Mg5SnB2O10:Eu3+,Bi3+—一种用于发光二极管的红色荧光粉的制备及其发光性能的研究

采用高温固相法成功合成了单一相的Eu³⁺,Bi³⁺共掺的Mg₅SnB₂O₁₀红色荧光粉,并通过X射线衍射、漫反射光谱、光致发光光谱等手段对该体系的结构及其发光特性进行了测试和研究.激发光谱表明,该荧光粉在393 nm呈现Eu³⁺的⁷Fo—⁵L₆特征激发,可以与用于发光二极管的近紫外芯片很好地匹配.在393 nm激发下,其发射光谱在591,612,701 nm处呈现Eu³⁺的⁵Do—⁷F₁,⁵Do—⁷F₂,⁵D₀—⁷F₄的特征发射.并且当固定Eu³⁺的浓度时,随着Bi³⁺含量的增加,发现Bi³⁺,Eu³⁺在这一体系中存在能量传递现象,系列样品发光强度大幅度提高.通过研究系列样品在不同Bi³⁺,Eu³⁺掺杂浓度下的发光性能,得出最佳样品为Mg_4.89Eu_0.1Bi_0.01SnB₂O₁₀,其积分强度达到了商用Y₂O₂S:Eu³⁺的1.1倍.     

Morphology and photoluminescence of BaAl12O19:Mn2+ green phosphor prepared by flux method

This paper reports that the green phosphor BaAl11.9O19:0.1Mn2+ is prepared by a flux assisted solid state reaction method.The effect of flux systems on the crystal structure,morphology and luminescent properties of the phosphor are studied in detail.The samples are characterized by the application of x-ray diffraction patterns,scanning electron microscopy patterns,luminescent spectra and decay curves.The results show that a pure phase BaAl12O19 can be achieved at the firing temperature above 1300℃ by adding the proper flux system,the firing temperature is reduced at least 200℃ in comparison with the conventional solid state reaction method.Maximum photoluminescence emission intensity is observed at 517 nm for(AlF3+Li2CO3) flux system under vacuum ultraviolet region(147 nm) excitation.The photoluminescence emission intensity and the decay time of these phosphor is found to be more superior to that of the corresponding sample prepared by the conventional solid state reaction method implying the suitability of this route for the preparation of display device worthy phosphor materials.     

深红色Mg_(1+y)Al_(2-x)O_4:xMn~(4+),yMg~(2+)荧光粉的合成与发光性质

采用高温固相法在空气气氛中合成了新型Mg_(1+y)Al_(2-x)O_4:xMn~(4+),yMg~(2+)深红色荧光粉.利用X射线衍射仪、扫描电子显微镜和荧光光谱仪表征荧光粉的晶体结构和形貌,并分析了发光性质,讨论了掺杂不同浓度Mn4+和过量Mg2+对样品发光强度的影响.结果表明,在300 nm波长激发下样品发射652 nm波长的红光,归因于Mn~(4+)的~2Eg—~4A_(2g)跃迁, Mn~(4+)的最佳掺杂浓度为0.14%.采用Blasse公式计算了Mn~(4+)-Mn~(4+)之间能量传递的临界距离,讨论了可能的能量传递过程和引起浓度淬灭的原因,采用Tanabe-Sugano能级图从理论上计算和分析了Mn~(4+)的d~3电子构型的晶体场强度大小.过量Mg~(2+)可以提高荧光粉的发光强度,同时导致了荧光寿命的缩短,荧光衰减曲线呈单指数变化.探讨了过量Mg~(2+)增强发光强度的机理,阐述了深红色荧光粉MgAl_2O_4:Mn~(4+)发光效率提高的原因.