Investigation of ammonia stripping with a hydrodynamic cavitation reactor

Ammonia is a commonly used compound in the domestic and industrial fields. If ammonia found in wastewater after use is not treated, even at low concentrations it may cause toxic effects in the receiving environment. In this study, a hydrodynamic cavitation reactor (HDC) was designed with the aim of removing ammonia. The effect of parameters like different cavitation numbers, airflow, temperature and initial concentration on NH₃ removal was researched. The potential of hydrodynamic cavitation for removal of volatile gases, like NH₃, was assessed with the aid of two film theory mathematical equations. Experimental studies were performed at fixed pH = 11. Under the conditions of 0.12 cavitation number, 25 L/min airflow, 30 °C temperature and 2500 mg/L initial concentration, in 24 h 98.4% NH₃ removal efficiency was achieved. With the same experimental conditions without any air, the HDC reactor provided 89.5% NH₃ removal at the end of 24 h.The HDC reactor is very effective for the removal of volatile gases from wastewater and it was concluded that even in the absence of aeration, the desired NH₃ removal efficiency was provided.     

Current air quality analytics and monitoring: A review

This review summarizes the different tools and concepts that are commonly applied in air quality monitoring. The monitoring of atmosphere is extremely important as the air quality is an important problem for large communities. Main requirements for analytical devices used for monitoring include a long period of autonomic operation and portability. These instruments, however, are often characterized by poor analytical performance. Monitoring networks are the most common tools used for monitoring, so large-scale monitoring programmes are summarized here. Biomonitoring, as a cheap and convenient alternative to traditional sample collection, is becoming more and more popular, although its main drawback is the lack of standard procedures. Telemonitoring is another approach to air monitoring, which offers some interesting opportunities, such as ease of coverage of large or remote areas, constituting a complementary approach to traditional strategies; however, it requires huge costs.     

Electrochemical sensors for environmental gas analysis

The application of electrochemical sensors for measurement of concentration of pollutant gases in air in the part-per-billion (10⁹) range is reviewed. Performance-limiting factors, particularly the effects of extremes and of relatively rapid changes in ambient temperature and humidity, are noted. Variations in composition of the electrolyte in the meniscus at the electrode–gas interface and instability of the solid–liquid–gas contact line, causing important variations in current due to background electrode reactions, are deduced and suggested as the reason for the performance limitations. Suggestions are made for mitigation through instrument design.     

Different regimes of the uniaxial elongation of electrically charged viscoelastic jets due to dissipative air drag

We investigate the effects of dissipative air drag on the dynamics of electrified jets in the initial stage of the electrospinning process. The main idea is to use a Brownian noise to model air drag effects on the uniaxial elongation of the jets. The developed numerical model is used to probe the dynamics of electrified polymer jets at different conditions of air drag force, showing that the dynamics of the charged jet is strongly biased by the presence of air drag forces. This study provides prospective beneficial implications for improving forthcoming electrospinning experiments.     

All-Solid-State Rechargeable Air Batteries Using Dihydroxybenzoquinone and Its Polymer as the Negative Electrode

A proof-of-concept study was conducted on an all-solid-state rechargeable air battery (SSAB) using redox-active 2,5-dihydroxy-1,4-benzoquinone (DHBQ) and its polymer (PDBM) and a proton-conductive polymer (Nafion). DHBQ functioned well in the redox reaction with the solid Nafion ionomer at 0.47 and 0.57 V vs. RHE, similar to that in acid aqueous solution. The resulting air battery exhibited an open circuit voltage of 0.80 V and a discharge capacity of 29.7 mAh g_DHBQ⁻¹ at a constant current density (1 mA cm⁻²). With PDBM, the discharge capacity was much higher, 176.1 mAh g_PDBM⁻¹, because of the improved utilization of the redox-active moieties. In the rate characteristics of the SSAB-PDBM, the coulombic efficiency was 84 % at 4 C, which decreased to 66 % at 101 C. In a charge/discharge cycle test, the capacity remaining after 30 cycles was 44 %, which was able to be significantly improved, to 78 %, by tuning the Nafion composition in the negative electrode.     

静电纺空气过滤用PET/CTS抗菌复合纳米纤维膜的制备

采用静电纺丝法制备PET/CTS复合纳米纤维膜,并在纤维膜表面吸附一层纳米银,进一步增加纤维膜的抗菌性能.以扫描电镜(SEM)对不同配比PET/CTS所制备的纤维膜的微观形貌进行表征,结果显示w(CTS)/w(PET)为12.5%时,纤维形貌较好,平均直径为405 nm.分别对不同厚度的PET/CTS纤维膜进行力学性能、透气性能以及空气过滤性能测试,结果表明纺丝时间为7 h时,纤维膜具有较好的性能,其弹性模量为48.15 MPa、断裂伸长率183.30%、拉伸断裂应力2.11 MPa、拉伸强度2.49 MPa、拉伸屈服应力1.23 MPa、最大力1.38 N,阻气值为3.99 k Pa·S/m,过滤效率为99.55%,压降为621.32 Pa.吸附银离子实验表明,最佳GA交联浴配比为GA(vol%)=3.5%.紫外可见光谱(UV)及透射电镜(TEM)表征证明,有10 nm左右纳米银生成.抑菌实验表明,载银PET/CTS复合纳米纤维膜对金黄色葡萄球菌(S.a.)和大肠杆菌(E.coli.)的杀菌率分别为99.97%和99.99%.     

NUMERICAL SIMULATION WITH A COMPREHENSIVE CHEMICAL TRANSPORT MODEL OF NITRATE, SULFATE, AND AMMONIUM AEROSOL DISTRIBUTIONS OVER EAST ASIA

The transport and chemical production processes of nitrate, sulfate, and ammonium aerosols over East Asia were investigated by use of the Models-3 Community Multi-scale Air Quality （CMAQ） modeling system coupled with the Regional Atmospheric Modeling System （RAMS）. For the evaluation of the model＇s ability in depicting their 3-dimensional concentration distributions and temporal variations, modeled concentrations of nitrate, sulfate, and ammonium aerosols are compared with the observations obtained at a ground station in Japan in March 2001 and onboard of an aircraft DC-8 on 18 and 21 March 2001 during the Transport and Chemical Evolution over the Pacific （TRACE-P） field campaign. Comparison shows that simulated values of nitrate, sulfate, and ammonium aerosols are generally in good agreement with their observed data, and the model captures most important observed features, and reproduces temporal and spatial variations of nitrate, sulfate, and ammonium aerosol concentrations reasonably well, e.g., the timing and locations of the concentration spikes of nitrate, sulfate, and ammonium aerosols are well reproduced, but large discrepancies between observed and simulated values are also clearly seen at some points and some times due to the coarse grid resolution and uncertainties of the emissions used in this study. This comparison results indicate that CMAQ is able to simulate the distributions of nitrate, sulfate, and ammonium aerosols and their related species in the troposphere over East Asia reasonably well.     

Effect of air gaps on ballistic resistance of targets for conical impactors

High velocity penetration of a rigid conical impactor into a ductile target with air gaps between the plates is studied using the cylindrical cavity expansion approximation describing impactor–target interaction. It is showed that the latter model predicts improvement of the ballistic performance of the target with the increase of air gaps. It is found analytically that the ballistic limit velocity of the target consisting of N plates with a fixed total thickness with large air gaps increases with the increase of N. The conditions are discussed when the predicted effects can be most pronounced.     

工业SO2及碳黑颗粒紫外成像遥感监测技术

为了准确有效监测工业烟囱排放,基于SO2及碳黑颗粒物的光学特性,设计并研制出一套双通道紫外成像遥感监测系统.该成像系统的两个光谱通道的中心波长分别定于310 nm和330 nm,利用两个通道的光学厚度之差反演SO2浓度图像,颗粒物浓度图像由330 nm通道获取,根据浓度图像结合光流法获取烟羽运动速度,进而计算得出SO2和碳黑颗粒物的排放速率.结果表明,该工业烟囱的SO2及碳黑颗粒物排放速率分别为72.48±3.16 kg/h和6.33±1.18 kg/h.实验采用紫外相机同时对工业烟囱排放的SO2及碳黑颗粒物进行监测,实验表明双通道紫外成像遥感监测兼具高时间分辨率与高空间分辨率,测量结果准确直观,在工业废气污染、船舶尾气污染以及火山喷发污染排放遥感监测中具有非常明显的技术优势及巨大的应用前景.     

Degradation of p-nitrophenol (PNP) in aqueous solution by mFe/Cu-air-PS system

In this study, batch experiments were conducted to investigate the performance of microscale Fe/Cu bimetallic particles-air-persulfate system (mFe/Cu-air-PS) for p-nitrophenol (PNP) treatment in aqueous solution. The results indicate that toxic and refractory PNP in aqueous solution could be decomposed effectively and transformed into lower toxicity intermediates.