Dynamical analysis,circuit realization,and application in pseudorandom number generators of a fractional-order laser chaotic system

A new five-dimensional fractional-order laser chaotic system (FOLCS) is constructed by incorporating complex variables and fractional calculus into a Lorentz-Haken-type laser system. Dynamical behavior of the system, circuit realization and application in pseudorandom number generators are studied. Many types of multi-stable states are discovered in the system. Interestingly, there are two types of state transition phenomena in the system, one is the chaotic state degenerates to a periodical state, and the other is the intermittent chaotic oscillation. In addition, the complexity of the system when two parameters change simultaneously is measured by the spectral entropy algorithm. Moreover, a digital circuit is design and the chaotic oscillation behaviors of the system are verified on this circuit. Finally, a pseudo-random sequence generator is designed using the FOLCS, and the statistical characteristics of the generated pseudo-random sequence are tested with the NIST-800-22. This study enriches the research on the dynamics and applications of FOLCS.     

Yb:CaF2–YF3 transparent ceramics ultrafast laser at dual gain lines

Yb³⁺:CaF₂-YF₃ transparent ceramics with excellent optical quality was successfully fabricated by hot-pressed method. Pulsed laser properties of this ceramics were investigated for the first time. Laser diode (LD) was applied as the pump source to generate a dual-wavelength mode-locked (ML) laser. The maximum average output power was 310 mW, which represents the highest output power of ultrafast calcium fluoride ceramic laser. The spectrum separated at 1048.9 nm and 1049.7 nm with a total pulse duration of 8.9 ps. The interval period between the beating signals was about 4.3 ps, corresponding to a 0.23 THz beat pulse repetition rate. These results demonstrate its potential in producing dual-wavelength ultrashort pulses. These Yb³⁺:CaF₂-YF₃ ceramics with low-cost and short-preparation period are ideal candidate materials for ultrafast lasers.     

光纤基底TiNi形状记忆合金薄膜制备工艺

将TiNi基记忆合金薄膜与光纤相结合可制成智能化、集成化且成本经济的微机电系统和微传感器件.本文采用磁控溅射法在二氧化硅光纤基底上制备TiNi记忆合金薄膜,系统讨论了溅射工艺参数以及后续退火处理对薄膜质量的影响.采用自研制光纤镀膜掩膜装置在直径为125μm的光纤圆周表面上形成均匀薄膜.实验表明:在靶基距、背底真空度、Ar气流量和溅射时间一定的条件下,溅射功率存在最佳值;溅射压强较大时,薄膜沉积速率较低,但薄膜表面粗糙度较小.进行退火处理后,薄膜形成较良好的晶体结构,Ti_49.09Ni_50.91薄膜中马氏体B19′相和奥氏体B2相共存,但以B19′为主.根据本文研究结果,在玻璃光纤基底上制备高质量的TiNi基记忆合金薄膜是可实现的,本工作为下一步研制微机电系统和微型传感器做了基础准备.     

阳离子交换皂石黏土在基质辅助激光解吸电离飞行时间质谱分析中的应用

将一种人工合成的无机聚合物——蒙脱石皂石黏土（smectite，Sm）应用于基质辅助激光解吸电离飞行时间质谱分析（matrix-assisted laser desorption/ionization time of flight mass spectrometry, MALDI-TOF-MS），以检测糖类化合物。 将传统的有机基质2，4，6-三羟基苯乙酮（trihydroxyacetophenone, THAP）与阳离子交换后的皂石黏土混合制备成新型复合基质，应用于糖类化合物的检测。通过比较不同的制样方法，测定不同分子直径的糖类化合物，发现由于受复合基质晶面间距的限制，只有小分子糖类化合物能进入晶面间隙充分接触有机基质并被离子化，从而实现对小分子糖类化合物的选择性检测。     

Terahertz generation in quantum cascade structures by two-color deriving fields: An approach to reach inversion population via optical pumping

In this paper, a quantum cascade laser (QCL) design is proposed based on GaAs/AlGaAs material system, which simultaneously operates at three widely separated wavelengths (${\lambda }_1=11.1\mu m,{\lambda }_2=14.1\mu m$ and ${\lambda }_{THz}=60\mu m$). In the design, all the wavelength radiations are achieved by the engineering of the electronic spectrum via the quantum-well widths and the applied electric field in a single active region within a same waveguide. The mid-infrared (mid-IR) wavelengths are obtained by adoption a dual-upper-state active region, and the proposed design aims to use both the mid-IR radiations as the coherent deriving fields to populate the upper THz lasing state to aid the THz-laser population inversion via optical pumping instead of direct electrical injection. A detailed analysis of electronic transport in the structure is carried out using a multi-level rate-equation model. The results show that the proposed structure offers an alternative approach to room temperature THz generation in QCLs.     

Coupling characteristics of laterally coupled gratings with slots

Laterally-coupled ridge-waveguide distributed feedback lasers fabricated without epitaxial regrowth steps have the advantages of process simplification and low cost. We present a laterally coupled grating with slots. The slots etched between the ridge and grating area are designed to suppress the lateral diffusion of carriers and to reduce the influence of the aspect-ratio-dependent-etching effect on the grating morphology in the etching process. Moreover, the grating height in this structure can be decreased to lower the aspect ratio significantly, which is advantageous over the conventional laterally coupled ridge waveguide gratings. The effects of five main structural parameters on the coupling characteristics of gratings are studied by MODE Solutions. It is found that varying the lateral width of the grating can be used as an effective way to tune the coupling strength; narrow slots (100 nm and 300 nm) and wide ridge (2 μm-4 μm) promote the stability of grating coupling coefficient and device performance. It is important to note that the grating bottom should be fabricated precisely. The comparative study of carrier distribution and mode field distribution shows that the introduction of narrow slots can strengthen the competitive advantage and stability of the fundamental mode.     

双激光脉冲打靶形成Gd等离子体的极紫外光谱辐射

高端芯片制造所需要的极紫外光刻技术位于我国当前面临35项"卡脖子"关键核心技术之首.高转换效率的极紫外光源是极紫外光刻系统的重要组成部分.本文通过采用双激光脉冲打靶技术实现较强的6.7 nm极紫外光输出.首先,理论计算Gd¹⁸⁺—Gd²⁷⁺离子最外层4d壳层的4p-4d和4d-4f能级之间跃迁、以及Gd¹⁴⁺—Gd¹⁷⁺离子最外层4f壳层的4d-4f能级之间跃迁对波长为6.7 nm附近极紫外光的贡献.其后开展实验研究,结果表明,随着双脉冲之间延时的逐渐增加,波长为6.7 nm附近的极紫外光辐射强度呈现先减弱、后增加、之后再减弱的变化趋势,在双脉冲延时为100 ns处产生的极紫外光辐射最强.并且,在延时为100 ns处产生的光谱效率最高,相比于单脉冲激光产生的光谱效率提升了33%.此外,发现双激光脉冲打靶技术可以有效地减弱等离子体的自吸收效应,获得的6.7 nm附近极紫外光谱宽度均小于单激光脉冲打靶的情形,且在脉冲延时为30 ns时刻所产生的光谱宽度最窄,约为单独主脉冲产生极紫外光谱宽度的1/3.同时...     

Yield enhancement of elliptical high harmonics driven by bicircular laser pulses

We theoretically investigate the yield enhancement of elliptical high harmonics in the interaction of molecules with bicircular laser pulses by solving the time-dependent Schrödinger equation. It is shown that by adjusting the relative intensity ratio of the two bicircular field components in specific ranges the yield of the molecular high harmonics for the plateau and cutoff regions can be respectively enhanced. To analyze this enhancement phenomenon, we calculate the weights of the electron classical trajectories. Additionally, we also study the ellipticity distribution of harmonics for different intensity ratios. We find that these enhanced harmonics are elliptically polarized, which we mainly attribute to the recombination dipole moment of the major weighted trajectories. These enhanced elliptical extreme ultraviolet and soft x-ray radiations may serve as essential tools for exploring the ultrafast dynamics in magnetic materials and chiral media.     

Physical,Thermal and Biological Properties of Yellow Dyes with Two Azodiphenylether Groups of Anthracene

Two yellow bis-azo dyes containing anthracene and two azodiphenylether groups (BPA and BTA) were prepared, and an extensive investigation of their physical, thermal and biological properties was carried out. The chemical structure was confirmed by the FTIR spectra, while from the UV–Vis spectra, the quantum efficiency of the laser fluorescence at the 476.5 nm was determined to be 0.33 (BPA) and 0.50 (BTA). The possible transitions between the energy levels of the electrons of the chemical elements were established, identifying the energies and the electronic configurations of the levels of transition. Both crystals are anisotropic, the optical phenomenon of double refraction of polarized light (birefringence) taking place. Images of maximum illumination and extinction were recorded when the crystals of the bis-azo compounds rotated by 90° each, which confirms their birefringence. A morphologic study of the thin films deposited onto glass surfaces was performed, proving the good adhesion of both dyes. By thermal analysis and calorimetry, the melting temperatures were determined (~224–225 °C for both of them), as well as their decomposition pathways and thermal effects (enthalpy variations during undergoing processes); thus, good thermal stability was exhibited. The interaction of the two compounds with collagen in the suede was studied, as well as their antioxidant activity, advocating for good chemical stability and potential to be safely used as coloring agents in the food industry.