排序方式: 共有34条查询结果,搜索用时 15 毫秒
1.
V2O5纳米片固载Pt纳米粒子催化剂的构建及其增强催化空气氧化脱硫性能 总被引:1,自引:0,他引:1
以铂系金属为代表的贵金属催化剂在工业反应中通常表现出优异的催化性能,这是因为其具有独特的d带电子结构和较高的价电子比.近年来,由于大气排放法规愈发严苛,铂系贵金属催化剂在催化空气氧化燃油脱硫方面的研究引起了广泛关注.在该催化反应中,铂系金属纳米粒子可以有效活化空气中的氧气,产生的活性氧物种可以将油品中的噻吩类硫化物氧化为其对应的强极性砜类物质,从而可以将其从非极性的油品中分离出来,有效实现油品中硫化物的深度氧化脱除.然而,在反应过程中铂系贵金属纳米粒子易发生流失和烧结,从而导致催化剂的失活.因此,急需寻找一类可以有效固载铂系贵金属纳米粒子的载体.在目前已报道的众多载体中,以ZrO2、TiO2、CeO2、ZnO等为代表的过渡金属氧化物引起了广泛的关注.通常认为,铂系贵金属纳米粒子的d轨道电子和过渡金属氧化物之间可形成金属-载体强相互作用.然而,目前所使用的过渡金属氧化物载体的比表面积较小,从而导致铂系贵金属纳米粒子难以有效且均匀地分散于其表面.本文采用热膨胀气相剥离法制备了超薄V2O5纳米片,并通过超声辅助沉积法将Pt纳米粒子固载于其表面,从而得到一系列可高效活化空气氧化脱硫的催化剂(Pt NPs-n/V2O5纳米片).通过电感耦合等离子体光谱、高倍透射电镜、原子力显微镜、X射线光电子能谱、X射线衍射、拉曼光谱和氮气吸附脱附等方法对催化剂的结构和形貌进行了表征.结果表明,尺寸为4-5 nm的Pt纳米粒子可有效均匀分散于层数约为6层的V2O5纳米片表面;在空气氧化脱硫反应中,当催化剂中Pt理论负载量为2 wt%时,反应5 h后,油品的脱硫率可达99.1%,实现了硫化物的深度氧化脱除.该反应体系对不同硫浓度、不同含硫底物的油品均有较好的脱除效果,但对含有烯烃、芳烃的油品脱除效果较差.此外,催化剂循环使用7次后,其脱硫活性仍无明显下降,表现出优异的重复使用性能.对反应后的催化剂进行表征,发现Pt几乎不发生流失,这可能是由于Pt纳米粒子和V2O5纳米片之间形成了金属-载体强相互作用.该结果为其他空气氧化反应的有效进行提供了新思路. 相似文献
2.
基于紫外光谱结合膜富集技术,提出了一种快速、灵敏检测自来水中2-萘酚的方法。以尼龙滤膜(孔径0.22μm)为富集材料,将富集到膜上的2-萘酚不经洗脱直接测定其漫反射紫外光谱,以实现定量分析目的。该方法方便快捷,大大提高了灵敏度。对p H值、样品体积和真空度等条件进行优化,并对方法的分析性能进行了评价。结果显示,2-萘酚的浓度与吸光度(波长为331 nm)在0.3~10 mg/L范围内用二次函数可得到良好的拟合关系,在0.3~1.0 mg/L和1.0~10 mg/L范围内呈分段的线性关系,相关系数(r2)分别为0.999 1和0.995 5。在最佳条件下,检出限达0.265 6 mg/L。该方法准确度和精密度较理想,适用于对自来水中2-萘酚的检测。 相似文献
3.
New experimental measurement of natSe(n, γ) cross section between 1 eV to 1 keV at the CSNS Back-n facility 下载免费PDF全文
Xin-Rong Hu 《中国物理 B》2022,31(8):80101-080101
The 74Se is one of 35 p-nuclei, and 82Se is a r-process only nucleus, and their (n, γ) cross sections are vital input parameters for nuclear astrophysics reaction network calculations. The neutron capture cross section in the resonance range of isotopes and even natural selenium samples has not been measured. Prompt γ-rays originating from neutron-induced capture events were detected by four C6D6 liquid scintillator detectors at the Back-n facility of China Spallation Neutron Source (CSNS). The pulse height weighting technique (PHWT) was used to analyze the data in the 1 eV to 100 keV region. The deduced neutron capture cross section was compared with ENDF/B-VIII.0, JEFF-3.2, and JENDL-4.0, and some differences were found. Resonance parameters were extracted by the R-matrix code SAMMY in the 1 eV-1 keV region. All the cross sections of natSe and resonance parameters are given in the datasets. The datasets are openly available at http://www.doi.org/10.11922/sciencedb.j00113.00019. 相似文献
4.
5.
臧宏亮 叶沿林 李智焕 王建松 楼建玲 李奇特 葛愉成 杨晓菲 李晶 蒋伟 冯俊 刘强 杨彪 陈志强 刘洋 吴鸿毅 牛晨阳 李晨光 王春光 王翔 刘威 高见 余翰舟 马军兵 马朋 白真 杨彦云 金仕纶 卢飞 《中国物理C(英文版)》2018,42(7):074003-074003
An experiment for p(~(14)C,~(14)C~*→~(10)Be+α)p inelastic excitation and decay was performed in inverse kinematics at a beam energy of 25.3 Me V/u.A series of~(14)C excited states,including a new one at 18.3(1)Me V,were observed which decay to various states of the final nucleus of~(10)Be.A specially designed telescope system,installed around zero degrees,played an essential role in detecting the resonant states near theα-separation threshold.A state at 14.1(1)Me V is clearly identified,being consistent with the predicted band-head of the molecular rotational band characterized by theπ-bond linear chain configuration.Further clarification of the properties of this exotic state is suggested by using appropriate reaction tools. 相似文献
6.
李朋杰 李智焕 陈志强 吴鸿毅 田正阳 蒋伟 李晶 冯骏 臧宏亮 刘强 牛晨阳 杨彪 陶龙春 张允 孙晓慧 王翔 刘洋 李奇特 楼建玲 李湘庆 华辉 江栋兴 叶沿林 《原子核物理评论》2017,34(2):177-183
介绍了利用硅探测器的脉冲形状甄别进行粒子鉴别的原理。详细叙述了基于数字化方法的脉冲形状甄别的实现。采样频率和位数是数字化方法的两个重要参数。对于硅探测器信号,采用100 MS/s,12 bit的Digitizer可以满足脉冲形状甄别法对时间分辨的要求。同时对该方法粒子鉴别的特征和能量阈值做了简要的分析和对比。粒子背面入射硅探测器的所得的阈值低于正面入射的情况。例如对于氖周围的同位素,背面入射情况的阈值约为100 MeV,为正面入射情况下鉴别阈值的二分之一,相当与ΔE-E方法中ΔE探测器厚度约为60 μm情况下的阈值。最后定性讨论了硅探测器的电阻率不均匀性和沟道效应对粒子鉴别性能的影响。In this paper Pulse Shape Discrimination(PSD) for silicon detector has been briefly introduced. The emerging digital method successfully applied to detector signal processing makes digital PSD method one of the most promising particle identification methods. Sampling frequency and the number of bits are two key parameters of digital method. For silicon detector signal, adopting 100 Ms/s, 12 bit Digitizer can satisfy the time resolution requirement of PSD method. The identification characteristic and energy threshold of this method have been discussed and compared with both front injection and rear injection cases. Energy threshold with rear injection usually is much lower than that with front injection. For example, around for Neon isotope energy threshold with rear injection is about 100 MeV which is only half of the threshold with front injection, also equivalent to thickness of about 60 μm silicon detector threshold in ΔE-E method. At the end the impact of silicon detector's resistivity nonuniformity and channel effect on the identification capacity of PSD method has been discussed in detail. 相似文献
7.
8.
9.
基于磁共振与荧光成像的双模态成像技术不仅克服了传统单一分子影像技术在灵敏度、特异度、分辨率等方面的固有缺陷,更是拓宽了分子影像技术在诊断及治疗监控等领域的研究范围及应用前景。本文将对磁共振/荧光双模态分子探针的应用情况和研究进展等进行综述。 相似文献
10.
王德鑫 张苏雅拉吐 蒋伟 任杰 王金成 唐靖宇 阮锡超 王宏伟 陈志强 黄美容 唐鑫 胡新荣 李鑫祥 刘龙祥 刘丙岩 孙慧 张岳 郝子锐 宋娜 李雪 牛丹丹 利国 蒙古夫 《物理学报》2022,(7):89-96
C6D6闪烁体探测系统结合脉冲权重技术被广泛应用于中子俘获反应截面测量研究.实验中采用的样品厚度直接影响中子束流时间,同时也影响实验数据的可靠性.本文基于中国散裂中子源反角白光束线(CSNS Back-n)C6D6探测系统,对比研究了不同厚度的镥(Lu)样品中子俘获反应截面的实验测量.利用GEANT4蒙特卡罗程序模拟了考虑样品厚度的探测系统光响应,计算出精确的脉冲权重函数.实验中,通过采用较长中子飞行距离和本底测量,得到了高精度的共振区产额分布.通过R矩阵理论分析产额分布,得到了相应的实验共振参数.结果发现,较厚Lu样品因其厚度效应导致共振曲线发生变化,实验共振参数与ENDF/B-Ⅷ.0评价数据库差距较大;然而,较薄Lu样品实验结果能够很好地再现ENDF/B-Ⅷ.0评价数据. 相似文献