Synthesis and crystal structures of novel glycoluril carboxylic acids conglomerates

The two novel conglomerates were obtained by crystallization of racemic (2'S,3aS,6aR)/(2'R,3aR,6aS) (glycoluril-1-yl)-3-methylbutanoic acid and (2'R,3aR,6aR)/(2'S,3aS,6aS) (4,6-dimethylglycoluril-1-yl)pentanoic acid synthesized by highly diastereoselective condensation of 4,5-dihydroxy- imidazolidin-2-ones with racemic ureido acids. The differences in the molecular geometry of synthesized racemates were studied by X-ray diffraction that showed them to crystallize as conglomerates in non-centrosymmetric space groups Pna2₁ and P2₁2₁2₁, respectively     

Aqueous-processed insulating polymer/nanocrystal solar cells with effective suppression of the leakage current and carrier recombination

As one of the most environmentally friendly photovoltaic(PV) conversion equipments,aqueousprocessed CdTe nanocrystal solar cells(NC SCs) have attracted great interest in recent years because of their excellent properties such as high charge-carrier mobility and broad absorption.However,two issues including interfacial recombination and leakage current seriously restrict their performance.In this paper,insulating polymer poly(vinyl pyrrolidone)(PVP) is introduced into CdTe NC SCs to solve the problems.The experimental results of transmission electron microscopy(TEM),atomic force micro scopy(AFM) and dark current measurements,etc.,demonstrate the leakage current is effectively suppressed by introducing PVP.Through further designing device structure,the reduction of interfacial recombination after introducing PVP is confirmed.By strategically taking the advantages of PVP properties(e.g.,water solubility and thermostability),the power conversion efficiency of the devices with PVP is enhanced by almost 37% compared to pure CdTe devices.This work demonstrates an effective and low-cost method to fabricate NC SCs via aqueous route.Moreover,it also proves that appropriate content of insulating polymer is of beneficial in promoting the PV performance.     

聚苯硫醚熔体的压致凝固行为

采用施加压力的方法将聚苯硫醚熔体凝固,凝固后获得的聚苯硫醚样品经过降温和卸压后在常温常压下回收. X射线衍射和差示扫描量热分析表明:约20 ms时间的快速压缩过程可以抑制熔体结晶,制备出非晶态聚苯硫醚块材,样品的表面及中心都是非晶态.非晶态聚苯硫醚的玻璃化转变温度和晶化温度分别为318和362 K.常压下的退火实验表明,非晶态聚苯硫醚在425 K等温结晶的产物为正交相晶型.压致凝固法中熔体的凝固不是靠温度变化,而是靠压力变化,样品表面和内部处在一致的温度下同时受压凝固,避免了热传导对非晶尺寸的影响,因此非常有利于获得结构均匀的大尺寸非晶态材料.     

Statistics of polymer capture by a nanopore: A Brownian dynamics simulation study

We investigate the statistics of polymer capture by a nanopore using Brownian dynamics simulations. It is found that when the velocity flux is greater than a critical velocity flux, the capture picture is a random selection process, otherwise it tends to a statistical process governed by energetic considerations. In addition, the chain ends capture probability decreases as the chain length increases and satisfies a power-law scaling of P0(N)~N-0.8.     

A modern approach to the solution and analysis of the Simha-Somcynsky model for the description of pressure-volume-temperature properties of polymer fluids

We revisit the Simha-Somcynsky model of polymer fluids with the purpose of developing novel theoretical and computational approaches to simplify and speed up its solution as well as the fitting of experimental data, and decrease its level of mathematical complexity. We report a novel method that allows us to solve one of the two equations of the model exactly, thus putting the level of mathematical difficulty on a par with the one of other models for polymer fluids. Moreover, we describe a computational algorithm capable of fitting all five parameters of the model in an unbiased way. The results obtained reproduce literature results and fit experimental pressure-volume-temperature and solubility parameter data for three polymers very accurately. Moreover, the new techniques allow for the investigation of the model at very low temperatures. Unexpectedly, the model predicts behaviors that could be interpreted as a glass transition, as routinely observed in dilatometry and differential scanning calorimetry, and a glass phase. We compared the predicted and experimental T g’s for cis poly(1,4-butadiene) and found an excellent quantitative agreement.     

Strongly localized states in a single carbon nanotube with polymer molecules

A single-walled carbon nanotube (SWCNT) with conjugated polymer molecules is analyzed via optical spectroscopy. The presence of strongly localized excitonic states in the SWCNT is confirmed using time-integrated photoluminescence (PL). The PL spectrum exhibits extremely narrow width (~0.8 meV) which is attributed to the strong confinement of the states by polymer molecules. In addition, I observed that the excited states are gradually filled as a function of the excitation power, which supports the localized excitonic behavior. Only the ground excitonic state is observed at low excitation powers, but three additional PL peaks appear as the excitation power is increased. Especially, the power-dependent PL spectrum shows a blueshift and increased width, which can be elucidated in terms of quantum confined stark effect and the screening of induced electric fields. Overall, I demonstrate that the presence of polymer molecules induces several localized states in a single SWCNT.     

TDPAC and first-principles study of electronic and structural properties of a Pd-vacancy complex in undoped germanium

Pd is one of the metals suitable for inducing low-temperature crystallization in Ge. However, it is not clear how residual Pd atoms are integrated into the Ge lattice. Therefore, time-differential γ–γ perturbed angular correlations (TDPAC) technique using the ¹⁰⁰Pd(→¹⁰⁰Rh) nuclear probe produced by recoil implantation has been applied to study the hyperfine interactions of this probe in single-crystalline undoped Ge. A Pd-vacancy complex aligned along the <111> crystallographic direction with a unique interaction frequency of 8.4(5) Mrad/s has been identified. This complex was measured to have a maximum relative fraction of about 76(4)% following annealing at 350 ^°C. Further annealing at higher temperatures reduced this fraction, possibly via dissociation of the complex. Calculations suggest dissociation energy of 1.94(5) eV for the complex. DFT calculations performed in this work are in reasonable good agreement with the experimental values for the electric-field gradient of the defect complex in Ge and Si for comparison. The calculations predict a split-vacancy configuration with the Pd on a bond-centred interstitial site having a nearest-neighbour semi-vacancy on both sides (V-Pd_BI-V) in Ge and Si.     

Effects of top confinement and diluents on morphology in crystallization of poly(l‐lactic acid) interacting with poly(ethylene oxide)

Effects of top confinement and diluent poly(ethylene oxide) (PEO) on poly(l ‐lactic acid) (PLLA) crystal morphology have been investigated. When crystallized at 120 °C, uncovered neat PLLA sample exhibits higher growth rate ringless spherulites; while the covered sample exhibits lower growth rate ring‐banded spherulites. As PEO is introduced into PLLA, the morphology also undergoes significant changes. For the same T_c,PLLA = 120 °C, the PEO/PLLA blend with PEO composition greater than 25% exhibits ring‐banded patterns even in uncovered sample. However, in much greater PEO composition (>80 wt %), uncovered samples exhibit ring bands diverging into dendritic patterns, while top covered samples tend to maintain the spiral ring‐band patterns. Both PEO inclusion in PLLA and top cover on films impose growth kinetic alterations. Additionally, the top glass cover tends to prevent the lower surface tension PLLA to be accumulated on the surface, resulting in the formation of ring‐band pattern. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 1160–1170     

H2SO4-H2O中硝酸铜对脱硫石膏晶须生长的影响

以处理后的脱硫石膏为原料,在H₂SO₄-H₂O体系中以Cu(NO₃)₂为晶形控制剂采用水热法制备脱硫石膏晶须,探讨了Cu(NO₃)₂对脱硫石膏晶须生长的影响机理。结果表明:Cu(NO₃)₂对脱硫石膏有明显促溶作用,其中Cu²⁺可减小溶液中各离子的活度系数,使溶液中的Ca²⁺浓度增大。NO^-₃通过静电作用在Ca²⁺周围聚集并对SO^2-₄产生屏蔽作用,导致脱硫石膏继续溶解并使Ca²⁺和SO^2-₄的浓度处于相对稳定状态,有利于半水脱硫石膏晶体的形核与生长。此外,Cu²⁺还可在晶须的生长过程中选择性吸附在晶须表面,生成CuSO₄,促进了脱硫石膏的结晶生长,最终在Cu(NO₃)₂用量为2.0%(质量分数)时制备的脱硫石膏晶须长径比约为73。     

Investigating the kinetics of liquid-free,OSDA-free ZSM-5 zeolite synthesis from iron ore tailings

In this study, ZSM-5, which is a Mobil-type five-type zeolite with well-defined crystal morphology, is successfully synthesized via a seed-assisted, liquid-free method that uses iron ore tailings as a silica source. The ZSM-5 crystallization kinetics at 423, 433, and 443 K and different synthesis times are investigated to identify the nucleation and crystallization mechanisms of the synthesized ZSM-5 zeolites, and results suggest that the crystallization kinetics follow a Kolmogorov-Johnson-Mehl-Avrami-type behavior. The activation energies for the induction and transition periods are 112.38 and 58.35 kJ mol⁻¹, respectively. Furthermore, the Avrami exponent indicates three-dimensional crystal growth from both sporadic and instantaneous nucleation mechanisms. A comparison of our results with previous reports of the ZSM-5 crystallization mechanism demonstrates that the seed crystals play a significant role in nucleation and crystal growth. Finally, seed surface crystallization and new nuclei crystallization dual mechanism has been proposed to describe the crystallization process of ZSM-5.