石英晶体板非线性高频振动的拓展伽辽金法分析

针对考虑几何和材料非线性的石英晶体板厚度剪切振动和弯曲振动的方程组,利用扩展伽辽金法对该方程组进行转化和求解,分别获得了强烈耦合的厚度剪切振动模态和弯曲振动模态的频率响应关系,绘制了不同振幅比和不同驱动电压影响下的频率响应曲线图。数值计算结果表明可以选取石英晶片的最佳长厚比尺寸来避免两种模态的强烈耦合。驱动电压的变化将引起石英晶体谐振器厚度剪切振动频率的明显改变,必须将振动频率的漂移值控制在常用压电声波器件的允许值之内。扩展伽辽金法对石英晶体板非线性振动方程组的求解为非线性有限元分析和偏场效应分析奠定了基础。     

Multivariate optimization and comparison between conventional extraction (CE) and ultrasonic-assisted extraction (UAE) of carotenoid extraction from cashew apple

Carotenoids are an essential component of cashew and can be used in pharmaceuticals, cosmetics, natural pigment, food additives, among other applications. The present work focuses on optimizing and comparing conventional and ultrasound-assisted extraction methods. Every optimization step took place with a 1:1 (w:w) mixture of yellow and red cashew apples lyophilized and ground in a cryogenic mill. A Simplex-centroid design was applied for both methods, and the solvents acetone, methanol, ethanol, and petroleum ether were evaluated. After choosing the extractor solvent, a central composite design was applied to optimize the sample mass (59–201 mg) and extraction time (6–34 min). The optimum conditions for the extractor solvent were 38% acetone, 30% ethanol, and 32% petroleum ether for CE and a mixture of 44% acetone and 56% methanol for UAE. The best experimental conditions for UAE were a sonication time of 19 min and a sample mass of 153 mg, while the CE was 23 min and 136 mg. Comparing red and yellow cashews, red cashews showed a higher carotenoid content in both methodologies. The UAE methodology was ca. 21% faster, presented a more straightforward composition of extracting solution, showed an average yield of superior carotenoid content in all samples compared to CE. Therefore, UAE has demonstrated a simple, efficient, fast, low-cost adjustment methodology and a reliable alternative for other applications involving these bioactive compounds in the studied or similar matrix.     

一种通过梯形PPMgLN波导倍频实现带宽可调谐光源的理论研究

本文设计了一种梯形的周期极化掺镁铌酸锂(PPMgLN)波导,并通过在传播方向上引入温度梯度来拓宽其倍频(SHG)过程的泵浦光源可接收带宽。通过有限差分的光束传输法,计算波导的有效折射率,并进行波导尺寸的设计。结果表明,通过改变梯形波导不同位置的温度,使其形成一个温度梯度,可拓宽泵浦光源的波长可接收带宽。本文所设计的PPMgLN波导最大泵浦光源可接收带宽为C波段,即1 530~1 565 nm,该波导可倍频C波段,得到输出波段带宽为765~782.5 nm,温度调谐范围为30~150 ℃。     

Terahertz generation in quantum cascade structures by two-color deriving fields: An approach to reach inversion population via optical pumping

In this paper, a quantum cascade laser (QCL) design is proposed based on GaAs/AlGaAs material system, which simultaneously operates at three widely separated wavelengths (${\lambda }_1=11.1\mu m,{\lambda }_2=14.1\mu m$ and ${\lambda }_{THz}=60\mu m$). In the design, all the wavelength radiations are achieved by the engineering of the electronic spectrum via the quantum-well widths and the applied electric field in a single active region within a same waveguide. The mid-infrared (mid-IR) wavelengths are obtained by adoption a dual-upper-state active region, and the proposed design aims to use both the mid-IR radiations as the coherent deriving fields to populate the upper THz lasing state to aid the THz-laser population inversion via optical pumping instead of direct electrical injection. A detailed analysis of electronic transport in the structure is carried out using a multi-level rate-equation model. The results show that the proposed structure offers an alternative approach to room temperature THz generation in QCLs.     

介观电路中量子纠缠的经典对应

从量子力学诞生日起,它的经典对应(或类比)一直是物理学家关心的话题.本文以介观电路量子化的框架中,带有互感的两个介观电容-电感(LC)电路为例,首次讨论了量子纠缠的经典类比(或对应)问题.先用有序算符内的积分理论证明其互感是产生量子纠缠的源头;再推导出求解特征频率的公式,就发现它与一个经典系统的小振动频率的表达式有相似之处,该经典系统组成如下:两个墙壁各连一个相同的弹簧,两个弹簧之间接着一个滑动小车可以在光滑的桌面上运动,小车挂有一根单摆.用分析力学求此系统的小振动频率,发现与上述介观电路的特征频率形式类似,单摆的摆动会造成小车来回振动,摆、小车和弹簧的互相牵制效应反映了小车和摆的"纠缠".     

薄板结构加筋布局优化设计方法研究

提出一种两步优化策略，以加筋板结构的固有频率最大化为目标函数，以结构所受外载荷作用的最大静变形为约束条件，开展薄板结构加筋构件的布局优化设计研究。为了降低加筋布局优化的难度，提高优化设计的效率，将加筋等效为一系列弹性铰（点）支撑，以便快速获得加筋横向移动的灵敏度信息。在基本不改变结构重量的情形下，通过合理布局加筋位置，能显著改善结构的刚度分布，提高结构的整体承载能力。随后，小幅调整加筋的截面尺寸，以满足对结构最大变形的设计要求。最后，用两个算例验证了所提优化方法的可行性和有效性。     

Spatially almost periodic solutions for active scalar equations

We are concerned with a family of dissipative active scalar equation on . By using similar methods from the previous paper of Y. Giga et al. (see Introduction below), we construct a unique real, spatially almost periodic mild solution θ of 1.1 satisfying 1.11 . In this paper, we consider some countable sum‐closed frequency sets (see Remark 1.1 ). We show that the property of the solution is rather different from Chae et al 1 and obtain that with some initial data θ₀ for all t≥0, and 0≤α≤ω, where ω is a fixed constant. Furthermore, arranging the elements of a countable sum‐closed frequency set F_δ as in Remark 1.3 , we have for any 0≤α≤ω that belongs to , where F_δ is defined in 1.4 or 1.5 .     

Highly Dispersed and Small‐Sized Nickel(II) Hydroxide Co‐Catalyst Prepared by Photodeposition for Hydrogen Production

Photodeposition has been widely used as a mild and efficient synthetic method to deposit co‐catalysts. It is also worth studying how to synthesize non‐noble metal photocatalysts with uniform dispersion. Different synthetic conditions in photodeposition have a certain influence on particle size distribution and photocatalytic activity. Therefore, we designed experiments to prepare the inexpensive composite photocatalyst Ni(OH)₂/g‐C₃N₄ by photodeposition. The Ni(OH)₂ co‐catalysts disperse uniformly with particle sizes of about 10 nm. The photocatalytic hydrogen production rate of Ni(OH)₂/g‐C₃N₄ reached about 19 mmol g^?1 h^?1, with the Ni(OH)₂ deposition amount about 1.57 %. During 16 h stability testing, the rate of hydrogen production did not decrease significantly. The composite catalyst also revealed a good hydrogen production performance under sunlight. The Ni(OH)₂ co‐catalyst enhanced the separation ability of photogenerated carriers, which was proved by surface photovoltage and fluorescence analysis.     

Multistrain edge‐based compartmental model on networks

Multistrain diseases, which are infected through individual contacts, pose severe public health threat nowadays. In this paper, we build competitive and mutative two‐strain edge‐based compartmental models using probability generation function (PGF) and pair approximation (PA). Both of them are ordinary differential equations. Their basic reproduction numbers and final size formulas are explicitly derived. We show that the formula gives a unique positive final epidemic size when the reproduction number is larger than unity. We further consider competitive and mutative multistrain diseases spreading models and compute their basic reproduction numbers. We perform numerical simulations that show some dynamical properties of the competitive and mutative two‐strain models.