基于内聚力模型的快速荷载下CFRP-混凝土界面剪切剥离模拟

鉴于纤维增强复合材料(Fiber Reinforced Polymer, FRP)已在混凝土结构加固中普遍应用, 能有效提高结构的承载和变形能力. 为揭示动载作用下FRP-混凝土界面的剥离机理, 本文基于ABAQUS平台, 采用内聚力模型模拟CFRP-混凝土界面层, 实现了快速荷载下CFRP-混凝土界面剥离的高效模拟. 结果表明: CFRP表面应变在加载过程中由加载端向自由端方向传递, 随着加载速率的提高, 界面承载能力也随之提高; 界面峰值剪应力也存在显著的应变率效应; 模拟结果与试验结果基本吻合, 说明了新方法的有效性.     

密度泛函理论研究MN@H_2O (M=Ga,Ge, In,Sn, Sb; N=M,Al)团簇的特性

采用密度泛函理论的B3LYP, B3P86, B1B95, P3PW91和PBE1PBE方法结合SDD, LANL2DZ和CEP-121G基组计算了d~(10)组态二聚物MN(M=Ga, Ge, In, Sn和Sb; N=M和Al)的几何结构.采用B3P86/SDD进一步研究了MN@H_2O团簇的几何结构及吸附能.结果表明,水分子结合在二聚物M_2上时,对二聚物影响较大,对水分子自身影响较小.将M_2中Ga, Ge, In, Sn或Sb替换一个原子为Al时,水分子在GeAl和SnAl上的吸附能变化较大,而在GaAl, InAl和SbAl上吸附能变化较小.另外, H_2O吸附在Ga, Ge, In, Sn和Sb上时,与吸附在Al上时,吸附能的变化不大.     

3d过渡金属掺杂M_2@Si_(20)(M=Sc-Zn)团簇的密度泛函理论研究

利用密度泛函理论(DFT)研究3d过渡金属掺杂硅团簇的几何结构和稳定性,计算了绝热电子亲和能和垂直电离能,内嵌双金属间距,自旋磁矩等.结果表明内嵌的Sc、Ti、V、Mn金属二聚体和十二面体硅笼构成了稳定的富勒烯结构,随着d电子数目的增加其内嵌的富勒烯构型有部分畸变,总体而言Si_(20)团簇掺杂双金属后稳定性得到了提高.     

超强频率梳激光场驱动下多光子共振谐波辐射的相位突变研究

本文从理论上研究了在双色频率梳激光场驱动下多光子谐波辐射光谱中的相位突变现象。我们利用Floquet理论非微扰地模拟了频率梳激光场与原子分子等量子系统的相互作用过程。谐波辐射信号是多光子偶极跃迁相干叠加的结果,通过调节频率梳激光场间的相对相位,可以相干地控制谐波辐射信号的强度。通过对谐波信号进行傅里叶变换,可以提取不同跃迁路径的相对相位信息。我们通过改变频率梳组激光场的强度和频率组分实现多光子跃迁频率,让其跨越共振跃迁频率时,谐波相位会发生突变。从而可以观测超强激光场驱动下量子系统共振跃迁频率的斯塔克能移。     

重分析 巧变形 抓特点 再换元

《中学生数学》2014年第5期刊登了康宇老师的文章《学会运用换元法》,文中总结出了利用换元法注意的四个问题,即等价性、必要性、多样性、求简性.阅后受益匪浅.因此对换元法作了进一步的研究,总结出了学好换元法必须做到：＂重分析、巧变形、抓特点、再换元＂.下面举例说明,供读者参考.     

PVT法氮化铝晶体铝面、氮面生长对比分析

在氮气环境下用PVT方法生长氮化铝过程中,氮面和铝面由于表面化学性质不同,生长的主要化学反应速度存在差异。原子在生长表面的迁移能力不同造成单晶表面生长方式差异较大。在基本相同条件下(生长温度、生长温差、生长气压、类似的籽晶、同一台生长设备)进行了铝、氮面氮化铝单晶晶体生长。为了更明显地表现铝氮面的差异,将同一片籽晶分为两半,翻转其中一半让铝氮面同时生长。铝面生长较好的区域形成了明显的晶畴,而氮面生长时生长较好的部分出现了明显的生长台阶,并出现了晶畴边界被生长台阶湮灭的生长现象,进一步通过AFM观测到铝面生长台阶平整但被缺陷所阻隔,晶畴发育明显为各晶畴独立生长。氮面生长台阶没有铝面规则但连续性较强,在原来晶畴边界位置也出现了连续的生长台阶(或台阶簇)。所以籽晶质量不高时氮面生长更容易提高晶体质量,后续的XRD测量结果也证明了氮面生长后的晶体质量明显高于铝面生长的晶体质量。     

石墨烯负载的氧配位钴单原子稳定金属锂负极

Lithium (Li)-based batteries are the dominant energy source for consumer electronics, grid storage, and electrified transportation. However, the development of batteries based on graphite anodes is hindered by their limited energy density. With its ultrahigh theoretical capacity (3860 mAh∙g⁻¹), low redox potential (−3.04 V), and satisfactorily low density (0.54 g∙cm⁻³), Li metal is the most promising anode for next-generation high-energy-density batteries. Unfortunately, the limited cycling life and safety issues raised by dendrite growth, unstable solid electrolyte interphase, and "dead Li" have inhibited their practical use. An effective strategy is to develop a suitable lithiophilic matrix for regulating initial Li nucleation behavior and controlling subsequent Li growth. Herein, single-atom cobalt coordinated to oxygen sites on graphene (Co-O-G SA) is demonstrated as a Li plating substrate to efficiently regulate Li metal nucleation and growth. Owing to its dense and more uniform lithiophilic sites than single-atom cobalt coordinated to nitrogen sites on graphene (Co-N-G SA), high electronic conductivity, and high specific surface area (519 m²∙g⁻¹), Co-O-G SA could significantly reduce the local current density and promote the reversibility of Li plating and stripping. As a result, the Co-O-G SA based Li anodes exhibited a high Coulombic efficiency of 99.9% at a current density of 1 mA∙cm⁻² with a capacity of 1 mAh∙cm⁻², and excellent rate capability (high current density of 8 mA∙cm⁻²). Even at a high plating capacity of 6 mAh∙cm⁻², the Co-O-G SA electrode could stably cycle for an ultralong lifespan of 1300 h. In the symmetric battery, the Co-O-G SA based Li anode (Co-O-G SA/Li) possessed a stable voltage profile of 18 mV for 780 h at 1 mA∙cm⁻², and even at a high current density of 3 mA∙cm⁻², its overpotential maintained a small hysteresis of approximately 24 mV for > 550 h. Density functional theory calculations showed that the surface of Co-O-G SA had a stronger interaction with Li atoms with a larger binding energy, −3.1 eV, than that of Co-N-G SA (−2.5 eV), leading to a uniform distribution of metallic Li on the Co-O-G SA surface. More importantly, when matched with a sulfur cathode, the resulting Co-O-G SA/lithium sulfur full batteries exhibited a high capacity of 1002 mAh∙g⁻¹, improved kinetics with a small polarization of 191 mV, and an ultralow capacity decay rate of 0.036% per cycle for 1000 cycles at 0.5C (1C = 1675 mA∙g⁻¹) with a steady Coulombic efficiency of nearly 100%. Therefore, this work provides novel insights into the coordination environment of single atoms for the chemistry of Li metal anodes for high-energy-density batteries.     

一厘米的毛毛

正小虫毛毛住在花园里,他能轻而易举地爬上高处,一边轻咬,一边测量他的宝贝们:西葫芦、茄子,还有荷兰豆。他的测量方法很简单:他每爬一下身体就会蜷成一个圈儿,这就是1厘米。他从一头开始爬,蜷成多少个圈儿就是多少厘米,这可是个很精确的测量方法哦!"扭来扭去的虫虫,一圈儿又一圈儿。什么都能测量,一环又一环。""7厘米的辣椒,8厘米的豌豆,还有刚长出3厘米的小青菜。"     

吲哚咔唑类异构体芳香性的研究

分别采用拓扑共振能(E_TR)和环电流(RC)方法对吲哚咔唑类化合物的全局芳香性进行了研究.根据E_TR结果,预测所有化合物都具有芳香性.分别用键共振能(BRE)和回路共振能(CRE)方法揭示了它们的局部芳香性.BRE和CRE研究结果表明,在吲哚咔唑类化合物中,由于六元环内电子的离域化程度比五元环内电子的离域化程度强,因此六元环比五元环表现出较强的局部芳香性.此外,外部六元环比中间六元环具有较强的局部芳香性.计算得到的RC结果表明,所有化合物都产生反磁性环电流,化合物产生的反磁性RC强度与它们的¹H NMR化学位移之间具有很好的一致性.