New chiral phosphine-phosphite ligands in the enantioselective palladium-catalyzed allylic alkylation

A series of chiral phosphine-phosphite ligands 1-6 have been synthesized and used in the enantioselective palladium-catalyzed reaction of rac-1,3-diphenyl-2-propenyl acetate with dimethyl malonate as nucleophile. Ligands 1a, 2, 3, 5a, 6a, and 6b have been synthesized starting from racemic tert-butylphenylphosphinoborane. The use of dynamically resolved Li phosphide (-)-sparteine provided the optically pure ligands. Crystals of the allylpalladium (6a) complex were obtained, suitable for X-ray crystal structure determination. The X-ray crystal structure of the allylpalladium (6a) complex revealed a longer palladium-carbon bond distance trans to the phosphine moiety indicating that the attack of the nucleophile takes place at the carbon trans to the phosphine moiety. This was confirmed by the fact that the phosphine moiety did not affect the enantioselectivity directly. Under mild reaction conditions, enantioselectivities up to 83% were obtained (25 degrees C) with ligand 1e. Systematic variation of the ligand bridge and the phosphite moiety showed that the configuration of the product is controlled by the atropisomerism of the biphenyl substituent at the phosphite moiety. The conformation of the biphenyl group, in turn, is controlled by the substituent at the chiral carbon in the bridge. Ligands with large bite angles yielded higher enantioselectivities.     

Stereoselective Rh-catalyzed hydrogenation of cyclobutyl chiral enamides: double stereodifferentiation vs catalyst-controlled diastereoselection

The hydrogenation reactions of several cyclobutyl enamides derived from (-)-alpha-pinene or (-)-verbenone have been investigated by using different catalysts. The chiralities of both the substrate and the catalyst as well as the Z/E stereochemistry of the double bond have been considered, and the observed diastereoselectivity has been rationalized. For enamides with the double bond separated from the cyclobutane by a methylene, the Wilkinson catalyst did not induce any diastereoselection, but excellent diastereoselectivity was observed when using Et-DuPHOS-Rh and ChiraPHOS-Rh. The configuration of the new stereogenic center was catalyst-dependent and can be rationalized according to the Halpern mechanism. For (Z)-enamides with the double bond directly linked to the cyclobutane ring, the chirality of the substrate governed the diastereoselection and the Halpern mechanism seemed not to be operative in the hydrogenation with ChiraPHOS, with the configuration of the new stereogenic center being determined by steric effects. On the contrary, the chirality of the catalyst was the factor determining the stereochemistry of the major products with alkyl-DuPHOS-Rh. Z/E stereochemistry influenced the stereodifferentiation, and a different behavior for each Z or E stereoisomer was found. For both (Z)- and (E)-enamides, some instances of match/mismatch between the chirality of the substrate and that of the catalyst were observed. As a result of all of these studies, a series of new cyclobutyl alpha-amino acids has been synthesized. These products are interesting to incorporate into conformationally constrained peptides.     

Intercalation of Benzamide into Kaolinite

Well-crystallized kaolinite (K) was initially reacted at 60 degrees C with a water/dimethylsulfoxide (DMSO) mixture and the resulting intercalation derivative (K-DMSO) was characterized by powder X-ray diffractometry (PXRD), thermal analysis (simultaneous TG and DSC), and Fourier-transformed infrared spectroscopy (FTIR). Benzamide crystals were then melted with the K-DMSO derivative at 140 degrees C for 4 days, when a gradual displacement of DMSO by benzamide was observed within the interlayer spacing of the modified kaolinite. The resulting material, after extensive washing with acetone, was characterized and compared to the results obtained previously for the K-DMSO composite. Benzamide intercalation proceeded by gradual displacement of DMSO molecules until completion. The structural stabilization of the K-BZ derivative was explained through the establishment of hydrogen bonds between the carbonyl oxygen atoms of the intercalated benzamide and aluminol groups present at the surface of the kaolinite layer. The interlamellar spacing of K-BZ was shown to be possibly occupied by benzamide molecules that were located at a 68 degrees orientation in relation to the layer surface. Unlike most intercalation molecules such as DMSO, variations in the interplanar spacing of kaolinite were consistent with the nonkeying of any other part of the molecule between the aluminosilicate interlayers. Copyright 2000 Academic Press.     

Monitoring multi-class pesticide residues in fresh fruits and vegetables by liquid chromatography with tandem mass spectrometry

A new analytical method was developed using liquid chromatography with tandem mass spectrometry for the routine analysis of 31 multi-class pesticide residues and applied to approximately 50 fresh fruit and vegetable samples (green bean, cucumber, pepper, tomato, eggplant, watermelon, melon and zucchini). Extraction of the pesticides with ethyl acetate was carried out. The optimal ionisation conditions were selected for each pesticide in the same run. The procedure was validated and the values of some merit figures, such as recovery, precision, linear range, detection limit and quantification limit for each pesticide were calculated together with its calculated expanded uncertainty (U). The average recoveries in cucumber obtained for each pesticide ranged between 74 and 105% at two different fortification levels (n = 10 each) that ranged between 9 and 250 ng g(-1) (depending on the pesticide). The uncertainty associated to the analytical method was lower than 23% for all compounds tested. The calculated limits of detection and quantitation were typically <1 ng g(-1) that were much lower than the maximum residue levels established by European legislation.     

Direct versus resonances mediated F+OH collisions on a new 3A" potential energy surface

A theoretical study of the F(2P) + OH(2Pi) --> HF(1Sigma+) + O(3P) reactive collisions is carried out on a new global potential energy surface (PES) of the ground 3A" adiabatic electronic state. The ab initio calculations are based on multireference configuration interaction calculations, using the aug-cc-pVTZ extended basis sets of Dunning et al. A functional representation of the PES shows no nominal barrier to reaction, contrary to previous results by others. Wave packet and quasiclassical trajectory calculations have been performed for this PES to study the F + OH(v = 0,j) reactive collision. The comparison was performed at fixed and constant values of the total angular momentum from 0 to 110 and relative translational energy up to 0.8 eV. The reaction presents a dynamical barrier, essentially due to the zero-point energy for the bending vibration near the saddle point. This determines two different reaction mechanisms. At energies higher than approximately 0.125 eV the reaction is direct, while below that value it is indirect and mediated by heavy-light-heavy resonances. Such resonances, also found in the simulations of the photodetachment spectrum of the triatomic anion, manifest themselves in the quasiclassical simulations, too, where they are associated to periodic orbits.     

Aqueous mercury adsorption in a fixed bed column of thiol functionalized mesoporous silica

The aim of this work was to investigate the aqueous mercury adsorption in a fixed bed of mesostructured silica SBA-15 functionalized with propylthiol by co-condensation (SBA-15-SH). Powdered synthesized adsorbents were used to prepare pellets with sizes ranging from 0.5 to 1 mm. The physicochemical properties determined from N₂ adsorption and chemical analysis were compared for powder and pellets. Batch static experiments were carried out to obtain the equilibrium mercury adsorption isotherms, resulting that although the maximum adsorption capacity was reduced from powder to pellets, the materials maintained high efficiency for mercury removal even at very low aqueous metal concentration. Dynamic experiments were carried out in a fixed bed column by modifying the volumetric flow rate, bed length, inlet concentration, and amount of propylthiol groups incorporated to the adsorbent, and analyzing the temporal scale and the mercury adsorption capacities. The elution of the fixed bed was carried out chemically by circulating an aqueous 2 M hydrobromic acid stream for 2 h so achieving a complete recovery of the mercury previously adsorbed. Simplified dynamic equations of Bohart–Adams and Wolborska were used for modeling the breakthrough curves.     

Formation and accumulation of contact deficiencies in a tunnel segmented lining

Damages observed in tunnels constructed with tunnel boring machines affect the overall quality of the structure and the efficiency of the construction process. Most of these damages are caused by contact deficiencies between segments that are generated by the sum of several tolerances on the shape and on the placement of the lining. Moreover, the imperfection of one ring affects the placement of the following ones, inducing an accumulation mechanism that magnifies the imperfection expected due to the sum of tolerances in a single isolated ring. The overall consideration of these phenomena yields an intricate analysis that must take into account some important probabilistic aspects. This paper explains how the tolerances may evolve into the contact deficiencies found in practice. Initially the types of tolerances and contact deficiencies more likely to affect the structural behavior of the lining are analyzed. A mathematical model is proposed to explain the relation between tolerances and contact deficiencies. The predictions obtained with the model are then compared with the measurements performed in the tunnel of Line 9 in Barcelona. The results obtained reinforce the importance of the model proposed in this study, which quantifies aspects that so far could only be studied qualitatively or on a trial and error basis.     

ac-Driven double quantum dots as spin pumps and spin filters

We propose and analyze a new scheme of realizing both spin filtering and spin pumping by using ac-driven double quantum dots in the Coulomb blockade regime. By calculating the current through the system in the sequential tunneling regime, we demonstrate that the spin polarization of the current can be controlled by tuning the parameters (amplitude and frequency) of the ac field. We also discuss spin relaxation and decoherence effects in the pumped current.     

Current fluctuation spectrum in dissipative solid-state qubits

We present a formalism to calculate frequency dependent electron current noise for transport through two-level systems (such as coupled quantum dots or Cooper-pair boxes) in presence of dissipation. Perturbation theories in various regimes are formulated within a matrix scheme in Laplace scheme which we evaluate in detail both for weak and strong coupling to a bosonic environment.Received: 12 December 2003, Published online: 10 August 2004PACS: 72.70. + m Noise processes and phenomena - 73.23.Hk Coulomb blockade; single-electron tunneling     

Phase transitions and theta vacuum energy

The analytic behaviour of θ-vacuum energy is related to the existence of phase transitions in QCD and ℂP ^N sigma models. The absence of singularities different from Lee-Yang zeros only permits ∧ cusp singularities in the vacuum energy density and never ∨ cusps. This fact, together with the Vafa-Witten diamagnetic inequality, provides a key missing link in the Vafa-Witten proof of parity symmetry conservation in vector-like gauge theories and ℂP ^N sigma models. However, this property does not exclude the existence of a first phase transition at θ = π or a second order phase transition at θ = 0, which might be very relevant for interpretation of the anomalous behaviour of the topological susceptibility in the ℂP¹ sigma model.