CiADS束流负载效应前馈补偿的仿真评估

在高功率超导质子直线加速器中，束流负载效应是影响超导腔幅相稳定性的一个重要因素。本工作基于谐振腔建场模型，开发了超导腔系统束流负载效应的时域仿真程序，分析了束流负载效应对超导腔幅相稳定性的影响，并在C-ADS注入器II上通过相关实验测量对仿真结果进行了验证。利用该程序，评估了CiADS超导直线加速器脉冲束流的脉冲长度，以及前馈补偿的时序抖动和束流纹波等因素对腔中电磁场幅相稳定度的影响。仿真结果表明:在当前CiADS直线加速器设计参数下，为满足超导腔中电磁场0.1%与在高功率超导质子直线加速器中，束流负载效应是影响超导腔幅相稳定性的一个重要因素。本工作基于谐振腔建场模型，开发了超导腔系统束流负载效应的时域仿真程序，分析了束流负载效应对超导腔幅相稳定性的影响，并在C-ADS注入器II上通过相关实验测量对仿真结果进行了验证。利用该程序，评估了CiADS超导直线加速器脉冲束流的脉冲长度，以及前馈补偿的时序抖动和束流纹波等因素对腔中电磁场幅相稳定度的影响。仿真结果表明:在当前CiADS直线加速器设计参数下，为满足超导腔中电磁场0.1%与$0.1^{\circ}$的幅相稳定度指标，前馈时序抖动的偏差不能超过0.79 μs，束流流强的直流偏差不能超过0.9%，并且给出了束流纹波的最大抖动幅值与纹波频率之间的关系。这些结果将为CiADS超导直线加速器相关子系统技术指标的确定提供依据。     

Ca9Al(PO4)7∶Eu2+的发光、浓度猝灭及温度稳定性

采用高温固相法制备了Ca9Al(PO4)7∶Eu2+蓝色荧光粉,研究了Ca9Al(PO4)7∶Eu2+的发光、浓度猝灭及温度稳定性.Ca9Al(PO4)7∶Eu2+的激发光谱覆盖200～350 nm紫外区;发射光谱为一主峰位于445 nm的宽谱,对应Eu2+的4f6 5d1--→4f特征跃迁.研究发现,随Eu2+掺杂量的增大,Ca9Al(PO4)7∶Eu2+的发射强度呈现先增大、后减小的变化趋势,最大发射强度对应的Eu2+掺杂量为0.01,即存在浓度猝灭效应,对应的机理为电偶极-电偶极相互作用;依据晶格常数,得出临界距离为2.297 nm.在25～300℃范围内改变光谱测量温度,发现温度升高到150℃时,Ca9Al(PO4)7∶Eu2+的发射强度变为25℃时的81.0％,对应的激活能为0.268 eV,说明材料具有较好的温度稳定性.     

Optimization of the three-dimensional electric f ield in IH-DTL

The tuning process of the three-dimensional electric field near the beam axis is very important in the optimization of the Interdigital H-mode Drift Tube Linac (IH-DTL). The tuning of the longitudinal field distribution, the Kilpatrik (Kp) factor, and the transverse dipole field have been discussed in detail, combined with the radio-frequency tuning process of the 53.667 MHz short IH-DTL cavity, which was designed to accelerate ²³⁸U³⁴⁺ from 0.143 MeV/u to 0.289 MeV/u in the SSC-Linac injector project at the Institute of Modern Physics. The flatness criterion and the tube tuning method are discussed in order to meet the beam dynamics requirements. In the tube tuning process, the energy gain error in the cells should be reduced to less than ±2%, and the Kp factor should be reduced to 1.6. The transverse dipole field and the method that uses a "plunger" to dismiss this dipole field are evaluated. The experience gained from the first cavity optimization benefits the tuning process of the three remaining IH-DTL cavities in the SSC-Linac project.     

The effect of interfacial energy anisotropy on planar interface instability in a succinonitrile alloy under a small temperature gradient

The morphological stability of a planar interface with different crystallographic orientations is studied under a small positive temperature gradient using a transparent model alloy of succinonitrile.Novel experimental apparatus is constructed to provide a temperature gradient of about 0.37 K/mm.Under this small temperature gradient,the planar interface instability depends largely on the crystallographic orientation.It is shown experimentally that the effect of interfacial energy anisotropy on planar interface stability cannot be neglected even in a small temperature gradient system.Higher interfacial energy anisotropy leads the planar interface to become more unstable,which is different from the stabilizing effect of the interfacial energy on the planar interface.The experimental results are in agreement with previous theoretical calculations and phase field simulations.     

Ca2SiO4:Dy3+材料的制备及其发光特性

采用高温固相法制备了Ca2SiO4:Dy3 发光材料,在365 nm紫外光激发下,测得Ca2SiO4:Dy3 材料的发射光谱为一多峰宽谱,主峰分别位于486 nm,575 nm和665 nm处;监测575 nm发射峰,测得材料的激发光谱为一多峰宽谱,主峰分别位于331 nm,361 nm,371 nm,397 nm,435 nm,461 nm和478 nm处,研究了Dy3 掺杂浓度对Ca2SiO4:Dy3 材料发射光谱及发光强度的影响,结果显示,随Dy3 浓度的增大,黄、蓝发射峰强度比(Y/B)逐渐增大,利用Judd-Ofelt理论解释了其原因;随Dy3 浓度的增大,Ca2SiO4:Dy3材料发光强度先增大,在Dy3浓度为4 mol%时到达峰值,而后减小,根据Dexter理论其浓度猝灭机理为电偶极-电偶极相互作用,研究了电荷补偿剂Li ,Na 和K 对Ca2SiO4:Dy3 材料发射光谱的影响,结果显示,不同电荷补偿剂下,随电衙补偿剂掺杂浓度的增大,Ca2SiO4:Dy3 材料发射光谱强度的演化趋势相同,即Ca2SiO4:Dy3材料发射峰强度先增大后减小,但不同电荷补偿剂下,材料发射峰强度最大处对应的补偿剂浓度不同,对应Li ,Na 和K 时,浓度分别为4 mol%,4 mol%和3 mol%.     

各向异性作用下合金定向凝固界面稳定性的渐近分析

采用渐近分析方法对考虑了界面能各向异性的单相二元合金平界面定向凝固过程进行了线性稳定性分析，得到了特定条件下的零级、一级渐近解，并通过对长波段渐近解的讨论得出了适用于整个波段的色散关系.分析表明零级渐近解等效于成分过冷理论，而一级渐近解则与M-S稳定性理论一致.在稳定状态控制参数(抽拉速度和温度梯度)的选择图中，界面能各向异性增大了不稳定区域，且在高速和高温度梯度时的影响更强. 关键词： 定向凝固 界面稳定性 渐近分析 各向异性     

Ce∶KNSBN晶体中光扇效应的响应时间特性研究

以单束光入射Ce∶KNSBN晶体,系统研究了不同入射光波长下,Ce∶KNSBN晶体中光扇效应的响应时间随入射光强度及光入射角的变化情况.结果显示,相同的入射光强度及光入射角下,入射光波长较短时,光扇效应到达稳态的时间较短.相同的入射光强度下,随光入射角的增大,响应时间先减小后增大,但不同波长入射光下,最小值对应的光入射角不同,入射光波长为532 nm时,响应时间最小值对应的θ为15°；入射光波长为632.8 nm时,对应的θ为15.5°.同时研究发现,入射光强度逐渐增大的过程中,响应时间在逐渐减小.     

求解stokes问题的一个新的非协调混合元格式

构造一个新的非协调混合元格式求解stokes问题,证明了该元满足B-B条件,并且有2阶收敛速度.     

基于异构三联苯-2，2″，4，4″-四羧酸构筑的单水桥钴(Ⅱ)、镍(Ⅱ)配位聚合物的合成、结构及磁性质

使用异构三联苯-2,2″,4,4″-四羧酸配体(m-H₄tpta和p-H₄tpta),通过水热法合成了2例新的单水桥Co (Ⅱ)/Ni (Ⅱ)金属链状配位聚合物[Co (m-H₂tpta)(H₂O)₃]_n(1)和{[Ni₂(p-tpta)(H₂O)₆]·2H₂O}_n(2)。其结构通过FT-IR、元素分析、X射线单晶及粉末衍射进行了表征。在结构上,金属离子呈现出轻微扭曲的八面体几何构型,通过单水分子桥连接形成了一维金属链,异构H₄tpta配体分别采用μ₁-η¹∶η⁰∶η¹∶η⁰和μ₄-η¹∶η¹∶η¹∶η¹配位模式与金属离子连接,形成一维链和三维网状结构,配合物2表现出(4,4)-连接的NbO型的三维拓扑网络结构。磁性方面,配合物1的Co(Ⅱ)离子间通过μ₂-H₂O桥传递表现出反铁磁相互作用。配合物2也展现出Ni(Ⅱ)离子间的反铁磁耦合作用,与磁耦合Ni—Ow—Ni角有关。     

Full period superconducting section physics design for injector Ⅱ of China-ADS

The China Accelerator Driven Subcritical System (China-ADS) project, which is a strategic plan and aims to design and build an ADS demonstration facility, has been proposed and launched actively in China. Injector Ⅱ as one of the parallel injectors of China-ADS, and is prompted by the Institute of Modern Physics (IMP). In this paper, a new scheme with full period lattice structure for the SC section is proposed. In the new scheme, there are sixteen periods, with one superconducting solenoid and one superconducting cavity included in each period. All of the elements are contained in four cryomodules. The dreadful influence of the mismatch caused by period structural change can be avoided, and the beam quality is favorable. In addition, this new scheme has certain advantages in reducing the project's difficulty and construction risk. The details of the design and beam dynamic simulation for the full period lattice structure are given in this paper.