Phase transition and scaling in Kuramoto model with high-order coupling

Nonlinear Dynamics - The classical Kuramoto model serves as a useful tool for studying synchronization transitions in coupled oscillators that is limited to the sinusoidal and pairwise...     

Collective sustained oscillations in excitable small-world networks: the moderate fundamental loop or the minimum Winfree loop?

Nonlinear Dynamics - The problem of self-sustained oscillations in excitable complex networks is the central issue under investigation, among which the exploration of the key factors in determining...     

Novel identification approach for nonlinear systems with hysteresis

Nonlinear Dynamics - A new identification approach for a nonlinear system with hysteresis, namely a cascading Bouc–Wen hysteresis model with linear dynamics, is proposed in this study. The...     

水冷却对高温花岗岩的细观损伤及动力学性能影响

为探讨高温花岗岩经水冷却后的细观结构损伤及动态力学性能，对水冷却后高温花岗岩开展波速和核磁共振测试，分离式霍普金森压杆冲击试验，以及冲击破碎试样的扫描电镜观察，分析比较不同状态下花岗岩波速、孔隙度和动力学参数的变化规律。研究发现:随着温度升高，经水冷却处理后高温花岗岩波速非线性下降，大孔径孔隙度分量增大，且水冷却后试样的孔隙孔径尺寸和数量均大于自然冷却；水冷却后高温花岗岩动力学参数呈现出随着温度升高，峰值应力减小，峰值应变增大，弹性模量则先增大后减小的规律；由于水冷却使高温花岗岩表面温度急剧降低，产生额外的温度应力，花岗岩内部损伤加剧，表现出更低的波速与峰值应力；而水的冷淬作用一定程度上提高了表层花岗岩的硬度，降低了高温后花岗岩的塑性能力，与自然冷却相比水冷却后花岗岩的峰值应变减小，弹性模量增大，表现出脆性破坏特征。在温度低于400 ℃时，冷却方式对冲击裂纹影响不大，随着温度升高到800 ℃，自然冷却后花岗岩冲击断面呈蜂窝状，而水冷却后冲击断面则相对平整。     

体外预应力梁摩擦效应的非线性分析

构造了简单的体外预应力梁的摩擦单元,摩擦单元位于转向块和体外筋之间的角平分线上,能模拟转向块和体外筋之间的有摩擦或无摩擦滑移。考虑混凝土、钢筋和体外筋应力-应变的非线性关系,采用梁截面弯矩-轴力-曲率的三折线模型,探讨了体外预应力梁的性能。对简支梁和连续梁的不同因素进行计算,包括不同摩擦系数、不同体外筋和钢筋面积、不同偏心距以及对称和非对称荷载形式。计算结果表明,对于简支梁和对称荷载下的连续梁,承载力的摩擦效应可以忽略,最大预应力增量和挠度的摩擦效应不宜忽略,最小预应力增量的摩擦效应明显;对于非对称荷载下的连续梁,承载力、最大和最小预应力增量以及挠度的摩擦效应不可忽略。     

Boron group element doping of Li1.5Al0.5Ge1.5(PO4)3 based on microwave sintering

Journal of Solid State Electrochemistry - We report effectiveness of dopants selected from group 13, such as B, Ga, and In, on the conductivity of Li1.5Al0.5Ge1.5(PO4)3 (LAGP) that is recognized as...     

Tea-derived carbon materials as anode for high-performance sodium ion batteries

Sodium-ion batteries (SIB) have attracted widespread attention in large-scale energy storage fields owing to the abundant reserve in the earth and similar properties of sodium to lithium. Biomass-based carbon materials with low-cost, controllable structure, simple processing technology, and environmental friendliness tick almost all the right boxes as one of the promising anode materials for SIB. Herein, we present a simple novel strategy involving tea tomenta biomass-derived carbon anode with enhanced interlayer carbon distance (0.44 nm) and high performance, which is constructed by N,P co-doped hard carbon (Tea-1100-NP) derived from tea tomenta. The prepared Tea-1100-NP composite could deliver a high reversible capacity (326.1 mAh/g at 28 mA/g), high initial coulombic efficiency (ICE = 90% at 28 mA/g), stable cycle life (262.4 mAh/g at 280 mA/g for 100 cycles), and superior rate performance (224.5 mAh/g at 1400 mA/g). Experimental results show that the excellent electrochemical performance of Tea-1100-NP due to the high number of active N,P-containing groups, and disordered amorphous structures provide ample active sites and increase the conductivity, meanwhile, large amounts of microporous shorten the Na⁺ diffusion distance as well as quicken ion transport. This work provides a new type of N,P co-doped high-performance tomenta-derived carbon, which may also greatly promote the commercial application of SIB.     

绿色双溶剂法制备高效稳定钙钛矿太阳能电池

采用毒性小、环境友好的乙二醇甲醚(ethylene glycol monomethyl ether,EGME)与水混合的双溶剂(体积比为1∶1)溶解CsBr,通过提高CsBr的溶解度,减少了后续CsBr的甲醇溶液的旋涂遍数,简化了电池制备流程。通过优化CsBr的甲醇溶液的旋涂遍数发现,在旋涂1遍200 mg·mL^-1 CsBr的水/EGME溶液的基础上旋涂2遍15 mg·mL^-1 CsBr的甲醇溶液,所制备的CsPb-Br₃钙钛矿太阳能电池(perovskite solar cells,PSCs)拥有最佳的性能,实现了1.44 V的开路电压(open-circuit voltage,V_OC),6.26mA·cm^-2的短路电流密度(short circuit current density,J_SC),74.57%的填充因子(fill factor,FF)及最高6.72%的光电转换效率(pho-toelectric conversion efficiency,PCE)。