排序方式: 共有33条查询结果,搜索用时 16 毫秒
1.
利用一套罗斯滤片系统测量激光轰击固体金属Ti平面靶产生的X射线辐射通量,系统包括两个相同的X射线探测器及相应滤膜。罗斯滤片法的优点在于利用相邻核素对X射线相似的阻止率,可滤出一个窄的能带并去除高能部分的干扰,获得了Ti平面靶K壳层X光辐射产额。实验结果表明:硬X射线能段在4.5~4.9keV之间的K壳特征辐射占优,连续谱所占份额较低(与晶体谱仪一致);随着激光能量的增加,特征辐射增加;激光强度接近2×1015 W/cm2时,能量转换效率出现峰值。 相似文献
2.
3.
Z-pinch experiments with two arrays consisting, respectively, of 32
4-μm- and 6-μm-diameter tungsten wires have been carried out on
QiangGuang-1 facility with a current rising up to 1.5MA in 80ns. At early
time of implosion, x-ray framing images show that the initial emission comes
from the central part of arrays, and double clear emission rings, drifting
to the anode and the cathode at 5×106cm/s and 2.4×107cm/s respectively, are often produced near the electrodes. Later,
in a 4-μm-diameter tungsten wire array, filamentation caused by ohmic
heating is prominent, and more than ten filaments have been observed. A
radial inward shift of arrays starts at about 30\,ns earlier than the
occurrence of the x-ray peak power for both kinds of arrays, and the
shrinkage rate of emission region is as high as 1.7×107cm/s in
a 4-μm-diameter tungsten wire array, which is two times higher than
that in a 6-μm one. Emission from precursor plasmas is observed in
implosion of 6-μm-diameter tungsten wire arrays, but not in implosion
of a 4-μm-diameter tungsten wire array. Whereas, in a 4-μm-diameter tungsten wire array, the soft x-ray emission shows the growth of
m=1 instability in the plasma column, which is caused by current. The
reasons for the discrepancy between implosions of 4-μm- and 6-μm-diameter tungsten wire arrays are explained. 相似文献
4.
在Angara-5-1联合实验中,利用条纹像机和光纤阵列实现时间分辨和1维空间分辨,得到了丝阵条纹像,观察到丝阵负载箍缩区X光辐射的1维轴向空间分布信息随时间的演化过程,考察了内爆的同步性和均匀性。通过对比不同结构负载内爆等离子体X光1维时空分布信息,发现由于内层等离子体对磁流体瑞利-泰勒不稳定性的抑制作用,(40+20)根双层钨丝阵比60根单层钨丝阵的内爆轴向同步性好,产生的X光辐射功率高;由于负载存在弯曲、断丝、扭曲等现象,(60+30)根双层钨丝阵比90根单层钨丝阵的轴向同步优势不明显;轴向同步性好与辐射功率高之间存在相关性;辐射波形前沿较快时,X光功率较高。 相似文献
5.
6.
为了获得填充泡沫的钨丝阵动态黑腔动力学演化图像, 研究钨等离子体与泡沫柱的相互作用形式, 在1 MA脉冲功率装置上设计了四分幅紫外探针光(266 nm)阴影成像系统, 该系统时间分辨为2.5 ns, 静态空间分辨优于70 μm, 径向阴影图像展示了从固体丝膨胀消融到先驱等离子体与泡沫相互作用, 从泡沫的箍缩到反弹膨胀的全过程. 图像显示了在长约50 ns时间内丝等离子体以雨的形式持续与泡沫相互作用, 在整个箍缩阶段并未观察到等离子体壳层结构. 定量分析表明泡沫柱的最小箍缩速度为1.0×106 cm/s, 最大箍缩速度为6.0×106 cm/s, 在轴上滞止的直径约为1 mm. 通过对数值模拟计算结果的讨论, 明确了在Z箍缩等离子体状态下阴 影成像结果主要反映了逆轫致吸收效应, 与径向功率波形的时间关联给出了钨等离子体主体与泡沫柱相互作用时刻的图像.
关键词:
动态黑腔
阴影像
箍缩速度 相似文献
7.
在Z箍缩实验中,利用ST1432红光闪烁体、多模石英光纤探头和大电流光电倍增管探测器等研究了丝阵等离子体内爆过程中沿轴向与径向不同方位角的X光辐射功率分布。采用的负载为单层钨丝阵和单层铝丝阵,驱动电流1.5~1.8 MA,上升时间60~90 ns。实验结果表明:Z箍缩等离子体X光辐射强度有轴向和径向分布不均匀性;单层钨丝阵轴向X光辐射强度大于径向辐射强度;单层铝丝阵径向X光辐射强度大于轴向辐射强度。 相似文献
8.
本文报道了2003年在强光一号装置上进行的钨丝阵列的Z箍缩实验研究的主要结果。为了研究钨丝阵列的内爆过程和x光辐射特性,使用了x光功率谱仪和一维时空分辨x光成像系统等诊断设备。实验中由32根5微米钨丝组成的直径8mm长20mm的优化负载获得了最高能量为36.6kJ的x光产额,一维时空分辨x光成像系统的数据显示x光辐射区域以6.4×106cm/s的速度减小,同时x光峰值时刻出现在等离子体被压缩到近轴区域之前。 相似文献
9.
10.