污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能研究

亚甲基蓝和环丙沙星是水体中2种污染物, 对生态环境有潜在危害. 本文以市政剩余活性污泥为原料, 氯化锌为活化剂热解制备污泥基吸附剂, 研究盐酸酸洗浓度、氯化锌浓度、热解温度、热解时间等对污泥基吸附剂吸附水中亚甲基蓝和环丙沙星性能的影响. 结果表明 (1)污泥基吸附剂对亚甲基蓝的吸附性能随盐酸酸洗浓度的增大而增加, 对环丙沙星的吸附性能则随盐酸酸洗浓度的增大呈先降后增趋势, 两者均在1.500mol·L-1盐酸浓度下取得最优值. (2)污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能随氯化锌浓度和热解温度的增加呈先升后降趋势, 在氯化锌浓度为4.0mol·L-1、热解温度为500℃时有最优值; 随着热解时间的延长, 污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能分别在500℃热解70min和80min时有最优值. (3)污泥基吸附剂的最佳制备条件为 氯化锌4.0mol·L-1活化2h、500℃热解70min和80min、1.500mol·L-1盐酸酸洗; 以此制得的污泥基吸附剂对亚甲基蓝和环丙沙星的去除率分别为97.7%和96.4%, 平衡吸附量分别为97.9mg·g-1和3.9mg·g-1, 且污泥基吸附剂对亚甲基蓝和环丙沙星的吸附过程均符合准二级动力学方程.     

坚硬顶板爆破切顶在沿空留巷中的应用研究

当煤层上方为坚硬顶板时,在工作面回采期间容易出现大面积悬顶,导致巷旁充填体出现大变形破坏,极大威胁采煤安全.为解决这一问题,以某矿1205工作面沿空留巷为工程背景,分析了爆炸围岩裂隙范围和坚硬顶板破断特征,建立了切顶卸压围岩结构力学模型,研究表明,相邻炮孔爆炸后,炮孔间裂隙互相贯穿,降低了顶板强度,同时当切顶角为15°时,巷道稳定性较好.工程实践结果表明:采用爆破切顶技术后,顶板下沉量减小了62.3%,较好地保证了围岩稳定性.     

基于XPS对硫铁矿去除SeO2-3的机理研究

硒是动植物及人体生长必需的十五种微量元素之一，具有清除体内自由基、抗氧化、增强免疫力等功能，但其安全剂量的范围却很窄。利用扫描电子显微镜（SEM）和X射线衍射仪（XRD）对湿法球磨制备的硫铁矿形貌进行了表征。SEM观测发现加乙醇助磨后的硫铁矿为粒径大小较均匀的球形颗粒团聚体，粒径范围在17～200 nm之间，平均粒径138 nm。XRD衍射图谱中的特征峰与FeS₂衍射图谱中各峰位置基本一致，因此判定硫铁矿中主要化学组分为FeS₂，且图谱中基本没有杂峰，表明制备过程中并未混入杂质，样品纯度较高。实验结果表明，该法制备的硫铁矿具有颗粒粒径小、比表面积大、反应活性高等优点。研究中利用X射线光电子能谱仪（XPS）对硫铁矿去除水体中SeO2-₃的机理进行了研究。研究结果表明, （1）在较为广泛的实验pH范围（pH 2.2～11.5），硫铁矿均能有效去除水体中SeO2-₃，去除效率（除pH值7.8以外）均达到90%以上；（2）硫铁矿与SeO2-₃发生反应后，其主要组成元素的XPS特征峰结合能有所减小，表明硫铁矿表面发生了一定化学变化；（3）酸碱环境下硫铁矿去除SeO2-₃的机理不完全相同，酸性环境下，硫铁矿对SeO2-₃的去除是单纯的氧化还原过程，即硫铁矿中被酸活化的S2-₂将SeO2-₃还原为单质Se(0)，并且酸性越强，SeO2-₃去除效果越好；碱性环境下，SeO2-₃的去除过程中氧化还原与络合反应并存，硫铁矿表面有络合态Fe(OH)SeO₃和单质Se(0)两种存在形态，且碱性越强，络合态Fe(OH)SeO₃含量越高。以上研究结果为硫铁矿去除固定水体和土壤中以SeO2-₃为代表的可变价金属阴离子提供重要理论依据和应用基础。     

Bicomponent Cocatalyst Decoration on Flux-assisted CaTaO2N Single Crystals for Photocatalytic CO2 Reduction under Visible Light

Cubic-like CaTaO₂N photocatalysts with high crystallinity and uniform particle size were successfully prepared by the flux-assisted nitridation method. The growth of CaTaO₂N single crystals under different synthesis conditions was systematically investigated to understand the effects of the crystallinity and optical property on photocatalytic performance of CO₂ reduction. Moreover, the modification of CaTaO₂N single crystals with core-shell Ni−Ag bicomponent cocatalyst by two-step decoration process gave a 2.4 times higher amount of CO evolution than the deposition of sole Ag cocatalyst, because of the synergistic effects of bicomponent cocatalyst on the interfacial electron transfer and surface catalytic process. This study provides a valuable way to construct high-crystalline photocatalysts with effective bicomponent cocatalyst for visible-light-driven CO₂ reduction with H₂O.     

射频等离子制备石墨烯负载Co3O4催化剂及其析氧性能研究

氢能的引入能有效提升配电网的供电可靠性,而电解水制氢是实现低碳转型的关键技术,开发高效的电解水催化剂势在必行。过渡金属氧化物储量大、催化活性高,是具有广阔应用前景的析氧反应催化剂。本文通过射频等离子体处理制备石墨烯上负载Co₃O₄析氧催化剂,XRD、Raman和XPS测试结果显示,二维结构石墨烯的引入加速表面电子迁移,增大了反应面积。等离子体处理促进了纳米粒子在石墨烯上的负载,利用等离子体刻蚀作用在催化剂表面制造出大量碳结构缺陷和氧空位结构,改善了活性位点分布,有效调控Co₃O₄电子结构,提高析氧催化活性。电化学测试表明,本文中合成的Co₃O₄@rGO在电流密度为50 mA·cm^-2时的过电位为410 mV,动力学反应速率较快,表现出优于商业IrO₂的析氧催化活性。     

Developing the Low-Temperature Oxidation Mechanism of Cyclopentane: An Experimental and Theoretical Study

At present, the reactivity of cyclic alkanes is estimated by comparison with acyclic hydrocarbons. Due to the difference in the structure of cycloalkanes and acycloalkanes, the thermodynamic data obtained by analogy are not applicable. In this study, a molecular beam sampling vacuum ultraviolet photoionization time-of-flight mass spectrometer (MB-VUV-PI-TOFMS) was applied to study the low-temperature oxidation of cyclopentane (CPT) at a total pressure range from 1–3 atm and low-temperature range between 500 and 800 K. Low-temperature reaction products including cyclic olefins, cyclic ethers, and highly oxygenated intermediates (e. g., ketohydroperoxide KHP, keto-dihydroperoxide KDHP, olefinic hydroperoxides OHP and ketone structure products) were observed. Further investigation of the oxidation of CPT – electronic structure calculations – were carried out at the UCCSD(T)-F12a/aug-cc-pVDZ//B3LYP/6-31+ G(d,p) level to explore the reactivity of O₂ molecules adding sequentially to cyclopentyl radicals. Experimental and theoretical observations showed that the dominant product channel in the reaction of CPT radicals with O₂ is HO₂ elimination yielding cyclopentene. The pathways of second and third O₂ addition – the dissociation of hydroperoxide – were further confirmed. The results of this study will develop the low-temperature oxidation mechanism of CPT, which can be used for future research on accurately simulating the combustion process of CPT.     

A New Quassinoid from Brucea javanica

Chemistry of Natural Compounds - A new quassinoid, dehydrobruceantinol B (1), was isolated from the seeds of Brucea javanica, together with two known compounds, bruceantinol (2) and bruceine A (3)....     

Effect of biaxial strain and hydrostatic pressure on the magnetic properties of bilayer CrI3

Two-dimensional van der Waals magnetic materials are intriguing for applications in the future spintronics devices, so it is crucial to explore strategy to control the magnetic properties. Here, we carried out first-principles calculations and Monte Carlo simulations to investigate the effect of biaxial strain and hydrostatic pressure on the magnetic properties of the bilayer CrI₃. We found that the magnetic anisotropy, intralayer and interlayer exchange interactions, and Curie temperature can be tuned by biaxial strain and hydrostatic pressure. Large compressive biaxial strain may induce a ferromagneticto-antiferromagnetic transition of both CrI₃ layers. The hydrostatic pressure could enhance the intralayer exchange interaction significantly and hence largely boost the Curie temperature. The effect of the biaxial strain and hydrostatic pressure revealed in the bilayer CrI₃ may be generalized to other two-dimensional magnetic materials.