表面活性剂对部分水解聚丙烯酰胺溶液抗盐性的影响

通过实验研究了阴离子表面活性剂(SDS)、非离子表面活性剂(OP-10)、两性表面活性剂(C12BE)浓度及KCl浓度对部分水解聚丙烯酰胺(阴离子型,HPAM)水溶液黏度的影响规律,进而分析各因素对聚合物溶液抗盐性的影响。实验结果表明:当表面活性剂浓度低于临界缔合浓度CAC时,聚合物溶液黏度变化不大;高于CAC后,随着表面活性剂浓度增大,聚合物溶液黏度急剧增加;当表面活性剂浓度达到聚合物饱和浓度PSP时,聚合物溶液黏度达到最大值;再加入阴离子和两性表面活性剂,将导致黏度降低,而加入非离子表面活性剂不再改变聚合物溶液的黏度,无机盐KCl对聚合物溶液有双重作用,低浓度KCl促进聚合物溶液黏度升高,高浓度KCl则导致聚合物溶液黏度急剧降低后趋于稳定,在相同KCl浓度下,三种表面活性剂的抗盐能力表现为:SDSOP-10C12BE。     

三羟甲基苯酚与部分水解聚丙烯酰胺成胶机理研究

采用13C固体核磁共振技术、X-射线电子能谱及红外光谱技术对部分水解聚丙烯酰胺(HPAM)与三羟甲基苯酚交联前后的结构进行了表征,发现体系中生成仲胺基团的同时伯胺基团有所减少;进一步采用两种表征手段对一系列交联样品进行了测试,定量地计算了仲胺基团含量的增加和伯胺基团含量的减少,得到一致的结果;在此基础上提出了水溶性酚醛交联剂与HPAM的交联机理.     

Influence of HPAM on W/O emulsion separation properties

The present study reports on the influence of partially hydrolyzed polyacrylamide (HPAM) on essential w/o emulsion properties. The characterization has been undertaken with low field NMR to follow droplet sizes and distributions, sedimentation and coalescence kinetic, bench-scale electrocoalescence (E_crit) experiments to follow emulsion stability changes, and electrorheology to detect changes in the viscosity upon applying an external electric field. The result is that HPAM does not basically influence the droplet size distribution (DSD) and the stability level of the emulsions as can be expected of bulk polymers. However, there seems to be an interaction between added demulsifiers either through direct molecular interaction or via an interfacial complexation.     

Effect of Octadecanol on the Interfacial Dilational Properties of Surfactant/Polymer Systems

The effect of octadecanol on dilational properties of 4,5-diheptyl-2-propylbenzene sulfonate and partly hydrolyzed polyacrylamide at the decane-water interface has been examined by means of longitudinal method. The octadecanol plays different roles in influencing the structure of adsorbed layers at different bulk concentration. A small quantity of octadecanol may enhance the dilational modulus by forming densely packed mixed-adsorption layer with surfactant molecules through hydrophobic interaction, which leads to the increase of dilational modulus. However, due to the weakening of the “entanglement” among long alkyl chains in surfactant molecules by the intercalation of octadecanol, the superfluous addition of octadecanol could decrease the dilational modulus. In the case of polymer/octadecanol system, the addition of the polymer may enhance the dilational modulus due to the slow diffusion-exchange process of the polymer.     

流变学法研究部分水解聚丙烯酰胺/Cr(III)交联反应I.浓度的影响

采用流变学法系统地考察了部分水解聚丙烯酰胺（HPAM）/Cr(III)交联体系的 反应动力学。HPAM溶液的粘性模量G”大于弹性模量G’,且其数值随时间不发生变 化,体系为粘性溶液。而HPAM/Cr(III)体系的G’和G”的数值都随时间变化,G” 在反应开始阶段大于G’,当反应进行一段时间后,G’超过G”占据主要地位,体 系成为弹性体系。交联过程可分为三个阶段：第一上升阶段,平缓上升阶段和第二 上升阶段。利用G’～ t曲线可以推测反应机理。实验发现成胶速率随反应物HPAM 和Cr(III)的浓度的增加而增加,而成胶时间缩短。在羧基浓度过量的情况下,交 联反应对Cr(III)浓度的反应级数是1。凝胶的有效弹性交联密度随聚合物浓度的增 加而增,且随凝胶反应的进行而增加。凝胶的交联点间的平均分子量随Cr(III)浓 度的增加和交联反应的进行而下降。     

油田污水中聚丙烯酰胺(HPAM)的降解机理研究

随着聚合物驱油技术在我国油田的大面积推广,含聚丙烯酰胺污水的产量在逐年增加 .聚丙烯酰胺在为油田生产提高原油采收率的同时,也大幅度增加了混合液的粘度和乳化性 ,使油水分离难度加大,造成采出水含油量严重超标.含聚丙烯酰胺污水具有粘度高、油水分离难度大、可生化性差等特点,对环境的负面影响也越来越明显.因此,亟待解决的问题便是部分水解聚丙烯酰胺的降解.本文综述了聚丙烯酰胺化学、生物降解机理,总结了降解聚丙烯酰胺的典型的微生物种群,阐述了生物方法的优势,为油田含聚丙烯酰胺污水的处理研究提供参考.     

Effect of Polymer on Dynamic Interfacial Tensions of Anionic–nonionic Surfactant Solutions

The dynamic interfacial tensions (IFTs) of enhanced oil recovery (EOR) surfactant/polymer systems against n-decane have been investigated using a spinning drop interfacial tensiometer in this paper. Two anionic–nonionic surfactants with different hydrophilic groups, C₈PO₆EO₃S (6-3) and C₈PO₆EO₆S (6-6), were selected as model surfactants. Partially hydrolyzed polyacrylamide (HPAM) and hydrophobically modified polyacrylamide (HMPAM) were employed. The influences of surfactant concentration, temperature, polymer concentration, and oleic acid in the oil on IFTs have been studied. The experimental results show that anionic–nonionic surfactants can form compact adsorption films and reach ultralow IFT (10^?3 mN/m) under optimum conditions. The addition of polymer has great influence on dynamic IFTs between surfactant solutions and n-decane mainly by the formation of looser mixed films resulting from the penetration of polymer chains into the interface. The compact surfactant film will also be weakened by the competitive adsorption of oleic acid, which results in the increase of IFT. Moreover, the penetration of polymer chains will be further destroyed surfactant/polymer mixed layer and lead to the obvious increase of IFT. On the other hand, polymers show little effect on the IFTs of 6-6 systems than those of 6-3 because of the hindrance of longer EO chain of 6-6 at the interface.     

部分水解聚丙烯酰胺在多孔介质中的静态吸附研究——水解度对吸附量的影响

部分水解聚丙烯酰胺在多孔介质中的静态吸附研究———水解度对吸附量的影响杨继萍李惠生黄鹏程（北京理工大学化工与材料学院北京１０００８１）（北京航空航天大学材料科学与工程系北京１０００８３）关键词部分水解聚丙烯酰胺，水解度，多孔介质，静态吸附聚合物作为...     

不同类型聚合物溶液对采油残余油的作用机理研究

通过实验测定了HPAM溶液和黄原胶溶液的流变性、在多孔介质中的流变性和残余阻力系数 ,计算了衰竭层效应 .用不同的浓度和注入速度进行了驱油实验 .提出聚合物分子缠结作用的增强不仅引起表观粘度增加或衰竭层厚度降低 ,而且使平行于油水界面的拉动残余油的力增加 ,从而使残余油饱和度降低 ,采收率提高 .随浓度增加 ,HPAM溶液的表观粘度和残余阻力系数增加 ,衰竭层厚度减小 ;黄原胶溶液的浓度高于缠结浓度时 ,衰竭层厚度和表观粘度变化不大 .注入速度增加时 ,两种聚合物溶液的衰竭层厚度均降低 ,HPAM溶液的残余阻力系数不变 ,粘弹性增加 ;而黄原胶溶液的残余阻力系数下降 .不同浓度和注入速度情况下两种聚合物溶液的驱油结果证实了文中提出的聚合物分子缠结作用和衰竭层效应对残余油的作用机理 .分子结构的不同是造成两种聚合物溶液在多孔介质中渗流规律和对残余油作用机理的差别的根本原因 .     

水解聚丙烯酰胺溶液粘弹特性的研究

通过锥板测量系统对水解聚丙烯酰胺(HPAM)溶液的粘弹性进行了研究.结果表明, 这种锥板测量系统能较灵敏地检测出溶液粘弹性结构的存在,并得到了聚合物溶液的弹性成份和粘性成份的关系.发现随着HPAM溶液浓度的增大,聚合物溶液的弹性成份起初迅速增大,随后增大的趋势变慢而趋于平缓,在经历一最大值后又略有下降.在剪切速率ṝ =0.36 s－1下,超高分子量的HPAM(M=1.65×107)溶液(c = 1.5 g·L－1)具有明显的粘弹特性;随着盐的加入,溶液的粘弹性下降,当盐浓度达到一定值的时候,溶液内部的网络结构遭到破坏,其弹性行为完全消失.对于聚丙烯酰胺(PAAM, M=2.0×105)溶液(c = 2.0 g·L－1)在剪切速率(ṝ=0.36～1.36 s－1)范围内没有观察到粘弹行为,只在ṝ≥1.65 s－1时,才能观察到微弱的粘弹现象.