Evaluation of green and efficient deep eutectic solvents as media for extracting alkaloids from lotus leaf

Deep eutectic solvents (DESs) were applied as eco-friendly solvents in this study for the extraction of alkaloids from lotus leaf, including O-nornuciferine, N-nornuciferine, nuciferine and roemerine. A series of hydrophilic and hydrophobic DESs with different hydrogen bond donors and a acceptors were synthesized and screened for a suitable DESs for extraction of alkaloids from lotus leaf. The study results showed that the hydrophilic DES with choline chloride and propanediol had the highest extraction yield. The main factors affecting the extraction efficiency—choline chloride–propanediol ratio, water content in deep eutectic solvents, solid–liquid ratio and extraction time—were investigated via a single-factor experiment. The optimized extraction conditions were 30% of water in choline chloride–propanediol (1:4) for heated extraction for 30 min and solid–liquid ratio 1:100 g/ml. Under optimum conditions, the extraction yields of O-nornuciferine, N-nornuciferine, nuciferine and roemerine were 0.069, 0.152, 0.334 and 0.041 g/100 g respectively, which were higher than those of methanol in acidified aqueous solution. This study suggests considerable potential for DESs as promising materials for the green and efficient extraction solvents for bioactive alkaloids from natural sources.     

Application of microcrystalline cellulose as an efficient and cheap sorbent for the extraction of metoprolol from plasma and wastewater before HPLC–MS/MS determination

A dispersive solid-phase extraction method based on a new sorbent has been performed on plasma and wastewater samples to determine metoprolol by high-performance liquid chromatography–tandem mass spectrometry. In this study, the analyte was adsorbed from the samples onto microcrystalline cellulose as a green and efficient sorbent and then eluted for use in the determination step. In the mass spectrometer, the analyte was detected in the positive mode and selectivity of the analysis was increased by sequential mass analysis through multiple reaction monitoring. All of the effective parameters in the extraction of metoprolol from plasma and wastewater were optimized. Under optimal conditions the method was linear in the ranges of 1–1,000 and 0.1–1,000 ng/ml in plasma and wastewater samples, respectively. The detection limits of the method were 0.30 and 0.03 ng/ml in plasma and wastewater samples, respectively. The data showed that the method provides low detection limit, wide linear range, good precision and high extraction recovery. Finally several plasma and wastewater samples were successfully analyzed using the method. The use of a small amount of a green and inexpensive sorbent and a low volume of plasma without the need for further pretreatment steps are the main advantages of the method.     

Optimisation of the ultrasound-assisted extraction of betalains and polyphenols from Amaranthus hypochondriacus var. Nutrisol

The present study optimised the ultrasound-assisted extraction (UAE) of bioactive compounds from Amaranthus hypochondriacus var. Nutrisol. Influence of temperature (25.86–54.14 °C) and ultrasonic power densities (UPD) (76.01–273.99 mW/mL) on total betalains (BT), betacyanins (BC), betaxanthins (BX), total polyphenols (TP), antioxidant activity (AA), colour parameters (L*, a*, and b*), amaranthine (A), and isoamaranthine (IA) were evaluated using response surface methodology. Moreover, betalain extraction kinetics and mass transfer coefficients (K_La) were determined for each experimental condition. BT, BC, BX, TP, AA, b*, K_La, and A were significantly affected (p < 0.05) by temperature extraction and UPD, whereas L*, a*, and IA were only affected (p < 0.05) by temperature. All response models were significantly validated with regression coefficients (R²) ranging from 87.46 to 99.29%. BT, A, IA, and K_La in UAE were 1.38, 1.65, 1.50, and 29.93 times higher than determined using conventional extraction, respectively. Optimal UAE conditions were obtained at 41.80 °C and 188.84 mW/mL using the desired function methodology. Under these conditions, the experimental values for BC, BX, BT, TP, AA, L*, a*, b*, K_La, A, and IA were closely related to the predicted values, indicating the suitability of the developed quadratic models. This study proposes a simple and efficient UAE method to obtain betalains and polyphenols with high antioxidant activity, which can be used in several applications within the food industry.     

Determination of trace amounts of aromatic amines after magnetic solid‐phase extraction using silver‐modified Fe3O4/graphene nanocomposite

In this work, a fast and simple magnetic dispersive solid phase extraction methodology was developed utilizing Ag@magnetite nanoparticles@graphene nanocomposite as an efficient magnetic nanosorbent for preconcentration and determine of five aromatic amines in water samples. The sorbent was characterized by diverse characterization techniques. After the extraction, high‐performance liquid chromatography with UV detection was utilized to analysis the aromatic amines. The effects of different factors on the extraction process were studied thoroughly via design of experiment and desirability function. Detection limits and linear dynamic ranges were obtained in the range of 0.10–0.20 and 0.3–300 μg/L, respectively. The relative standard deviations (n = 5) were in the range of 4.3–6.5%. Eventually, the method was employed for determination of target aromatic amines in various water samples.     

A simple,rapid and sensitive method based on modified multiwalled carbon nanotube for preconcentration and determination of lead ions in aqueous media in natural pHs

In this study, multiwalled carbon nanotube (MWCNT) was modified by the pyridine group using a silane agent and characterized by infrared spectroscopy (IR), thermal analysis (TG/DTA), and elemental analysis (CHN) and scanning electron microscopy (SEM). The application of this sorbent was investigated in determination of lead ions in aqueous samples, using flame atomic absorption spectrometry (FAAS). Through this study, different parameters such as pH and sample flow rate on adsorption process and eluent concentration, volume and flow rate were optimized. The limit of detection (LOD), the relative standard deviation and the recovery of the method were 2 ng mL^?1, 1.3% and 99.7%, respectively. Two standard reference materials (NIST 1571 and NIST 1572) were used to verify accuracy of this method. Finally, the sorbent was successfully applied for extraction and determination of low levels of Pb(II) ions in aqueous samples.     

QuEChERS/超高效液相色谱-串联质谱法快速测定土壤中19种氟喹诺酮类抗生素残留

建立了一种基于QuEChERS前处理技术,结合超高效液相色谱-串联质谱(UPLC-MS/MS)和内标法,快速测定土壤中19种氟喹诺酮类抗生素(FQs)残留的分析方法。5. 0 g土壤样品添加200μg/kg基质匹配同位素内标后,经20 m L 0. 1 mol/L EDTA-McIlvaine缓冲液和乙腈混合溶剂(体积比1∶1)提取,基质分散固相萃取(150 mg无水MgSO4、15 mg PSA、15 mg C18)净化后,采用UPLC-MS/MS进行测定。质谱分析采用电喷雾电离,正离子扫描,多反应监测模式。在优化条件下,19种抗生素的相关系数(r~2)为0. 992～0. 998,检出限为0. 2～1. 0μg/kg,定量下限为1. 0～5. 0μg/kg;在10、50、200μg/kg加标水平下的回收率为65. 2%～104%,相对标准偏差(n=5)不大于14%。该方法操作简单快速、准确度高,适用于土壤中氟喹诺酮类抗生素残留的检测。     

Magnetic solid‐phase extraction based on carbon nanosphere@Fe3O4 for enantioselective determination of eight triazole fungicides in water samples

In this work, a carbon nanosphere decorated by Fe₃O₄ nanoparticles was prepared, characterized and used as the magnetic adsorbent. Eight commonly used chiral triazole fungicides, including penconazole, uniconazole, paclobutrazol, triazolone, tebuconazole, hexaconazole, triticonazole and epoxiconazole were extracted from two environmental water samples (river water and lake water) by magnetic solid‐phase extraction, followed by the enantiomeric analysis on a Chiralpark IC column coupled with a triple quadrupole mass spectrometry to evaluate their possible stereoselective degradation occurring in the water samples. The possible factors affecting the extraction performance, such as amount of used adsorbents, pH and ionic strength of water solution, types and volumes of desorption solvents were systematically investigated. Under the optimum conditions, extraction yields of eight triazole fungicides were above 80% and the concentration factors were as high as 1000. Method detection and quantification limits for the enantiomers of eight triazole fungicides were in the range of 0.56–6.95 ng/L. Satisfactory accuracy (relative recovery 77.8–93.5%), good intraday precision (RSD 4.3–9.8%) and interday precision (RSD 3.1–7.9%) were also obtained. The developed method provided the simplicity of operation, rapidity and high enrichment factor, which can be used to monitor and evaluate the behavior of the individual enantiomer of chiral triazole fungicides.     

A simple method for extracting both active oily and water soluble extract (WSE) from Nigella sativa (L.) seeds using a single solvent system

The current study provides a way of extraction for both active NSO and WSE from Nigella sativa seeds using 98% methanol. About 1?kg of ground seeds was macerated by 1:2.5 w/v (g/mL) for 72?hours. After rotary evaporation and 7 days of continuous drying and chilling at 50 and 4?°C, NSO and WSE were obtained at the same instant. Solubility tests of 24 solvents and 11 thin layer chromatographic analyses while 2, 2-diphenyl-1-picrylhydrazyl free radical scavenging assay of NSO (73.66) , WSE (33.32) and NSO?+?WSE (78.22) against ascorbic acid (IC50?=?4.28?mg/mL) was performed. WSE was found to be highly soluble in water and 5% NaOH exhibiting the same Rf value of 0.95 for EtOH:DMSO (9:1) against the honey. WSE has revealed more than twofold higher anti-oxidant activity than others. Formulation of WSE with Tualang honey may provide better targeted hydrophilic drug delivery systems.     

Dissolvable layered double hydroxide as a sorbent in dispersive micro‐solid phase extraction for the determination of acidic quinolones in honey by HPLC

This study presents a simple and green dispersive micro‐solid phase extraction method for preconcentration of acidic quinolones from honey prior to high performance liquid chromatography determination. A two‐dimensional nanostructured zinc‐aluminum layered double hydroxide was synthesized and used as the sorbent for dispersive micro‐solid phase extraction. Its different characteristics from conventional sorbents is that it is dissolvable in acidic solution (pH < 4). After the extraction, the analyte elution step was omitted and thus the use of organic solvents was avoided. The key parameters influencing the extraction efficiency such as the amount of sorbent, pH of sample solution, vortex time, type and volume of acidic solution were investigated and optimized. The method exhibited low limits of detection (3.0?5.0 ng/g), good linearity (10?2000 ng/g) with coefficients of determinations higher than 0.9991, acceptable precision (RSD<9.1%) and accuracy (RE<5.8%). The proposed method is fast, efficient, eco‐friendly, and suitable for the determination of acidic quinolones in honey samples.     

Exploration and optimization of conditions for quantitative analysis of lignans in Schisandra chinensis by an online supercritical fluid extraction with supercritical fluid chromatography system

An online supercritical fluid extraction with supercritical fluid chromatography system could provide sequential extraction and quantitative analysis of lignans in Schisandra chinensis. Supercritical fluid extraction conditions were optimized at 15 MPa, 50°C, and 4 min with supercritical CO₂ adding 1% methanol; the elution volume and flow rate were set at 6 mL and 2 mL/min to blow extract out of the tank completely. The split‐flow rate was confirmed at 2.5%, which determines injection volume and accuracy of quantitative detection. The factors having negative influences on supercritical fluid chromatography retention in the online system, including sample loading forms and backpressure settings, are discussed in the paper. At last, an extraction‐quantitative method for lignans in Schisandra chinensis was developed, which could be finished within 19.5 min. The total content percentage of four lignans (Schisandrin, Schisandrin A, Schisandrin B and Schisandrol B) in four batches was respectively measured to be 1.42, 1.54, 1.62, and 1.90%.