油-气-水三相流超声传感器持气率测量*

为探索油-气-水三相流持气率测量难题,该文开展了脉冲透射式超声传感器持气率测量动态实验研究。首先,利用超声传感器与光纤传感器组合,测取了油-气-水三相流中段塞流、混状流、泡状流的响应信号;其次,提取了超声脉冲信号的最大值序列来反映不同流型时超声传感器响应特性,同时,借助双头光纤传感器与相关测速法,计算得到了流体中气泡弦长序列;最后,结合流型与泡径信息,利用超声传感器测量了不同流型下持气率,并分析了不同流型持气率预测的误差来源,为其他油-气-水三相流持气率测量传感器设计提供了借鉴。     

基于CARS技术的超燃冲压发动机点火过程温度测量

相干anti-Stokes Raman散射（coherent anti-Stokes Raman scattering，CARS）技术作为一种非接触测量手段，已广泛应用于多种发动机模型燃烧室温度测量及地面试验.然而，目前的工作主要集中在稳态燃烧场温度的测量，缺乏用高分辨率的单脉冲来测量瞬变的燃烧火焰温度及组分浓度的研究.基于CARS理论，结合多参数拟合算法，开发了基于MATLAB的CARS光谱计算和拟合程序CARSCF；利用McKenna平面火焰炉在不同工况下进行了温度测量，并与DLR测量结果进行对比，结果显示开发的CARSCF具有较高的测量重复性和准确性；最后将CARS技术应用于测量超燃冲压发动机点火过程中的温度测量，获取了点火过程中的温度.结果显示，在来流Mach数为3的条件下，H₂/air点火过程中温度呈现急剧上升然后缓慢下降，而CARS信号则呈现急剧上升然后急剧下降随后又缓慢上升的趋势，并且在点火过程中最高温度为1 511 K.      

Two-dimensional optical coherence tomography for real-time structural dynamical characterization

We present a two-dimensional optical coherence vibration tomography (2DOCVT) system with an ultra-precision displacement resolution of ~0.1 nm that is capable of in site real-time absolute displacement measurement of structural line vibrations. Experimental results of sinusoidal, sweep and impulse vibrations were reported. The key figures of merit such as the 2DOCVT system could obtain fast line vibration measurement without scanning and it also could be used to capture structural modal parameters in one single impulse excitation measurement without any vibration excitation input information, making it attractive for the application in low-frequency vibration measurement and response-only modal analysis.     

PN结物理特性的开放式测量实验方法研究

开放式、综合性量测实验的设计与应用,在巩固基础理论知识的同时,能够有效培养学生的动手实践能力、数据处理及分析能力,一定程度代表着大学物理实验课程的教学模式改革方向。以PN结物理特性的测量实验为例,基于通用型仪器与元器件的积木式组合,设计出简单、适用的实验电路;t=17.95℃时所采集的原始实验数据经三种模式回归分析,比较验证了PN结扩散电流与电压间遵循的玻尔兹曼分布律;计算出的玻尔兹曼常数与FD-PN-4测定仪的量测值相比,其结果说明了开放式测量实验方法的有效性。     

Electrochemical sensors for environmental gas analysis

The application of electrochemical sensors for measurement of concentration of pollutant gases in air in the part-per-billion (10⁹) range is reviewed. Performance-limiting factors, particularly the effects of extremes and of relatively rapid changes in ambient temperature and humidity, are noted. Variations in composition of the electrolyte in the meniscus at the electrode–gas interface and instability of the solid–liquid–gas contact line, causing important variations in current due to background electrode reactions, are deduced and suggested as the reason for the performance limitations. Suggestions are made for mitigation through instrument design.     

平行平板横向剪切干涉仪装调误差的矫正方法研究

对平行平板双光路横向剪切干涉仪的装调进行了研究,提出了一种矫正两个平行平板之间角度误差的方法.输出激光的波前采用Zernike多项式拟合,经过理论推导,发现两个方向差分波前求解出的倾斜像散之差与平行平板的角度误差存在线性关系,利用两个方向倾斜像散之差来矫正两个平行平板之间的角度误差.在平行平板横向剪切干涉仪的装调过程中使两个方向差分波前的倾斜像散之差为零即可以使两个方向的平行平板之间的角度误差值为零.进一步地从实验上证明了这个线性关系,对于所用的实验系统,当离焦像差为-3.224 7±0.001 8,两个方向差分波前的倾斜像散之差波动范围为±2.0×10^-3时,平行平板的角度误差可以控制在8.82″之内,高阶像差对平行平板的角度误差调节精度的影响约为1.63″.该方法具有装调简单、精确度高,易于流程化操作的优点.     

Enhanced-performance relative humidity sensor based on MOF-801 photonic crystals

We proposed an enhanced-performance relative humidity (%RH) nano-sensor based on MOF-801/TiO₂ one-dimensional photonic crystals (1DPC). The maximum reflectance-peak wavelength of it shifted obviously in the range of 20%-90% under varying %RH levels, due to the highly moisture-sensitive MOF-801 film in the 1DPC structure. It was demonstrated that the linear spectrum sensitivity of the MOF-801/TiO₂ %RH 1DPC sensor is exceeding 119 pm/%RH from 20%RH to 90% RH, and the sensitivity of reflection power variations exhibits 1.34 dB/%RH with the resolvable relative humidity variation less than 0.1%RH at 15°C. Meanwhile, the sensor shows a fast optical response time less than 100 ms with exceptional repeatability and reliability, which promises successful measurements of human respiration. Moreover, the sensor performance on the structure of 1DPC is investigated, representing a tradeoff between the sensing sensitivity and response time.     

基于数字全息的热透镜效应测量

提出一种数字全息定量测量半导体激光二极管侧面泵浦Nd∶YAG晶体热透镜效应的方法。CCD采集Nd∶YAG晶体在不同泵浦电流下的数字全息图,通过数值重建得到热透镜效应引起的相位分布及其变化过程。再由相位分布计算得到对应的热透镜焦距。实验结果表明,利用数字全息技术可以准确和有效测量热透镜效应及热透镜焦距。     

Entropic uncertainty relation of a qubit-qutrit Heisenberg spin model and its steering

We investigate the quantum-memory-assisted entropic uncertainty relation (QMA-EUR) in a Heisenberg XYZ mixed-spin (1/2, 1) model. Coupling strength, Dzyaloshinskii-Moriya (DM) interaction and inhomogeneous magnetic field, respectively, contributing to QMA-EUR by a thermal entanglement in the hybrid-spin model are studied in detail. Furthermore, we compare the uncertainty of the bipartite hybrid model with those of qubit-qubit and qutrit-qutrit systems. Meanwhile, the effects of local PT-symmetric operation and weak measurement on the steering of entropic uncertainty are analyzed. We find that the local PT-symmetric operation can reduce the entropic uncertainty, and the entropic uncertainty can also be decreased by weak measurement reversal.     

基于机器视觉的刀具轮廓在线检测方法的研究

超精密单点金刚石车削过程中需要对刀具参数进行检测。基于机器视觉原理,采用新型的机械结构设计了新型刀具在线检测系统。通过垂直放置的两组由同轴远心镜头和CMOS相机组成的光学系统来获取车刀刀尖正面及侧面的图像,再经图像处理系统来获取刀具的轮廓及位置信息,完成对刀具轮廓及位置的在线检测,实验验证可实现测量的重复性定位精度达1μm。在线检测的方式借助了超精密车床自身的高精度和运动机构,可以保证相机焦点和机床主轴之间的相对位置关系,弥补了目前刀具检测系统稳定性差和重复性精度低的不足,提高了加工的整体效率。