentration of 630 μM ascorbic acid. The effects of the polymer thickness, the enzyme/polymer ratio, and the applied potential were evaluated with respect to optimal sensor properties. The sensitivity of the optimized sensors for catechol was 6.1 nA μM⁻¹ with a detection limit of 10 nM, and for phenol 0.15 nA μM⁻¹ with a detection limit of 100 nM.     

A spring-embedding approach for the facility layout problem

The facility layout problem is concerned with finding the most efficient arrangement of a given number of departments with unequal area requirements within a facility. The facility layout problem is a hard problem, and therefore, exact solution methods are only feasible for small or greatly restricted problems. In this paper, we propose a spring-embedding approach that unlike previous approaches results in a model that is convex. Numerical results demonstrating the potential of our model and the efficiency of our solution procedure are presented.     

Indirect fluorometric determination of diclofenac sodium.

A simple and easy method of analysis for diclofenac sodium is reported. A spectrofluorometric method for the microdetermination of diclofenac sodium has been developed through its reaction with cerium(IV) in an acidic solution and measurement of the fluorescence of the Ce(III) ions produced. Under the optimum experimental conditions for the oxidation reaction, 1.0 M H2SO4 with 90 min of heating time (100 degrees C), the range of application is 124.3-600 ng mL(-1) and the limit of detection is 72.7 ng mL(-1). The proposed method was applied to the determination of diclofenac sodium in pharmaceutical tablets. The results of the analysis show a good agreement with those obtained by the official USP 27 HPLC method.     

Inclusive\bar K^{0*} (892) andK 0*(892) production on silicon by 200 GeVK − andπ −

The production of the neutralK ^? (892) resonances by 200 GeVK ^? andπ ^? has been studied over the kinematic range 0.0<x _f<1.0 andp _t ² <5.0 GeV². Longitudinal and transverse momentum distributions are presented. In addition the decay angular distributions inK ^? fragmentation to \(\bar K^{0*} \) have been investigated.     

Mössbauer and infrared spectroscopic studies of novel mixed valence states in cobaltous ferrocyanides and ferricyanides

Novel mixed valence states have been obtained by the treatment of cobaltous ferrocyanides (Co⁺²Fe^II) and ferricyanides (Co⁺²Fe^III) in an ozone flow. The CN stretching bands occur at 2085 cm^–1 for Co⁺²Fe^II and at 2160 cm^–1 for Co⁺²Fe^III. After the ozonization process of Co⁺²Fe^II, an intense band approximately at 2125 cm^–1 is detected. This intermediate band must correspond to a mixed valence state of the type: Fe^II–CN–Co²⁺–NC–Fe^III Mössbauer spectra recorded in situ during the ozonization of Co⁺²Fe^II show the presence of two components: a doublet with isomer shift and quadrupole splitting values close to the cobalti ferricyanide and a very broad line for the mixed valence state. From the Mössbauer and infrared spectra of the aged samples of the Co⁺²Fe^II after ozonization, a relaxation process to the initial state of the samples is observed but the mixed valence state is stable.     

Simultaneous determination of Cd(II), Cu(II) and Pb(II) in surface waters by solid phase extraction and flow injection analysis with spectrophotometric detection

A method for heavy metal monitoring using spectrophotometric detection is presented. Traces of Cu(II), Pb(II) and Cd(II) at the low microg l(-1) level can be determined simultaneously after both selective removal of metal interferences and preconcentration using 'extraction chromatographic resins'. Lewatit TP807'84, which contains di(2,4,4-trimethylpentyl)phosphinic acid as active component, was used as solid adsorbent. Two minicolumns containing this resin were used: one at pH 3.2 for the removal of interferences, such as Zn(II) and Fe(III), and the other at pH 5.5 for the selective preconcentration of the target analytes. Spectrophotometric determination used FIA methodology with sulfarsazene as chromogenic reagent and partial least-squares multivariate calibration. The method was successfully applied to the analysis of surface waters from the Llobregat river and ground water samples from wells in the Guadiamar basin. Accuracy, expressed in terms of recoveries, was in the range 80-120% and relative standard deviations were below 10%.