一类非线性发展方程的精确解

利用hirota双线性法,得到(3+1)维孤子方程、(3+1)维KP-Boussinesq方程、(2+1)维修正Caudrey-Dodd-Gibbon-Kotera-S awada方程、Hirota-Satsuma浅水波方程的精确解,并做出一部分解的图形,进一步研究解的结构和性质.     

MCNOs/CdS双效光催化剂的制备及其性能研究

水热合成法制备了不同磁性纳米洋葱碳(MCNOs)负载量(0%、1%、3%、5%)的MCNOs/CdS光催化剂。并通过X射线衍射分析(XRD)、扫描电子显微镜(SEM)、傅里叶红外光谱(FT-IR)、X射线光电子能谱(XPS)、紫外可见光光谱(UV-Vis)、磁滞回线测定仪(VSM)对其进行表征,探究了MCNOs负载比例对催化剂在可见光下降解RhB性能及机理的影响。结果表明,MCNOs能有效提高CdS的光催化效果,复合3%MCNOs后降解率为96%,与纯CdS相比降解率提高了30%,磁性分析表明,其具有良好的顺磁性并能实现催化剂的有效回收。MCNOs/CdS在可见光下催化降解RhB的一级反应动力学直线有较好的拟合度,表明制备的催化剂有较好的催化活性。     

密度泛函理论方法研究填料表面对聚合物摩擦化学的影响

采用超声分散法制备出氧化铝、高岭土、氧化硅/聚四氟乙烯复合材料, 使用线性往复摩擦磨损试验机对比三种复合材料的摩擦学性能. 结果表明 质量分数10%的氧化铝、高岭土能将聚四氟乙烯的磨损率降低约4个数量级, 而氧化硅仅能降低约3个数量级. 对金属对偶表面形成的转移膜的形貌和化学成分进行分析发现 氧化铝、高岭土/聚四氟乙烯在金属对偶面上形成了高度羧酸盐化的转移膜. 用密度泛函理论对三种填料表面上碳氟分子吸附过程进行模拟, 结果显示氧化铝、高岭土表面的路易斯酸性位点促进了碳氟分子的脱氟过程, 产生了更多的羧酸螯合物的中间产物; 氧化硅缺少路易斯酸性位点, 因此不能促进高度羧酸盐化的转移膜形成.     

Sonochemical conversion of CO2 into hydrocarbons: The Sabatier reaction at ambient conditions

In this study, we investigated an alternative method for the chemical CO₂ reduction reaction in which power ultrasound (488 kHz ultrasonic plate transducer) was applied to CO₂-saturated (up to 3%) pure water, NaCl and synthetic seawater solutions. Under ultrasonic conditions, the converted CO₂ products were found to be mainly CH₄, C₂H₄ and C₂H₆ including large amount of CO which was subsequently converted into CH₄. We have found that introducing molecular H₂ plays a crucial role in the CO₂ conversion process and that increasing hydrogen concentration increased the yields of hydrocarbons. However, it was observed that at higher hydrogen concentrations, the overall conversion decreased since hydrogen, a diatomic gas, is known to decrease cavitational activity in liquids. It was also found that 1.0 M NaCl solutions saturated with 2% CO₂ + 98% H₂ led to maximum hydrocarbon yields (close to 5%) and increasing the salt concentrations further decreased the yield of hydrocarbons due to the combined physical and chemical effects of ultrasound. It was shown that CO₂ present in a synthetic industrial flue gas (86.74% N₂, 13% CO₂, 0.2% O₂ and 600 ppm of CO) could be converted into hydrocarbons through this method by diluting the flue gas with hydrogen. Moreover, it was observed that in addition to pure water, synthetic seawater can also be used as an ultrasonicating media for the sonochemical process where the presence of NaCl improves the yields of hydrocarbons by ca. 40%. We have also shown that by using low frequency high-power ultrasound in the absence of catalysts, it is possible to carry out the conversion process at ambient conditions i.e., at room temperature and pressure. We are postulating that each cavitation bubble formed during ultrasonication act as a “micro-reactor” where the so-called Sabatier reaction -$C{O}_2+4H_2\stackrel{\mathit{Ultrasonication}}{\to }C{H}_4+2H_{2}O$ - takes place upon collapse of the bubble. We are naming this novel approach as the “Islam-Pollet-Hihn process”.     

基于XPS对硫铁矿去除SeO2-3的机理研究

硒是动植物及人体生长必需的十五种微量元素之一，具有清除体内自由基、抗氧化、增强免疫力等功能，但其安全剂量的范围却很窄。利用扫描电子显微镜（SEM）和X射线衍射仪（XRD）对湿法球磨制备的硫铁矿形貌进行了表征。SEM观测发现加乙醇助磨后的硫铁矿为粒径大小较均匀的球形颗粒团聚体，粒径范围在17～200 nm之间，平均粒径138 nm。XRD衍射图谱中的特征峰与FeS₂衍射图谱中各峰位置基本一致，因此判定硫铁矿中主要化学组分为FeS₂，且图谱中基本没有杂峰，表明制备过程中并未混入杂质，样品纯度较高。实验结果表明，该法制备的硫铁矿具有颗粒粒径小、比表面积大、反应活性高等优点。研究中利用X射线光电子能谱仪（XPS）对硫铁矿去除水体中SeO2-₃的机理进行了研究。研究结果表明, （1）在较为广泛的实验pH范围（pH 2.2～11.5），硫铁矿均能有效去除水体中SeO2-₃，去除效率（除pH值7.8以外）均达到90%以上；（2）硫铁矿与SeO2-₃发生反应后，其主要组成元素的XPS特征峰结合能有所减小，表明硫铁矿表面发生了一定化学变化；（3）酸碱环境下硫铁矿去除SeO2-₃的机理不完全相同，酸性环境下，硫铁矿对SeO2-₃的去除是单纯的氧化还原过程，即硫铁矿中被酸活化的S2-₂将SeO2-₃还原为单质Se(0)，并且酸性越强，SeO2-₃去除效果越好；碱性环境下，SeO2-₃的去除过程中氧化还原与络合反应并存，硫铁矿表面有络合态Fe(OH)SeO₃和单质Se(0)两种存在形态，且碱性越强，络合态Fe(OH)SeO₃含量越高。以上研究结果为硫铁矿去除固定水体和土壤中以SeO2-₃为代表的可变价金属阴离子提供重要理论依据和应用基础。     

High-efficient surface tailoring via reverse atom transfer radical polymerization and reversible addition-fragmentation chain-transfer polymerization in an aqueous system initiated by a monocenter redox pair

The commonly used multi-center initiation methods always lead to the formation of quantities of homopolymer in the surface tailoring based on reverse atom transfer radical polymerization (ATRP) and reversible addition-fragmentation chain-transfer (RAFT) polymerization. In this study, a monocenter redox pair constructed of silica bearing tert-butyl hydroperoxide groups and ascorbic acid (SiO₂-TBHP/AsAc) was applied to substitute the commonly used initiation method of R-supported RAFT grafting polymerization. All the propagating radicals were restricted on the surface of solid particles during the whole procedure theoretically, resulting in a higher grafting efficiency of 95.1% combined with the “controllable” feature at 10 h. This redox pair was also used to initiate the reverse ATRP in miniemulsion successfully with a grafting efficiency of 86.3% at 10 h. The grafting efficiency obtained under this monocenter initiation method was significantly higher than that of the frequently reported surface modification by reverse ATRP and RAFT polymerization. In addition, the high-efficient surface tailoring was traced and confirmed by nuclear magnetic resonance, Fourier transform infrared, X-ray photoelectron spectroscopy, thermogravimetric analysis, transmission electron microscopy, and other analysis tests. The advantage of this monocenter redox pair will open a new avenue for the potential “high-efficient” surface tailoring of various materials.     

Visible light-driven acridone catalysis for atom transfer radical polymerization

Acridone as a new kind of visible light photocatalyst has been developed to catalyze metal free atom transfer radical polymerization (ATRP). The photocatalyst possess low excited state potential as can undergo an oxidative quenching pathway to initiate ATRP of vinyl monomers. Kinetic study and light on/off reaction demonstrate the “living”/controlled nature of the polymerization by light. Block copolymers can be achieved by using PMMA as macroinitiator to reinitiate polymerization of other vinyl monomers, which shows highly preserved Br chain-end functionality in the synthesized polymers. Moreover, the polymerization can be conducted under air atmosphere as most photocatalysts need anaerobic condition, which may give inspiration of further application of this kind of photocatalyst.     

Monitoring the Thiol/Thiophenol Molecule-Modulated Plasmon-Mediated Silver Oxidation with Dark-Field Optical Microscopy

Surface plasmon can trigger or accelerate many photochemical reactions, especially useful in energy and environmental industries. Recently, molecular adsorption has proven effective in modulating plasmon-mediated photochemistry, however the realized chemical reactions are limited and the underlying mechanism is still unclear. Herein, by using in situ dark-field optical microscopy, the plasmon-mediated oxidative etching of silver nanoparticles (Ag NPs), a typical hot-hole-driven reaction, is monitored continuously and quantitatively. The presence of thiol or thiophenol molecules is found essential in the silver oxidation. In addition, the rate of silver oxidation is modulated by the choice of different thiol or thiophenol molecules. Compared with the molecules having electron donating groups, the ones having electron accepting groups accelerate the silver oxidation dramatically. The thiol/thiophenol modulation is attributed to the modulation of the charge separation between the Ag NPs and the adsorbed thiol or thiophenol molecules. This work demonstrates the great potential of molecular adsorption in modulating the plasmon-mediated photochemistry, which will pave a new way for developing highly efficient plasmonic photocatalysts.     

Current trends in the description of lanthanum strontium manganite oxygen electrode reaction mechanism in a high-temperature solid oxide cell

This review summarizes recent progress in understanding the oxygen reduction and evolution reactions at the lanthanum strontium manganite electrode of a high-temperature solid oxide cell. Information provided here is put into the perspective of the defect chemistry of lanthanum strontium manganite and its impact on the electrode reaction mechanisms itself. After summarizing recent views on the oxygen reduction reaction mechanism, the focus turns to the oxygen evolution reaction, which is significantly less treated in the literature. A combination of the information in the literature on both reactions was the basis for modified reaction mechanism of the oxygen evolution reaction to be proposed under consideration of recent experimental observations and theoretical findings.