基于含芴菲并咪唑衍生物的可湿法加工的蓝光有机电致发光器件

设计合成了一种新型A-D-A含芴菲并咪唑和炔基基团的蓝光分子( FI),采用紫外吸收、光致发光光谱和循环伏安对材料进行了表征,发现该物质具有稳定的蓝光发射。采用旋涂的方法制备了非掺杂蓝光有机发光二极管,器件的最大电流效率为1.52 cd·A-1,最大功率效率为0.63 lm·W-1.     

高效钙钛矿-有机本体异质结杂化串联太阳能电池

制备了一种有机铅卤钙钛矿-有机本体异质结杂化串联太阳能电池。采用紫外可见吸收光谱、原子力显微镜对薄膜形貌进行了表征。结果表明:有机本体异质结层可以有效改善钙钛矿的表面形貌, 增强了可见光的吸收。优化后的串联结构电池的短路电流可达19.14mA/cm², 开路电压为0.76V, 光电转换效率达到了6.54%。钙钛矿电池和有机本体异质结电池串联结构可以同时提高短路电流及填充因子, 二者具有较好的相容性和协同作用。     

A Simple Interconnection Layer for Tandem Organic Solar Cells with Improved Efficiency and Fill Factor

We demonstrate a simple interconnection layer （ICL） that can be employed in tandem organic solar cells. An ICL with an optimized structure of Ca/Au/MoO3 is used between two sub cells composed of identical regioregularpoly（3-hexylthiophen） （P3HT）：[6,6]-phenyl C61-butyric acid methylester （PCBM） photoactive layers. Power conversion efficiency （PCE） of 3.24% and fill factor （FF） of 68.0% are achieved with such an ICL under simulated sunlight （1 O0 m W. cm- 2 ）. Compared with the best values of devices with ICLs of Ca/Al/MoOa, PCE is improved by 68.9% and FF is improved by 15.5%. The improved performances are attributed to the optical and electrical balances in both sub cells. The presented ICL extracts free charges efficiently from both sub cells thereby suppressing the exaction recombination in each sub cell.     

在电子传输层中添加PVK提高钙钛矿太阳能电池的性能

为了探究PVK对倒置平面异质结钙钛矿太阳能电池电子传输层的影响,向电子传输层PCBM中添加了一种富电子的聚乙烯基咔唑(PVK).采用原子力显微镜、PL光谱对薄膜进行了表征.实验结果表明:少量PVK的添加提高了覆盖在钙钛矿薄膜上PCBM层的平整度.当PVK的添加质量分数为4%时得到最佳器件效率,相比于纯PCBM作为电子传输层的器件,器件效率由(5.11±0.14)% 提升到(9.08±0.46)%.当PVK的添加质量分数大于4%时,粗糙度又趋于变大.PL光谱显示,少量PVK的加入使钙钛矿/电子传输层薄膜的PL强度降低,并使PL峰蓝移.研究表明:向PCBM中掺杂适量PVK能够改善钙钛矿/电子传输层/Al的界面接触,减少漏电流,并能够减少钙钛矿表面陷阱和晶界缺陷,减少电荷复合,从而提高了器件性能.     

Performance of Organic Field Effect Transistors with Self-Improved Cu/Organic Interfaces

We fabricate pentacene-based organic field effect transistors （OFETs） with Cu as source and drain （S-D） electrodes. The fabricated devices stored for ten hours under ambient atmospheric conditions exhibit superior performance compared with the as-prepared devices. The field-effect mobility increases from 0. 012 to 0.03 cm^2 V^-1 s^-1, and the threshold voltage downshifts from -14 to -9 V. The on/off current ratios are close to the order of 10^4. The improved performance of the stored devices is attributed to the formation of thin Cu oxide at the Cu electrodes/organic interfaces. These results suggest a simple and available way to optimize device properties and to reduce fabrication cost for OFETs.     

以BAlq为主体的高效高色纯度的红色有机电致磷光器件

以铱配合物红色磷光体Ir(piq)₂(acac)为掺杂剂,制备了基于BAlq材料的红色电致磷光器件,其结构为ITO/NPB(30nm)/Ir(piq)₂(acac):BAlq(25nm)/BCP(13nm)/Alq₃(35nm)/LiF(1nm)/Al(1000nm),当掺杂浓度为8%的时候,器件发光的色坐标为(x=0.67,y=0.32),基本满足了全色显示对红色发光的要求。在电压为16V时,器件达到最高亮度9380cd/m²。在电流密度为5.45mA/cm²时,外量子效率达到最大5.7%。由于磷光体Ir(piq)₂(acac)的磷光寿命较短,所以器件在高电流密度下,仍然保持较高的外量子效率。电流密度为100mA/cm²时,外量子效率仍然维持在4.7%。进一步研究表明在器件中短程的Dexter能量传递以及红光染料对空穴的直接捕获两种机制同时存在。     

Effect of NaCl doped into Bphen layer on the performance of tandem organic light-emitting diodes

To improve the performance of tandem organic light-emitting diodes （OLEDs）, we study the novel NaCl as n-type dopant in Bphen：NaCl layer. By analyzing their relevant energy levels and cartier transporting characteristics, we discuss the mechanisms of the effective charge generation layer （CGL） of Bphen：NaCl （6 wt%）/MoO3. In addition, we use the Bphen：NaC1 （20 wt%） layer as the electron injection layer （ELL） combining the CGL to further improve the performance of tandem device. For this tandem device, the maximal current efficiency of 9.32 cd/A and the maximal power efficiency of 1.93 lm/W are obtained, which are enhanced approximately by 2.1 and 1.1 times compared with those of the single- emissive-unit device respectively. We attribute this improvement to the increase of electron injection ability by introducing of Bphen：NaCl layer. Moreover, the CGL is almost completely transparent in the visible light region, which is also important to achieve an efficient tandem OLEDs.     

Improved Performance of Phthalocyanine Derivative Field-Effect Transistors by Inserting a Para-Quarterphenyl as the Inducing Layer

We investigate the phthalocyanine derivative organic field-effect transistors （OFETs） using a novel para - quaterphenyl （p-4p） as the inducing layer. Compared to the devices without the p-4p inducing layer, the performances of p-type （copper phthalocyanine） and n-type （fluorinated copper phthaloeyanine） OFETs with optimized thickness of p-4p thin films are greatly enhanced. Both the field-effect mobility and the on/off ratio of the two-type devices are improved by one order of magnitude compared to those of the control devices. This re- markable improvement is attributed to the introduction of p-4p, which can form a highly oriented and continuous phthalocyanine derivative film with the molecular π - π stack direction parallel to the substrate.     

溶剂效应对聚喹啉铝发光特性的影响

研究了非共轭聚喹啉铝（Palq)在氯仿和乙醇不同极性的溶剂下所获得的薄膜的吸收和发光光谱。由于溶剂性的不同，聚喹啉铝链在氯仿和乙醇溶液中表现出不同的聚集状态。当各种溶液分别旋涂成膜时，溶液中的聚喹啉铝的聚集态仍部分地保存下来，导致不同聚喹啉铝薄膜的电子结构状态的差别。结果，聚喹啉铝的薄膜表现出不同的发光特性。实验表明，在制作聚合物器件中，溶剂的选择对共轭聚合物的发光特性有着重要的影响。     

有机薄膜器件负电阻特性的影响因素

研究了影响有机染料掺杂聚合物薄膜器件负电阻特性的因素，为探索有机负电阻的机理提供实验依据。实验中制备了多种有机染料掺杂聚合物薄膜器件，研究了有机小分子染料、聚合物基体、薄膜组成及厚度、ITO和聚苯胺阳极等对有机染料掺杂聚合物薄膜器件负电阻特性的影响。在室温、大气环境下，所制备的多种有机染料掺杂聚合物器件在所加电压为3～4V时，观察到明显的负电阻特性，电流峰谷比最大约为8。负电阻现象及峰谷比的大小受膜厚和器件的结构、制备工艺等影响。提出用负电阻和二极管并联组成的等效电路模型解释影响负电阻特性的因素，认为负电阻特性与载流子的不平衡注入有关。在此基础上设计、合成了主链含唔二唑电子传输基团的可溶性聚对苯撑乙烯衍生物，该聚合物兼具空穴和电子传输功能，在空气中具有较稳定的N型负电阻特性。进一步控制相关材料和工艺条件，有可能得到易于控制的负阻效应，开发出新型的有机负电阻器件。