C2H4的微波场助气相光催化氧化

用溶胶-凝胶法制备了多孔性TiO     

乙烯在纳米催化剂InVO4-TiO2上的可见光降解

The InVO₄-TiO₂ nano-crystalline photocatalyst was prepared by sol-gel method and characterized by DRS, FTIR, Raman and XRD. The photocatalytic activities of the prepared sample were investigated by photocatalytic degradation of ethylene in the gaseous phase under visible light irradiation (λ>450 nm). The results indicate that both of pure TiO₂ and InVO₄ or their simple mixture show no photocatalytic activities for degradation of ethylene under visible light irradiation. However, as-synthesized InVO₄-TiO₂ catalyzes the degradation of ethylene into CO₂ under visible light irradiation. In addition, the interaction between InVO₄ and TiO₂ results in some structural distortion to all the crystal forms of TiO₂ in as-synthesized catalyst InVO₄-TiO₂.     

低能C36团簇在金刚石(100)晶面沉积时的影响因素

"使用Brenner-LJ拟合势描述了金刚石与C36团簇原子间的相互作用,并用分子动力学模拟的方法研究单个C36(D6h)在金刚石(100)晶面的沉积机制．通过仿真实验分析了C36团簇的入射能量、入射点位置、入射姿势、入射角度等因素对其成核初期化学吸附过程以及沉积后其稳定性的影响．研究发现：由于C36入射点位置及入射姿势的不同,其在金刚石(100)晶面沉积时的沉积阈值最小值为20 eV,最大值为60 eV;在入射角不超过60o斜射时,由于水平运动分量的存在,C36可能翻滚及平滑至成键能量较小的区域后再成键     

原位红外光谱法研究La/TiO2对有机污染物的光催化降解

本工作采用改进的溶胶-凝胶法和浸渍法制备了TiO₂掺杂稀土离子La³⁺的La/TiO₂光催化剂，运用XRD、N₂吸附脱附、紫外可见漫反射光谱(DRS)、表面光电压谱(SPS)等手段进行表征，同时利用原位红外技术考察了La/TiO₂样品光催化降解乙烯、丙酮、苯的气-固相光催化氧化反应，对其光催化降解有机污染物的过程进行了研究。结果表明，TiO₂经适量La³⁺掺杂后，锐钛矿晶型的含量增加，晶粒度减小，比表面积增大，禁带宽度增加，表面光电压信号增强，光生电子-空穴对有效分离；La/TiO₂样品对乙烯、丙酮、苯的光催化性能与纯TiO₂相比均有不同程度的改善，乙烯可以被光催化氧化完全矿化生成CO₂，而丙酮被光催化氧化可能生成中间产物丙酸，苯被光催化氧化可能生成中间产物苯酚和苯醌。     

形态结构和光电特性对纳米TiO2光催化性能的影响

采用sol-gel法制备了系列纳米TiO2光催化剂,运用X射线衍射、BET比表面测定、紫外漫反射吸收光谱和表面光电压谱等手段对催化剂进行表征,并以乙烯作为光催化反应的指标反应分子,研究了TiO2纳米晶的性质对于光催化活性的影响.随着焙烧温度的升高,TiO2的晶粒逐渐增大,比表面积下降,晶相由锐钛矿向金红石转变,其吸收带边与光伏响应阈值向长波方向移动,氧化－还原能力降低,降解乙烯的转化率迅速下降.     

单分散纳米InVO4(正交相)的低温合成

InVO₄ is a new developed visible light responding photocatalyst for water decomposition, which is obtained by a solid-state reaction at high temperature traditionally. In this paper, pure InVO₄ nano-crystalline powder has been prepared by a hydrothermal process at low temperature and was characterized by TEM, IR, and X-ray diffraction. Many factors such as pH value, reaction time and temperature have been investigated. It is found that the optimal conditions for the preparation is: n_InCl3∶n_NaVO3=1∶2; temperature : 150 ℃; Reaction time: 4～8 h; pH=7.9～8.0. And the experimental result shows that it is a convenient way to get single dispersing InVO₄ nano-crystalline powder by flux in alkyl alcohol.     

异质结型光催化膜的活性及其机理研究

采用浸渍提拉法制得Ti02,ZnO,Fe2O3,ZnO／TiO2,TiO2／ZnO,Fe2O3／TiO2和TiO2／Fe2O3石英玻璃基底负载膜．光催化降解亚甲基蓝实验表明,TiO2和ZnO具有良好的光催化活性,Fe2O3活性较差．但形成异质结后,TiO2和Fe2O3的光催化降解能力发生明显的变化．用254nm紫外光光照后．TiO2。ZnO和Fe2O3等3种氧化物膜与水的接触角均有不同程度的降低,TiO2表现出超亲水性,ZnO／Ti02和Fe2O3／TiO2膜与水的接触角小于对应的单纯ZnO和Fe2O3膜与水的接触角,其中Fe2O3／TiO2表面出现超亲水性．瞬态光电导谱的少数载流子寿命的测定表明,异质结势垒电场能有效地增强光生电子一空穴对的分离效率．根据能带理论建立的两组异质结能带模型可合理地解释实验结果．     

用椭圆偏光法研究硅中砷离子注入的损伤和退火效应

我们用椭圆偏光法对As⁺离子注入Si的损伤和退火效应进行了测量。对As⁺注入能量为150keV、注入剂量为10¹⁶cm^-2的情况,测得的折射率分布呈现平台型,表明出现了非晶质层。在600—700℃间有一转变温度,高于此温度退火,可消除非晶质层。实验结果表明椭圆偏光法亦是测定辐射损伤的有用工具。 关键词：     

RE/TiO2光催化剂的谱学特性与气相光催化性能的研究

采用改进的sol-gel法和浸渍法制备了TiO₂掺杂稀土离子La³⁺、Y³⁺、Gd³⁺、Er³⁺、Nd³⁺、Pr³⁺的RE/TiO₂光催化剂,运用FTIR、XRD、TEM、低温氮吸附/脱附、TG/DTA、UV-Vis DRS、表面光电压谱(SPS)等进行表征,以气相光催化降解乙烯、溴代甲烷作为探针反应,阐明了RE/TiO₂光催化剂的谱学特性与气相光催化性能的关系。结果显示,稀土离子掺杂后,TiO₂的锐钛矿含量增加,比表面积增大,粒径变小,吸收边发生蓝移,表面光电压的响应阈值增大,此外,Pr³⁺除外的其它稀土离子掺杂的TiO₂的表面光电压信号增强;光催化降解实验表明,与纯TiO₂相比,La³⁺、Y³⁺、Gd³⁺、Er³⁺、Nd³⁺掺杂TiO₂样品上乙烯、溴代甲烷的光催化活性均有不同程度的增强,而且表现出较强的矿化能力。但是,掺杂Pr³⁺的TiO₂的光催化性能降低恰好对应较弱的表面光电压信号。所以,本文认为提高光生电子-空穴对的分离效率是改善光催化性能的关键因素。     

Deposition mechanism of nano-structured single-layered C36 film on a diamond （100） crystal plane

The Brenner-LJ potential is adopted to describe the interaction between C36 clusters and diamond surface, and the deposition mechanism of multi-C36 clusters on the diamond surface is also studied by using the method of molecular dynamics simulation. The simulation results show that the competition effects of two interactions, i.e. the interaction between cluster and cluster and the interaction between cluster and crystal plane, are studied, and then the influence of these competition effects on C36 cluster deposition is analysed. The finding is that when an incident energy is appropriately chosen, C36 clusters can be chemically adsorbed and deposited steadily on the diamond surface in the form of single-layer, and in the deposition process the multi-C36 clusters present a phenomenon of energy transmission. The experimental result shows that at a temperature of 300K, in order to deposit C36 clusters into a steady nanostructured single-layered film, the optimal incident energy is between 10 and 18 eV, if the incident energy is larger than 18 eV, the C36 clusters will be deposited into an island nano-structured film.