生物电化学系统降解多环芳烃萘及微生物群落研究

采用单室空气阴极微生物燃料电池(MFC)反应器构型, 以不同浓度萘为基底物质, 考察MFC的产电性能、 萘降解率、 化学需氧量(COD)和总有机碳含量(TOC)降解率及MFC阴阳极微生物活性和多样性. 结果表明, 循环伏安曲线受不同浓度萘的影响变化较为明显, 随着萘浓度的增大, 最大功率密度呈下降趋势, 且萘对MFC的阴极电极电势影响较大; 当萘的浓度为15 mg/L时, MFC最大功率密度可达(645.841±28.08) mW/m ²; 对萘的降解率高达100%, 且MFC对COD和TOC的降解率随着萘浓度的提高而增大, 但是增大的速率逐渐减小. 对MFC阳极微生物膜进行高通量测序发现, Geobacter是优势菌属, 相对丰度达81%, 阴极主要以Aquamicrobium为主.     

Nd∶YVO4/Nd∶GdVO4双波长激光器的功率均衡实验研究

实验研究了Nd∶YVO4/Nd∶GdVO4双波长激光器在不同抽运功率条件下,通过调节热沉温度达到功率均衡时的输出特性.实验结果表明:对于Nd∶YVO4/Nd∶GdVO4双波长激光器,当提高抽运功率,需要重新降低热沉温度达到功率均衡输出,降温幅度与抽运功率增加之比为11.23℃/W.与此同时,随着抽运功率和热沉温度的变化,双波长激光器的中心波长会出现小幅度的漂移,左峰波长随抽运功率增加的蓝移速率为0.056 nm/W,右峰波长随抽运功率增加的蓝移速率为0.054 nm/W.实验还发现功率均衡条件下激光器的输出总功率随抽运功率的增加而增加,拟合斜效率为8.7%,当抽运功率为5.58 W时,输出最大总功率达到115.7 mW.     

Strongly localized states in a single carbon nanotube with polymer molecules

A single-walled carbon nanotube (SWCNT) with conjugated polymer molecules is analyzed via optical spectroscopy. The presence of strongly localized excitonic states in the SWCNT is confirmed using time-integrated photoluminescence (PL). The PL spectrum exhibits extremely narrow width (~0.8 meV) which is attributed to the strong confinement of the states by polymer molecules. In addition, I observed that the excited states are gradually filled as a function of the excitation power, which supports the localized excitonic behavior. Only the ground excitonic state is observed at low excitation powers, but three additional PL peaks appear as the excitation power is increased. Especially, the power-dependent PL spectrum shows a blueshift and increased width, which can be elucidated in terms of quantum confined stark effect and the screening of induced electric fields. Overall, I demonstrate that the presence of polymer molecules induces several localized states in a single SWCNT.     

Optimizing Membranes for Osmotic Power Generation

The design of ion-selective membranes is the key towards efficient reverse electrodialysis-based osmotic power conversion. The tradeoff between ion selectivity (output voltage) and ion permeability (output current) in existing porous membranes, however, limits the upgradation of power generation efficiency for practical applications. Thus, we provide the simple guidelines based on fundamentals of ion transport in nanofluidics for promoting osmotic power conversion. In addition, we discuss strategies for optimizing membrane performance through analysis of various material parameters in membrane design, such as pore size, surface charge, pore density, membrane thickness, ion pathway, pore order, and ionic diode effect. Lastly, a perspective on the future directions of membrane design to further maximize the efficiency of osmotic power conversion is outlined.     

退火处理提高P3HT:PCBM聚合物太阳能电池光伏性能

利用旋转涂膜方法制备了以P3HT:PCBM为有源层的聚合物太阳能电池, 器件结构为ITO/PEDOT:PSS/P3HT:PCBM/Al(氧化铟锡导电玻璃/聚二氧乙基噻吩:聚对苯乙烯磺酸/聚三已基噻酚:富勒烯衍生物/铝),研究了退火温度对聚合物太阳能电池性能的影响. 实验发现: 聚合物薄膜经过120 °C退火10 min处理后, 开路电压(V_oc)达到0.64 V, 短路电流密度(J_sc)为10.25 mA·cm^-2, 填充因子(FF) 38.1%, 光电转换效率(PCE)达到2.00%. 为了讨论其内在机制, 对不同退火条件下聚合物薄膜进行了各种表征. 从紫外-可见吸收光谱中发现, 退火处理使P3HT在可见光范围内吸收加强且吸收峰展宽, 特别是在560和610 nm处的吸收强度明显增大; X射线衍射(XRD)结果表明, 120 °C退火后P3HT在(100)晶面上的衍射强度是未退火薄膜的2.8倍, 有利于光生载流子的输运; 原子力显微镜(AFM)研究结果表明, 退火显著增大了P3HT与PCBM的相分离程度, 提高了激子解离的几率; 傅里叶变换红外(FTIR)光谱验证了退火并没有引起聚合物材料物性的变化.     

镁热还原CO2气体制备介孔石墨烯及其电容特性研究

以CO_2为原料,采用金属镁热还原法,制备出富含介孔结构的石墨烯材料。分别利用X射线衍射、扫描电镜、透射电镜、拉曼光谱和N_2吸附-脱附等测试手段对材料的微观结构进行了表征。通过在镁粉中加入不同质量的MgO,可以实现对石墨烯形貌和孔结构的调控,当MgO/Mg质量比为8∶1时,产物(MRG-8)具有均一的介孔结构(4nm)。并对材料的电化学性能进行了测试,在1mol/L KOH的电解液中,MRG-8具有最高的比电容(171F/g),同时具有非常好的倍率特性,循环测试12000周,比电容保持率为94%。当采用[EMIM][BF4]离子液体作为电解液,以MRG-8为电极材料组装成的对称型超级电容器显示出超高功率密度(175k W/kg),对应的能量密度为28.1Wh/kg。因此,采用此方法制备的介孔石墨烯材料在高功率的超级电容器领域具有潜在的应用前景。     

Synthesis,characterizations, and electrochemical studies of ZnO/reduced graphene oxide nanohybrids for supercapacitor application

Herein the present article reports the fabrication of ZnO/reduced graphene oxide (ZnG) nanohybrid following a reduction-based process using a non-hazardous material, i.e., ascorbic acid. The morphology, structure, and bonding in the nanohybrid were analyzed using different techniques. Atomic force microscopy and scanning electron microscopy images show spherical particles of ZnO distributed over reduced graphene oxide (rGO). The X-ray diffraction analysis gives calculated values of crystallite size for ZnO as 15.62 nm. The successful incorporation of ZnO nanoparticles into rGO was confirmed using energy-dispersive X-ray spectroscopy and X-ray photoelectron spectroscopy analyses. The electrochemical studies were performed using an electrolyte (0.5 M H₂SO₄). The calculated value of specific capacitance for the nanohybrid was 345 Fg^-1, which was found to be almost double as compared to that of rGO, which is having a value of only 190.5 Fg^-1 at the same scan rate. The nanohybrid also showed excellent capacitance retention after 1,000 cycles.     

应用于染料敏化太阳能电池的基于染料R6的含有不同吸电子基团的有机染料的理论研究

Dye-sensitized solar cells (DSSCs) are the most promising alternatives to traditional fossil energy because of their advantages of low production cost, facile structure, relatively low environmental impact, relatively high photoelectronic absorption efficiency, and overall high efficiency. In addition, several studies on sensitizers as vital components have been conducted over the last three decades. Compared to metal dyes, metal-free organic dyes have been considered as promising candidates because of their simple fabrication, multiple structures, high molar absorption coefficients, easily tunable properties, and environmental friendliness. In this study, we systematically investigated the optoelectronic properties of six metal-free organic donor-acceptor dyes (RD1–6) derived from the known dye R6 by using the density functional theory (DFT) and time-dependent DFT methods. Cell performance parameters were discussed, including the geometrical and electronic structures, absorption spectrum, adsorption energy, light harvesting efficiency (LHE) curve, predictive short circuit current density (J_sc^Pred.), predictive open circuit voltage (V_oc^Pred.), and theoretical power conversion efficiency (PCE). Results revealed that all the designed dyes exhibited high theoretical PCE. In particular, dyes RD1, 2, and 4–6 showed greater conjugations, and dyes RD1–3 had smaller energy gaps than those of the reference dye. In addition, dyes RD1–3, 5, and 6 exhibited better light harvesting capacities that covered the entire visible region and extended to the near-infrared region with obviously red-shift maximum absorption wavelengths (λ_max), wider LHE curves, and higher J_sc^Pred. as compared to the reference dye. It was critical that dyes RD1 and 2 not only have greater conjugations and narrow band gaps but also good light harvesting capacities with more than 56-nm red-shift maximum absorption wavelengths and broadened LHE curves than those of the reference dye. Notably, mainly because of an average increment of 12.0% of J_sc^Pred., a remarkable increment of the theoretical power conversion efficiency was observed from 12.6% for dye R6 to 14.1% for dyes RD1 and 2. Thus, dyes RD1 and 2 exhibited superior cell performances and could be promising sensitizer candidates for highly efficient DSSCs. These results could be used to guide effective synthetic efforts in the discovery of efficient metal-free organic dye sensitizers in DSSCs.     

A phenomenological model of electrorheological fluids

The fundamental assumption of the paper is that the extra stress tensor of an electrorheological fluid is an isotropic tensor valued function of the rate of strain tensor D and the vector n (which characterizes the orientation and length N of the fibers formed by application of an electric field). The resulting constitutive equation for is supplemented by the solution of the previously studied time evolution equation for n. Plastic behavior for the shear and normal stresses is predicted. Anticipating that the action of increasing shear rate is i) to orient the fibers more and more in the direction of flow and ii) simultaneously to break up the fibers leads to the conclusion that for the same behavior is encountered as without an electric field. Using realistically possible approximation formulas for the dependence of and N on leads to the Bingham behavior for and power law behavior for large shear rates.

Propagation of converging and diverging shock waves under isothermal condition

In this article the flows of perfect gas behind converging and diverging strong shock waves under isothermal condition in the cases of spherical and cylindrical symmetry are examined. A diverging shock wave is formed by energy supply according to a power law. These waves propagate in a uniform medium at rest and all conservation laws hold at the fronts of these shock waves. It was established that in the case of converging waves for any value of the ratios of specific heats the solution of the problem under consideration exists and is unique. When the problem has more than one solution. In the case of diverging shock waves the solution exists and is unique for any from the interval and any value of power in the energy input law. Received 4 August 1996 / Accepted 28 May 1996