石英晶体板非线性高频振动的拓展伽辽金法分析

针对考虑几何和材料非线性的石英晶体板厚度剪切振动和弯曲振动的方程组,利用扩展伽辽金法对该方程组进行转化和求解,分别获得了强烈耦合的厚度剪切振动模态和弯曲振动模态的频率响应关系,绘制了不同振幅比和不同驱动电压影响下的频率响应曲线图。数值计算结果表明可以选取石英晶片的最佳长厚比尺寸来避免两种模态的强烈耦合。驱动电压的变化将引起石英晶体谐振器厚度剪切振动频率的明显改变,必须将振动频率的漂移值控制在常用压电声波器件的允许值之内。扩展伽辽金法对石英晶体板非线性振动方程组的求解为非线性有限元分析和偏场效应分析奠定了基础。     

Piezoelectric Nanogenerator Based on Electrospun Cellulose Acetate/Nanocellulose Crystal Composite Membranes for Energy Harvesting Application

Nanogenerators, as the typical conversion of mechanical energy to electrical energy devices, have great potential in the application of providing sustainable energy sources for powering miniature devices. In this work, cellulose acetate/cellulose nanocrystal(CA/CNC) composite nanofiber membranes were prepared by electrospinning method and then utilized to manufacture a flexible pressure-driven nanogenerator. The addition of CNC not only increased the content of piezoelectric cellulose I crystallization but also strengthened the mechanical deformation of the nanofiber membranes, which could greatly enhance the piezoelectric performance of CA/CNC composite membranes. The CA/CNC composite nanofiber membrane with 20%(mass fraction) of CNC(CA/CNC-20%) showed optimal piezoelectric conversion performance with the output voltage of 1.2 V under the force of 5 N(frequency of 2 Hz). Furthermore, the output voltage of the CA/CNC-20% nanogenerator device exhibited a linear relationship with applied impact force, indicating the great potential in pressure sensors.     

Development of a Chitosan/Nickel Phthalocyanine Composite Based Conductometric Micro-sensor for Methanol Detection

Thin-film composite of chitosan/nickel phthalocyanine (NiPc) was electrochemically deposited on the fingers of interdigitated gold electrodes, applying chronoamperometric polymerization technique. The presence of crystallized NiPc in the chitosan was confirmed by EDX and FTIR analysis. Acetone, ethanol, and methanol gas-sensing properties of the films prepared at optimum conditions were studied at atmospheric temperature, through differential measurements at an optimized frequency of 10 kHz, using a lock-in amplifier. The conductometric sensor presents the highest sensitivity of 60.2 μS.cm⁻¹(v/v) for methanol and 700 ppm as the limit of detection. For validation, the methanol content of a commercial rubbing alcohol was determined.     

Diffusion Model of a Non-Integer Order PIγ Controller with TCP/UDP Streams

In this article, a way to employ the diffusion approximation to model interplay between TCP and UDP flows is presented. In order to control traffic congestion, an environment of IP routers applying AQM (Active Queue Management) algorithms has been introduced. Furthermore, the impact of the fractional controller PIγ and its parameters on the transport protocols is investigated. The controller has been elaborated in accordance with the control theory. The TCP and UDP flows are transmitted simultaneously and are mutually independent. Only the TCP is controlled by the AQM algorithm. Our diffusion model allows a single TCP or UDP flow to start or end at any time, which distinguishes it from those previously described in the literature.     

PSO-LSSVM对LIBS定量分析精度的提高

针对土壤定量分析受基体效应影响大，LIBS定量分析精度不佳等问题，采用粒子群算法对LSSVM进行优化，提高模型的精确度。选取Pb Ⅰ 405.78 nm和Cr Ⅰ 425.44 nm作为分析谱线进行分析。采集十二个不同浓度样品的特征光谱，每个浓度样品在不同点采集20组数据，将其中17组数据设为训练集，3组数据设为预测集，用LSSVM和PSO-LSSVM两种方法建立定标模型。对比两种模型的拟合相关系数（R2）、训练集均方根误差（RMSEC）和预测集均方根误差(RMSEP)。由于自吸收效应的影响，随着浓度的增加，预测值逐渐低于实际值，LSSVM定标模型的拟合程度较低，无法达到实验要求，模型性能有待提高。利用粒子群算法对LSSVM的模型参数惩罚系数和核函数参数进行优化，得到最佳的参数组合，Pb元素为(8 096.8, 138.865 7)，Cr元素为(4 908.6, 393.563 5)，用最佳的参数组合构建LSSVM的定标模型。相比于LSSVM，PSO-LSSVM定标模型的精确度更高，Pb和Cr元素的R2提高到了0.982 8和0.985 0，拟合效果明显提升。Pb和Cr元素的训练集均方根误差由0.026 0 Wt%和0.027 2 Wt%下降到0.022 4 Wt%和0.019 1 Wt%，预测集均方根误差由0.101 8 Wt%和0.078 8 Wt% 下降到0.045 8 Wt%和0.042 0 Wt%，模型的稳定性进一步提高。说明PSO-LSSVM算法能够更好地降低土壤基体效应和自吸收效应带来的影响，提高分析结果的精确度与稳定性。     

Negative thermal expansion in NbF_3 and NbOF_2:A comparative theoretical study

Thermal expansion control is always an obstructive factor and challenging in high precision engineering field. Here,the negative thermal expansion of Nb F_3 and Nb OF_2 was predicted by first-principles calculation with density functional theory and the quasi-harmonic approximation(QHA). We studied the total charge density, thermal vibration, and lattice dynamic to investigate the thermal expansion mechanism. We found that the presence of O induced the relatively strong covalent bond in Nb OF_2, thus weakening the transverse vibration of F and O in Nb OF_2, compared with the case of Nb F_3.In this study, we proposed a way to tailor negative thermal expansion of metal fluorides by introducing the oxygen atoms.The present work not only predicts two NTE compounds, but also provides an insight on thermal expansion control by designing chemical bond type.     

Dynamic Modeling of the Feed Drive System of a CNC Metal Cutting Machine

Studying the vibrational behavior of feed drive systems is important for enhancing the structural performance of computer numerical control (CNC) machines. The preload on the screw and nut position have a great influence on the vibration characteristics of the feed drive as two very important operational conditions. Rotational acceleration of the screw also affects the performance of the CNC feed drive when machining small parts. This paper investigates the influence of preload and nut position on the vibration characteristics of the feed drive system of a CNC metal cutting machine in order to be able to eliminate an observed resonance occurred at high rotational speeds of the screw, corresponding to high feed rates. Additionally, rational structural parameters of the feed drive system are selected in order to increase the rotational acceleration for improving the performance of the CNC machine. Experiments and analyses showed that by selecting specific parameters of feed drive system and simultaneously applying a certain value of preload, a 97% increase in rotational acceleration and 30% time reduction considering the vibration resistance at high rotational speeds can be achieved.     

对称向量拟均衡问题有效解的存在性

利用标量化方法建立对称向量拟均衡问题有效解的存在性定理。作为标量化方法的应用，利用这一方法得到向量变分不等式和拟向量变分不等式有效解的存在性定理。     

Removal of single and dual ring thiophene’s from dodecane using cavitation based processes

Utilising cavitation for enhancing oxidative desulphurization has been investigated for nearly-two decades with recent investigations shifting focus from low-capacity acoustic cavitation (AC) to scalable hydrodynamic cavitation (HC). This work focuses on developing a viable means for removing thiophene’s from fuels. In the first phase of this work, use of vortex based HC devices for removal of single and dual ring thiophenes from dodecane was investigated. HC was shown to be able to remove single ring thiophene from dodecane without using any external catalyst or additives. However, in absence of catalyst or additives, it was not possible to remove dual ring thiophenes such as dibenzothiophene using HC. Therefore, in the second phase of this work, various strategies based on use of catalyst or additives to augment cavitation based process were investigated. AC based experiments were opted for shortlisting suitable catalysts and additives for intensifying cavitation based processes. The influence of using oxidant (H₂O₂) and carboxylic acid catalysts on efficacy of removal of dual ring thiophenes is presented. Several conditions were tested, and the optimal volumetric ratios of 0.95 v/v % H₂O₂ and 6.25 v/v % HCOOH was identified and utilised throughout the remainder of the study. Regeneration of extractant which accumulates oxidised sulphur species from dodecane was also investigated using AC. The additives and process conditions reported in this work are useful for enhancing desulphurization performance.     

Stability of Multiplier Ideal Sheaves

Chinese Annals of Mathematics, Series B - In the present article, the authors find and establish stability of multiplier ideal sheaves, which is more general than strong openness.