Use of SPE—TLC for Quality Control of Rhodiola rosea Extracts

SPE and TLC have been used for qualitative and quantitative analysis of salidroside, rosavin, rosarin, and rosin in commercially available dry extracts from Rhodiola rosea roots. The best separation of all the compounds was achieved on silica gel TLC plates with ethyl acetate—methanol—water, 77 + 13 + 10 (v/v), as mobile phase. UV detection was performed at λ = 215 nm for salidroside and at λ= 245 nm for the rosavins (rosavin, rosarin, and rosin). Detection limits for salidroside and the rosavins were 90 ng and 60 ng per spot, respectively. Results from quantitative analysis confirmed the manufacturer’s declaration of the amounts of salidroside and the rosavins in the extracts.

     

Variation of the elasticoviscous characteristics of a heavily filled rubber after periodic shear deformation

The results of an investigation of the recovery of the elasticoviscous characteristics after thixotropic reduction by periodic deformation in the nonlinear zone are reported. The rate of recovery of the mechanical properties depends on the deformation frequency and the previous history of dynamic deformation is shown to affect the dependence of the elasticoviscous characteristics on the shear rate gradient. The effects of stationary and dynamic deformation regimes on the relaxation spectrum of the material are compared.Institute of Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga. Translated from Mekhanika Polimerov, No. 3, pp. 528–533, May–June, 1969.     

High-frequency periodic deformation of polymers in the viscous-flow state

The propagation of high-frequency periodic vibrations in melts and solutions is considered in the case where the acoustic characteristics of the material are determined by the deformation amplitude. It is shown that in sufficiently large specimens the consequences of periodic deformation are concentrated near the vibration source, as a result of which a layer of material with strongly modified mechanical characteristics develops. It is suggested that when periodic high-frequency deformation is superimposed on steady-state flow, owing to the presence of a boundary layer there is effective slippages of the material at the vibration-emitting surfaces.Institute of Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga. Translated from Mekhanika Polimerov, No. 4, pp. 722–728, July–August, 1973.     

A study of the shear viscosity of human whole saliva

Summary A model R-18 Weissenberg Rheogoniometer operating in the continuous shear mode was used to generate shear viscosity vs. shear rate data on male and female human whole saliva. These data were found to accurately follow the Sisko model, , whereµ is the shear viscosity at shear rate is the asymptotic shear viscosity at infinite shear rate, andK andn are constants. Data were collected on the effects of food, coffee, caffeine, and aspirin as functions of time. Studies were also made on the effects of emotional stress, donor sex and age.The saliva viscosity increased with time and then decreased to the basal value for most ingested materials. Emotional stress was found to elevate the saliva viscosity. On the other hand, no significant difference was found between the average saliva viscosities of male and female groups. Also, no significant effect of donor age was detected.

---

Zusammenfassung Mit Hilfe eines Weissenberg-Rheogoniometers (Typ R-18) wurden bei stationärem Betrieb Scherviskositätskurven in Abhängigkeit von der Schergeschwindigkeit für den Speichel von Männern und Frauen gemessen. Man fand, daß sich die Meßwerte hinreichend genau durch ein Sisko-Modell, , beschreiben lassen, woµ die Scherviskosität bei der Schergeschwindigkeit die asymptotische Scherviskosität bei unendlich großer Schergeschwindigkeit sowieK undn weitere Konstanten bedeuten. Diese Messungen verfolgten die Wirkung von Nahrung, Kaffee, Coffein und Aspirin als Funktion der Zeit. Untersucht wurde weiterhin der Einfluß von emotionaler Spannung, sowie Geschlecht und Alter der Spender.Die Speichelviskosität stieg bei den meisten eingenommenen Stoffen mit der Zeit zuerst an, um danach wieder auf den Normalwert abzusinken. Ebenso fand man, daß emotionale Spannung eine Viskositätserhöhung hervorruft. Dagegen wurden bei Gruppen von Männern und Frauen keine signifikanten Unterschiede gefunden, und ebenso wurde kein gesicherter Einfluß des Alters festgestellt.

---

---

With 4 figures and 6 tables     

Experimental determination of the influence of periodic shear deformation and filling on the effective viscosity of solutions of synthetic rubber

The influence of periodic shear deformation on the effective viscosity of filled solutions of synthetic rubber has been studied. The study was carried out on an amplitude-frequency viscosimeter developed by the authors. It has been established that during periodic deformation a linear region exists in which the effective viscosity is independent of the vibration rate, and a nonlinear region where the effective viscosity of the solutions decreases with increase in amplitude of the speed of relative deformation.Presented at the IV Symposium on Rheology of Polymers at the A. V. Topchiev Institute for Petrochemical Synthesis, Academy of Sciences of the USSR, Moscow, May 27–30, 1969.Institute for Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga. Translated from Mekhanika Polimerov, No. 3, 514–520, May–June, 1970.     

An extensional vibrorheometer for viscofluid polymers

An extensional vibrorheometer and a system for its automatic control have been developed. The instrument which has been created makes it possible to investigate liquid polymers under conditions of extensional deformation under a regime where =const. Such investigations may be carried out over a wide range of rates and deformations with the simultaneous superimposition on the extensional flow of periodic deformations covering a range of frequencies exceeding three decimal orders.Institute of Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga. Translated from Mekhanika Polimerov, No. 2, pp. 336–343, March–April, 1976.     

Rheological characteristics of melts of low-molecular-weight branched polyethylene in the region of critical molecular weights

The viscosity and the first difference of the normal stresses have been measured at stationary shear rates from 5.68 to 4500 sec^–1 for melts of low-density polyethylenes obtained by thermal degradation of commercial polyethylene in a nitrogen atmosphere. In addition, the complex modulus has been measured on the angular frequency range from 0.396 to 198.5 sec^–1. Three regions of molecular weights differing with respect to the value of the exponent in the relation ₀ = kM have been established. At > normal stresses are observed in the region of shear rates corresponding to a linear dependence of the shear rate on the shear stresses.Institute of Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga; Plastpolymer Research and Production Association, Leningrad. Translated from Mekhanika Polimerov, No. 6, pp. 963–967, November–December, 1973.     

Rheology and molecular structure of polyethylene melts 1. Melt identification from mechanical properties

It is proposed to use periodic deformation for the identification of the molecular structure of polyethylenes. By comparing the dependence of the complex and apparent viscosities on frequency and shear rate, respectively, it is shown that these functions are not equivalent for low-density polyethylene melts. The need for a numerical characteristic of the rheological functions, which should be related to the numerical characteristics of the molecular structure of the polymer, is established. The possibilities of using generalized relations for investigating the molecular structure are discussed. It is shown that the dynamic viscosity of polyethylene melts, described by a three-parameter equation, quite accurately reflects the viscoelastic properties of polyethylene melts and makes it possible, with the aid of the calculated function of the relaxation spectrum, to construct a frequency dependence of the modulus corresponding to the experimental data. Three numbers characterizing the viscoelasticity of polyethylene, which must be related with three molecular characteristics, are established.Institute of Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga. Translated from Mekhanika Polimerov, No. 3, pp. 523–532, May–June, 1975.