Elongating the area of plasma/fluid interaction of surface nanosecond pulsed discharges

Plasma-assisted flow control is of high industrial interest, but practical applications at full scale require a large surface of interaction. Nanosecond pulsed Dielectric Barrier Discharge (DBD) have demonstrated promising results of flow control, but their interacting region is limited to only a few cm². In this paper, the conditions to extend a surface nanosecond DBD are documented. It is shown that a sliding discharge regime can fully fill an inter-electrode distance of 40 mm. This discharge regime promotes the formation of two hemispheric pressure waves originating from both air-exposed electrodes while an horizontal region of pressure gradient is also observed.     

托卡马克工程试验混合堆等离子体性能的等值线图分析

本文简要叙述托卡马克工程试验混合堆等离子体概念设计的物理基础,对等离子体性能进行了等值线图(Plasma Operation Contour)分析。根据工程试验混合堆的要求,得出一组等离子体参数。     

Magnetic properties of oxygenated carbon nitride films from RF-discharge in an acetylene, nitrogen, and oxygen mixture environments

Properties of oxygenated carbon nitride films have attracted the attention of physics researchers due to their magnetic and physical properties, as well as for their usefulness in the industry. The free radicals were investigated using electron paramagnetic resonance applied in the study of spin concentration due to the different mechanism of preparation of carbon nitride films by RF-discharge with different kinds of plasma. Unpaired spin concentrations, in the order of 10²⁰ per cm³, were measured and their time recombination dependency was important in those films. The films were grown by plasma enhanced chemical vapor deposition using mixtures of hydrocarbons, N₂ and O₂ in different proportions.     

HL-1M边缘等离子体静电湍流扰动

对HL－1M边缘等离子体静电湍流扰动进行了初步的实验研究。获得了扰动的基本特征量，估计了低杂波引起的径向粒子流的变化。在加低杂波（2．45GHz)前、后，电子密度扰动和极向电场扰动的幅度及其关联性变化不大。虽然低杂波部分抑制了静电湍流，但在数量上不能解释粒子约束改善的实验结果。     

Mössbauer and X-ray diffraction characterization of Fe60Al40 coatings prepared by thermal spraying

Microstructured (atomized) and nanostructured (milled) Fe₆₀Al₄₀ powders together with their corresponding coatings synthesized by High Velocity Oxy-fuel (HVOF) or Atmospheric Plasma Spray (APS) thermal spraying techniques have been characterized by Mössbauer Spectroscopy (MS) and X-ray Diffraction (XRD). The evolution of the microstructure and the atomic ordering degree in the powders and coatings are discussed at the light of the various processing conditions. The operational correlation between the parameters of the duplex morphology of coatings and the processing parameters is discussed.     

低温等离子体对塑料表面处理——低温等离子体对高密度聚乙烯表面处理的ESR研究

本文研究了不同处理条件(处理功率、处理时间和处理压力)下等离子体气体(Ar、N₂、O₂和空气等)对高密度聚乙烯表面处理产生的自由基的ESR谱。我们观察到等离子体处理产生的自由基是相当稳定的,它的ESR信号强度随处理功率和处理时间增加而增加。但处理压力对它影响不大。我们证明了紫外线对高密度聚乙烯表面产生自由基作用随处理条件而变化。并初步解释了谱的超精细相互作用。     

Effect of plasma treatment on interface property of BCN/GaN structure

Interface properties of BCN/GaN metal-insulator-semiconductor (MIS) structures are investigated by X-ray photoelectron spectroscopy (XPS) and capacitance versus voltage (C-V) characteristics measurements. The BCN/GaN samples are fabricated by in situ process consisting of plasma treatment and deposition of BCN film in the plasma-assisted chemical vapor deposition (PACVD) apparatus. XPS measurement shows that the oxide formation at the BCN/GaN interface is suppressed by nitrogen (N₂) and hydrogen (H₂) plasma treatment. The interface state density is estimated from C-V characteristics measured at 1 MHz using Terman method. The minimum interface state density appears from 0.2 to 0.7 eV below the conduction band edge of GaN. The minimum value of the interface state density is estimated to be 3.0 × 10¹⁰ eV⁻¹ cm⁻² for the BCN/GaN structure with mixed N₂ and H₂ plasma treatment for 25 min. Even after annealing at 430 °C for 10 min, the interface state density as low as 6.0 × 10¹⁰ eV⁻¹ cm⁻² is maintained.     

Analysis of Antennas with PBG Substrate

The use of photonic materials has been used in the theory of optical waves. The PBG (Photonic Band Gap) theory and material, was developed recently for optical frequencies and can be easily applied to millimeter waves, microwaves and planar antenna frequencies. The presence of photonic materials as substrate in antennas has some good characteristics such as, supression of light spontaneous emission and suppression of surface waves, allowing the application in planar antenna array. In this work an elaborate analysis using the full wave Transverse Transmission Line - TTL method, that provides efficient and concise results is applied to the planar antennas array with PBG substrate.     

On the hydrogen etching mechanism in plasma nitriding of metals

Iron alloys and aluminum were nitrogen implanted in a controlled oxygen atmosphere and the role of hydrogen on the surface etching mechanisms studied. The surface composition was analyzed by in situ photoemission electron spectroscopy (XPS). In iron alloys, hydrogen strongly etches oxygen, improving nitrogen retention on the surface. On the other hand, hydrogen removes nitrogen from aluminum surfaces, with a deleterious effect on the nitriding effectiveness. The oxygen removal in iron alloys is associated with the catalytic effect of electrons in d-orbitals and the nitrogen removal in aluminum is associated with a steric effect.     

���ܶȵ�������ģ�������˲��������

用高密度等离子体模型可以计算出一整套输运参数,并且在很宽的等离子体温度和密度范围内有合理的精度,可广泛应用于Z箍缩等离子体、激光聚变和磁约束聚变等领域,并将这个模型计算出的各种输运参数拟合成了实用的公式。