多种纳米结构Fe掺杂TiO2光热耦合水分解制氢研究

氧空位是材料缺陷工程的重要组成. 基于光生氧空位的直接热利用, 实现纯水分解制氢的光热耦合实验, 被认为是太阳能综合利用的有效途径. 以多种制备方法合成的TiO₂纳米材料为基础, 研究了多种形貌纳米TiO₂及其Fe掺杂改性材料的光热耦合反应能力. 通过高分辨透射电子显微镜(HRTEM)、 X射线衍射(XRD)和电子顺磁共振(EPR)对晶体特征进行表征, 利用漫反射光谱(DRS)、 光致发光(PL)和三电极测试法表征了材料的性能, 并结合密度泛函理论(DFT)计算了产氢反应路径. 研究结果表明, 溶胶-凝胶法制备的纳米颗粒相比水热法制备的纳米片及纳米线, 体相内缺陷较多, 载流子强度高, 光热耦合产氢效果较差. Fe掺杂改性扩展了光响应, 增强了载流子分离和寿命, 降低了电子传输阻抗, 利于光反应过程中光生氧空位的形成, 克服了制氢反应中的关键能垒. 同时, 纳米材料中的缺陷促进了Fe离子的有效掺杂, Fe掺杂TiO₂纳米颗粒的光热耦合平均产氢量为9.73 μmol/g, 性能提升达13倍.     

Fe掺杂Mn/TiO_2低温脱硝催化剂的催化性能研究

采用氧化沉淀-浸渍法制备了不同含量Fe掺杂的Fe-Mn/TiO_2低温脱硝催化剂,考察了催化剂在80~180℃范围内的脱硝能力并通过XRD、BET、TG、H_2-TPR、NH_3-TPD等测试手段,对催化剂的物理化学性质进行了表征。实验结果表明,Fe的加入并没有改变Mn/TiO_2的主要晶相,仍是锐钛矿型的TiO_2,Mn Ox和FeO_x均以非晶态结构高度分散于载体表面,而且Fe的加入可以有效地改善催化剂的微观形貌、比表面积及表面酸性位点,从而提高其低温脱硝性能。Fe掺量在Fe/Ti为0.10时催化剂具有最佳性能,在120℃时脱硝率可达90%以上。     

溶胶凝胶法制备Ti1-xFexO2纳米颗粒及磁性能研究

采用溶胶凝胶法制备了稀磁半导体Ti1-xFexO2(x=0～0.050)的纳米颗粒,在氩气氛围中以500℃对样品进行退火处理,并通过差热/热重综合热分析仪(TG-DTA)、X射线衍射仪(XRD)、拉曼光谱(Raman)分析了纳米颗粒的结构和相变温度.使用振动样品磁场计(VSM)测试了样品的磁性能.研究发现:经500℃氩...     

Lattice vibration and photoinduced light scattering in Co-, Cr- and Fe-doped lithium niobate

Raman scattering and photoinduced light scattering in Co-, Cr- and Fe-doped lithium niobate were examined. The A₁(TO) modes appear in E symmetry spectrum of the doped lithium niobate. Their intensities vary with different dopings. In the spectrum of z(yy)x geometry, the properties of the lowest-frequency E(TO) mode of the Cr-doped lithium niobate are different from those of pure, Co- and Fe-doped lithium niobate. The intensity of the A₁(TO) mode at 637cm^-1 I is decreased in doped lithium niobate compared with the pure crystal. We attribute these properties to both the photorefractive effect which is enhanced by dopants and to the different occupation of the doping ions. A light climbing effect was observed in Co- and Cr-doped lithium niobate for the first time. A higher photodamage threshold and quicker light climbing speed were found in Co- and Cr-doped lithium niobate in comparison with the light climbing effect in the Fe-doped lithium niobate. The results from the photoinduced light scattering experiments were compared with those from a Raman spectroscopic study.     

水热合成掺Fe氧化锌复合材料及其光催化活性

以Zn(Ac)2•2H2O、Fe(NO3)3•9H2O和NaOH为原料,采用水热法合成了Fe掺杂ZnO复合材料。并用x射线衍射和扫描电子显微镜技术对合成样品的结构和形貌进行了表征,Fe掺杂ZnO合成产物为直棒状,直径为500 nm,长度为3 µm左右。样品的紫外可见漫反射分析,在300~500 nm紫外可见光区域均有强的吸收。利用Fe掺杂ZnO作为光催化剂降解有机染料,发现对于光催化降解有机染料有较好的降解功能,且光降解性能优于纯ZnO材料。     

铁掺杂TiO2纳米管阵列对不锈钢的光生阴极保护

在含FeSO4的HF、H2SO4/HF、NaF/Na2SO4溶液中,通过电化学阳极氧化直接在纯钛表面制备Fe 掺杂的TiO2(Fe-TiO2)纳米管阵列. 应用X射线衍射(XRD)、扫描电子显微镜(SEM)、紫外-可见吸收光谱(UV-Vis)、X 射线光电子能谱(XPS)等手段对纳米管阵列的结构、形貌及化学组成进行表征. 利用光电化学测量研究Fe-TiO2纳米管阵列在不同波长范围内的光电响应特性和光生阴极保护行为. 考察了温度、时间、掺杂含量等参数对TiO2纳米管阵列的几何尺寸、形貌和光电性能的影响. 结果表明, Fe掺杂可有效减缓TiO2纳米管阵列载流子的复合, 窄化TiO2带隙宽度, Fe-TiO2在410-650 nm范围显示强吸收, 并使光谱响应扩展到波长大于400 nm 的可见光区. 实验结果还表明, Fe-TiO2纳米管阵列对316不锈钢(316L)具有良好的光生阴极保护作用, 暗态下阴极保护作用可继续维持.     

The influence of Fe doping on the structural, magnetic and optical properties of nanocrystalline ZnO particles

We report the results of an investigation of Fe-doped nanocrystalline ZnO particles synthesized using the co-precipitation method with doping concentrations from 5 up to 31 at%. To understand how the dopant influenced the structural, magnetic and optical properties of nanocrystalline ZnO particles, X-ray diffraction, energy dispersive X-ray spectroscopy, infrared absorption spectroscopy, UV-vis spectroscopy, electron spin resonance spectroscopy (ESR) and vibrating sample magnetometer were employed. From the analysis of X-ray diffraction, our Fe-doped nanocrystalline ZnO particles are identified as having the wurtzite crystal structure and the unit cell volume increases with increasing doping concentrations. However, impurity phases are observed for Fe contents higher than 21 at%. Sample structures were further studied by infrared spectra, from which a broad and strong absorption band in the range of 400-700 cm⁻¹ and -OH stretching vibrational mode at approximately 3400 cm⁻¹ were observed. Ultraviolet-visible measurements showed a decrease in the energy gap with increasing Fe content, probably due to an increase in the lattice parameters. Magnetic measurements showed a ferromagnetic behavior for all samples. ESR results indicate the presence of Fe in both valence states Fe²⁺ and Fe³⁺.     

Electron-mediated ferromagnetism in Fe-doped InP: Theory and experiment

We report on the electron-mediated ferromagnetism in Fe-doped InP from both first-principles calculations and experiments. Theoretically, based on the spin-polarized density functional theory within the Heyd-Scuseria-Ernzerhof (HSE03) approach, we systematically investigate the magnetic properties of Fe-doped InP and predict the existence of electron-mediated ferromagnetism. Experimentally, by diffusing Fe into the n-type InP wafer with thermal annealing at 800 C, we observe room-temperature ferromagnetism in InP:Fe, which is in agreement with the theoretical prediction.     

Synergy of Iron Doping and Cyano Groups for Enhanced Photocatalytic Hydrogen Production over C3N4

Improving the insufficient carrier separation dynamics is still of significance in carbon nitride (C₃N₄) research. Extensive research has been devoted to improving the carrier separation efficiency through a single strategy, while ignoring the synergistic enhancement effect produced by coupling two or more conventional strategies. Herein, we reported the fabrication of cyano group-containing Fe-doped C₃N₄ porous materials via direct co-calcination of iron acetylacetonate and melamine for synergistically improving the photocatalytic performance. Iron acetylacetonate can promote the generation of cyano groups and form Fe-doping in C₃N₄, thereby increasing the visible-light absorption and reactive sites. Further, the internal donor-acceptor system formed by cyano groups and Fe-doped sites promoted charge carrier separation and inhibited the radiation recombination of e⁻-h⁺ pairs. The optimized photocatalytic activity of Fe−CN-2 sample was 4.5 times of bulk C₃N₄ (BCN).     

Controllable Synthesis of Fe-Doped NiCo2O4 Nanobelts as Superior Catalysts for Oxygen Evolution Reaction

As one of the promising clean and renewable technologies, water splitting has been a hot topic, especially the half-reaction of oxygen evolution reaction (OER) due to its sluggish and complex kinetics. Hence, Fe-doped NiCo₂O₄ nanobelts were designed and prepared as catalysts toward OER. By increasing the Fe amount, the catalytic performances of the as-synthesized products went up and then decreased. Profiting from the synergistic effect between Fe atom and NiCo₂O₄, all the Fe-NiCo₂O₄ catalysts exhibited superior catalytic activities to the corresponding NiCo₂O₄. In addition, the characteristic nanobelt architecture facilitates the conduction of electrons and the exposure of active sites. With the optimal Fe content, the 9.1 % Fe-NiCo₂O₄ yielded the smallest overpotential and Tafel slope among the catalysts, distinctly lower than that of RuO₂.