The Effect of the Spacer of Bis(biurea) Ligands on the Structure of A2L3‐type (A=anion) Phosphate Complexes

By tuning the length and rigidity of the spacer of bis(biurea) ligands L, three structural motifs of the A₂L₃ complexes (A represents anion, here orthophosphate PO₄^3?), namely helicate, mesocate, and mono‐bridged motif, have been assembled by coordination of the ligand to phosphate anion. Crystal structure analysis indicated that in the three complexes, each of the phosphate ions is coordinated by twelve hydrogen bonds from six surrounding urea groups. The anion coordination properties in solution have also been studied. The results further demonstrate the coordination behavior of phosphate ion, which shows strong tendency for coordination saturation and geometrical preference, thus allowing for the assembly of novel anion coordination‐based structures as in transition‐metal complexes.     

Nano-tribological study on a super-hydrophobic film formed on rough aluminium substrates

A novel super-hydrophobic stearic acid (STA) film with a water contact angle of 166^o was prepared by chemical adsorption on aluminum wafer coated with polyethyleneimine (PEI) film. The micro-tribological behavior of the super-hydrophobic STA monolayer was compared with that of the polished and PEI-coated Al surfaces. The effect of relative humidity on the adhesion and friction was investigated as well. It was found that the STA monolayer showed decreased friction, while the adhesive force was greatly decreased by increasing the surface roughness of the Al wafer to reduce the contact area between the atomic force microscope (AFM) tip and the sample surface to be tested. Thus the friction and adhesion of the Al wafer was effectively decreased by generating the STA monolayer, which indicated that it could be feasible and rational to prepare a surface with good adhesion resistance and lubricity by properly controlling the surface morphology and the chemical composition. Both the adhesion and friction decreased as the relative humidity was lowered from 65% to 10%, though the decrease extent became insignificant for the STA monolayer. The project supported by the National Natural Science Foundation of China (50375151, 50323007, 10225209) and the Chinese Academy of Sciences (KJCX-SW-L2)     

Status of heavy element research using a gas-filled recoil separator at RIKEN

A gas-filled type of recoil separator for heavy element research was installed at an experimental hall of RIKEN Linear Accelerator facility to realize getting higher intensity of primary beam and long beam time. Performance of the separator was studied using target recoils and various nuclear reactions. The results show the high performance of the separator for heave element research. As an application of the GARIS, production and identification of an isotope of the 110th element ²⁷¹[110] have been performed using the ²⁰⁸Pb(⁶⁴Ni,1n)²⁷¹[110] reaction. Three decay chains coincide well both in decay times and energies with the ones reported by the group of SHIP experiment at GSI, Germany. Our results provide a confirmation of the synthesis of an isotope ²⁷¹[110] of element 110.     

A Quantum Chemical Study on Recognition of Nitro-phenols by Calix[n]arenes

A PM3 calculation in vacuum of the inclusion complexation ofo-, m-, p-nitro-phenol with calix[n]arenes is performedsuccessfully. The pathways for inclusion process are describedand the most probable structures of the 1:1 complex are soughtthrough a potential energy scan. The energy differences betweenthe inclusion complexes and the hosts, by calculation, show thatthe most stable complexation is calix[4]-p-nitro phenol andcalix[6]-m-nitro phenol.     

Structure and mechanical properties of Al/AlN multilayer with different AlN layer thickness

Nanometer scale Al/AlN multilayers have been prepared by dc magnetron sputtering technique with a columnar target. A set of Al/AlN multilayers with the Al layer thickness of 2.9 nm and the AlN layer thickness variation from 1.13 to 6.81 nm were determined. Low angle X-ray diffraction (LAXRD) was used to analyze the layered structure of multilayers. The phase structure of the coatings was investigated with grazing angle XRD (GAXRD). Mechanical properties of these multilayers were thoroughly studied using a nanoindentation and ball-on-disk micro-tribometer. It was found that the multilayer hardness and reduced modulus showed no strong dependence on the AlN layer thickness. Al2.9 nm/AlN1.13 nm multilayer had more excellent tribological properties than single layers and other proportion multilayers with a lowest friction coefficient of 0.15. And the tribological properties of all the multilayers are superior to the AlN single layer.     

Ionic liquid-regulated sulfamic acid: chemoselective catalyst for the transesterification of β-ketoesters

1-Propyl-3-methylimidazolium chloride ([C₃MIm]Cl) ionic liquid and sulfamic acid (NH₂SO₃H), as a synergetic catalytic medium, were used for the transesterification of acetoacetate with alcohols of different structures. It shows the good ability for the chemoselective transesterificatin of β-ketoesters and maintains its catalytic activity in the reuse.     

Growth mechanisms of GaAs nanowires by gas source molecular beam epitaxy

GaAs nanowires were grown on GaAs (1 1 1)B substrates in a gas source molecular beam epitaxy system, using self-assembled Au particles with diameters between 20 and 800 nm as catalytic agents. The growth kinetics of the wires was investigated for substrate temperatures between 500 and 600 °C, and V/III flux ratios of 1.5 and 2.3. The broad distribution of Au particles enabled the first observation of two distinct growth regimes related to the size of the catalyst. The origins of this transition are discussed in terms of the various mass transport mechanisms that drive the wire growth. Diffusion of the growth species on the 2-D surface and up the wire sidewalls dominates for catalyst diameters smaller than ∼130 nm on average, while direct impingement on the catalyst followed by bulk diffusion through the Au particle appears to sustain the wire growth for larger catalyst diameters. A change in wire sidewall facets, indicating a probable transition in the crystal structure, is found to be primarily dependent on the V/III flux ratio.     

纳米二氧化锆制备过程的DSC、TGA和XRD研究

用ＤＳＣ、ＴＧＡ和ＸＲＤ技术研究了在沉淀法制备纳米ＺｒＯ２的过程中，残留ＮＨ４Ｃｌ、ｐＨ值、滴加方式、以及结构稳定剂Ｙ２Ｏ３的添加量对结晶过程的影响。结果表明，残留ＮＨ４Ｃｌ使结晶化温度降低，使放热过程变为吸热过程。而ｐＨ值、滴加方式和结构稳定剂的添加对结晶过程无明显影响。     

Chiral Salen Manganese Complex Immobilized on SBA-15： A New Heterogenized Enantioselective Catalyst for the Epoxidation of Alkenes

Jacobsen‘s catalyst was immobilized onto SBA-15 by multi-step grafting, and this heterogenized catalyst exhibited comparable catalytic performance with the corresponding homogeneous counterpart for the epoxidation of alkenes, and the catalyst could be recycled effectively several times.     

付里叶变换红外光谱仪的操作参数对光谱的影响

本文以二苯基甲酮的ＫＢｒ压片为标样，在Ｂｒｕｋｅｒ ＩＦＳ １２０ＨＲ付里叶变换红外光谱仪上系统考察了该仪器折一些重要操作参数（光源光栏、切趾函数、扫描速度）对光谱质量（信噪比，分辨率）的影响。从而获得了测样时的优化操作条件。