HL-2M 初始等离子体放电阶段的辉光放电 清洗系统电极的设计与分析

针对 HL-2M 装置初始等离子体放电阶段所需的直流辉光放电清洗系统的电极进行了设计。对辉光 放电清洗系统在不同工况下的系统负载进行了分析和拟定，并确定了电极结构设计分析标准。根据系统电极的结 构特点并结合系统负载规范与分析标准，依据不同的失效模式对电极进行了失效分析。分析结果表明，此针对初 始等离子体放电的电极设计能可靠安全运行，满足设计需求。     

辉光放电质谱仪期间核查控制图在实验室质量控制中的应用

仪器设备的期间核查是实验室管理及实验室认证认可的一项基本要求,辉光放电质谱仪主要应用于高纯金属材料的分析,标样研制较为困难,使用高纯标准物质进行质量控制及期间核查的方法难以实现。对用液氮低温冷却离子源型的辉光放电质谱仪,使用纯钽片在进行日常仪器调试信号时得到的钨元素含量数据,用于绘制平均值-极差控制图作为实验室质量控制及期间核查的判定依据,以此评价仪器日常工作的性能状态,以保证检测结果的正确性和可靠性。     

微波瑞利散射法测定空气电火花激波等离子体射流的时变电子密度

大气压空气电火花激波等离子体射流的电子密度在亚微秒时间尺度上瞬变,其电子密度的测定很难.基于微波瑞利散射原理,本文测量了空气电火花冲击波流注放电等离子体射流的时变电子密度.实验结果表明:测量系统的标定参数A为1.04 × 105 V·Ω·m–2;空气流注放电等离子体射流的电子密度与等离子体射流的半径和长度有关,结合高速放电影像展示的等离子体射流的等效半径和等效长度,测定的电子密度在1020 m–3的量级,且随时间先快速增长至峰值再成指数衰减.此外,本文还探讨了等离子体射流的不同等效尺度对测定结果的影响;分析结果表明,采用时变等效半径和时变等效长度的计算结果最有效,且第1个快速波峰是由光电离的电离波导致的.     

Reduced-order modeling of three-dimensional unsteady partial cavity flows

An efficient reduced-order modeling to analyze three-dimensional unsteady partial cavity flows is proposed. The proposed approach is based on the boundary element method along with the potential flow assumption. To this end, a novel non-iterative method based on the flow eigenmodes of three-dimensional partial cavity flows is applied. Eigenanalysis and reduced-order modeling for unsteady flows over a three-dimensional hydrofoil with various sections are performed. The results obtained from the present analysis are compared with those reported in the literature to verify the strength of the proposed approach. In order to examine the performance of the introduced algorithm for unsteady cavitating flows, various simulations for several reduced frequencies, hydrofoil geometries and different cavitation numbers are also investigated. Comparison between the obtained results using the novel and conventional methods indicates that the present algorithm works very well with sufficient accuracy. Moreover, it is shown that the proposed method is computationally more efficient than the conventional ones for unsteady sheet cavitation analysis on three-dimensional hydrofoils.     

Elongating the area of plasma/fluid interaction of surface nanosecond pulsed discharges

Plasma-assisted flow control is of high industrial interest, but practical applications at full scale require a large surface of interaction. Nanosecond pulsed Dielectric Barrier Discharge (DBD) have demonstrated promising results of flow control, but their interacting region is limited to only a few cm². In this paper, the conditions to extend a surface nanosecond DBD are documented. It is shown that a sliding discharge regime can fully fill an inter-electrode distance of 40 mm. This discharge regime promotes the formation of two hemispheric pressure waves originating from both air-exposed electrodes while an horizontal region of pressure gradient is also observed.     

A Theoretical study on the charge and discharge states of Na-ion battery cathode material,Na1+xFePO4F

Na₂FePO₄F is a promising cathode material for a Na-ion battery because of its high electronic capacity and good cycle performance. In this work, first principle calculations combined with cluster expansion and the Monte Carlo method have been applied to analyze the charge and discharge processes of Na₂FePO₄F by examining the voltage curve and the phase diagram. As a result of the density functional theory calculation and experimental verification with structural analysis, we found that the most stable structure of Na_1.5FePO₄F has the P2₁/b11 space group, which has not been reported to date. The estimated voltage curve has two clear plateaus caused by the two-phase structure composed of P2₁/b11 Na_1.5FePO₄F and Pbcn Na₂FePO₄F or Na₁FePO₄F and separated along the c-axis direction. The phase diagram shows the stability of the phase-separated structure. Considering that Na₂FePO₄F has diffusion paths in the a- and c-axis directions, Na₂FePO₄F has both innerphase and interphase diffusion paths. We suggest that the stable two-phase structure and the diffusion paths to both the innerphase and interphases are a key for the very clear plateau. We challenge to simulate a nonequilibrium state at high rate discharge with high temperature by introducing a coordinate-dependent chemical potential. The simulation shows agreement with the experimental discharge curve on the disappearance of the two plateaus. © 2018 Wiley Periodicals, Inc.     

The maximum multiplicity of the largest k-th eigenvalue in a matrix whose graph is acyclic or unicyclic

Given a graph $G$ we are interested in studying the symmetric matrices associated to $G$ with a fixed number of negative eigenvalues. For this class of matrices we focus on the maximum possible nullity. For trees this parameter has already been studied and plenty of applications are known. In this work we derive a formula for the maximum nullity and completely describe its behavior as a function of the number of negative eigenvalues. In addition, we also carefully describe the matrices associated with trees that attain this maximum nullity. The analysis is then extended to the more general class of unicyclic graphs. Further our work is applied to re-describing all possible partial inertias associated with trees, and is employed to study an instance of the inverse eigenvalue problem for certain trees.