排序方式: 共有37条查询结果,搜索用时 15 毫秒
1.
A simple and convenient pressure calibration method is developed for a newly designed portable wide-access 'panoramic' cell. This cell is adapted to angle-dispersive-mode high-pressure in situ neutron diffraction of reactor neutron sources. This pressure calibration method has established a relationship between the cell pressure and the anvil displace- ment (gasket compression) based on the fixed-point calibration technique. By employing TiZr gasket with a thickness of 3 mm and WC anvil with a culet of 4 mm diameter, the average anvil displacements are 1.31 mm and 2.22 mm for Bi phase transitions (2.55 GPa and 7.7 GPa), and 1.85 mm for Ba phase transitions (5.5 GPa), respectively. In this pressure range, the pressure increases quickly with decreasing gasket thickness, and undergoes a linear increase with the anvil displacement. By extrapolating the calibration curve, the cell pressure will achieve 10 GPa when the anvil displacement is around 2.5 ram. 相似文献
2.
采用基于第一原理的全势能线性缀加平面波加局域轨道((L)APW lo)方法对Nd(Fe,Si)11Cx化合物(x=0,2)的电子结构进行了计算,得到了化合物态密度和磁矩等信息.计算结果表明NdFe9Si2化合物中Si原子主要与4b和32i位Fe原子产生杂化,导致Fe原子磁矩减小.NdFe9Si2C2化合物C原子使32i位Fe原子磁矩进一步降低,同时减弱了Si原子的影响,使得4b位Fe原子磁矩增大. 相似文献
3.
R(Fe,Si)12(R=Y,Nd)型稀土永磁材料具用重要的实际应用价值,然而对于V(Fe,Si)12化合物微观机理的理论计算工作至今尚未开展。采用新近发展的全势能线性缀加平面波((L)APW)+局域轨道(10)和广义梯度近似(GGA)密度泛函方法对其结构与磁性进行了研究。 相似文献
4.
基于密度泛函理论, 分别计算了α, γ铀的晶格常数、平衡态体积、体弹模量及其导数等, 与实验和其他第一性原理计算结果符合较好; 并根据焓-压强曲线得到了两相的相变压强~111GPa. 通过体心立方结构理想拉伸强度的计算, 分析其在极端加载条件下的结构行为. 另外, 计算了小应变情况下U-Nb (6.25at.%) 的能量-应变关系, 发现对应于剪切模量c’的应变会使得该结构的能量降低, 揭示了该结构的力学不稳定性.
关键词:
铀
相变
理想强度
结构稳定性 相似文献
5.
采用新近发展的全势能线性缀加平面波((L)APW) 局域轨道(lo)和广义梯度近似(GGA)密度泛函方法计算了Y(Fe,M)12化合物(M=Nb,Si)的电子结构,得到了相应的总态密度和局域态密度,并分析了替代原子与替代晶位不同引起态密度的变化。根据计算结果预测的居里温度变化与实验结果基本一致。 相似文献
6.
奥克托金(HMX) 在温度作用下, 会发生热膨胀、 相转变、 热分解等物理、 化学变化, 导致在材料内部产生大量缺陷, 进而会对其宏观性能造成明显影响. 为了深入了解热损伤HMX内部的缺陷演化, 本文采用X射线小角散射和原子力显微技术研究了热损伤HMX的内部缺陷. 结果发现HMX在180 °C相变过程中散射曲线有明显的变化, 颗粒内部生成了大量10nm左右的孔洞, 随着加载时间延长, 其尺寸增大到25nm, 数量明显降低. 当HMX在190 °C、 200 °C保温5h时, 由于HMX热分解内部有新缺陷生成, 小角散射发现其尺寸约为5至8nm, 随着加载温度升高, 其数量增加. 相似文献
7.
建立了超高效液相色谱-串联质谱(UPLC-MS/MS)测定人血清中孕酮的分析方法。血清样品经乙酸乙酯、正己烷液液萃取(LLE)后,采用Acquity UPLC BEH C_(18)色谱柱(2.1 mm×100 mm,1.7μm)进行梯度分离,色谱运行时间为5 min,采用电喷雾(ESI)正离子电离模式和多反应监测(MRM)扫描模式,同位素内标法定量。考察了两步萃取法对孕酮的提取效果,不同流动相的分离效果以及样品稳定性,结果表明以甲醇-0.1%氨水溶液为流动相时分离效果较好。优化条件下,孕酮在10~10 000pg/mL范围内线性关系良好(r~2=0.999 8),方法检出限和定量下限分别为5、10 pg/mL;平均加标回收率为91.5%~106%,日内相对标准偏差(RSD)为1.2%~8.2%,日间RSD为4.1%~9.1%。采用该方法对30个真实血清样品进行测定,孕酮质量浓度为0.050 2~1.363 5 ng/mL,均在正常生理范围内。该方法灵敏度高、准确可靠,可用于临床血清样品中孕酮生理水平的检测。 相似文献
8.
冷中子三轴谱仪( CTAS ) 的屏蔽体对于保障工作人员安全、降低散射大厅本底及提高信噪比具有重要的意义。采用蒙特卡罗程序MCNP5 对谱仪各部分屏蔽体进行了计算,并结合Mcstas 程序确定了CTAS 入口处的中子源,大大提高了计算效率。经过模拟计算和优化表明:单色器后端使用厚350mm、密度4.6 g/cm3 的重混凝土,衔接屏蔽体使用厚300 mm、密度3.6 g/cm3的重混凝土,生物屏蔽采用厚150 mm、密度3.6 g/cm3 的重混凝土可保证屏蔽体外表面的剂量率满足散射大厅的剂量要求。The shielding of Cold neutron Triple-Axis Spectrometer( CTAS ) is important for radiation safety of workers, and reduce the background of scattering hall as well as enhancing the ratio of signal-to-noise. In this study,Monte-Carlo simulation was performed to conduct the calculation on the shielding of CTAS. To increase the calculation efficiency, neutron source was obtained by using Mcstas code. The results indicate that, in the case of heavy concrete ( density 4.6 g/cm3 ) with thickness of 350 mm for the shielding behind the monochromater, and heavy concrete ( density 3.6 g/cm3 ) with thickness of 300 mm for the other monochromater shielding, as well as the heavy concrete ( density 3.6 g/cm3 ) with thickness of 150 mm for biological shielding, the dose rate outside shielding may meet the requirement of national standard of China. 相似文献
9.
Small-angle neutron scattering study on the stability of oxide nanoparticles in long-term thermally aged 9Cr-oxide dispersion strengthened steel 下载免费PDF全文
Peng-Lin Gao 《中国物理 B》2022,31(5):56102-056102
A 9Cr-oxide dispersion strengthened (ODS) steel was thermally aged at 873 K for up to 5000 h. The size distribution and chemical composition of the dispersed oxide nanoparticles were analyzed by small-angle neutron scattering under a magnetic field. Combined with transmission electron microscopy, Vickers micro-hardness tests and electron backscattered diffraction measurements, all the results showed that the thermal treatment had little or no effect on the size distributions and volume fractions of the oxide nanoparticles in the ferromagnetic matrix, which suggested excellent thermal stability of the 9Cr-ODS steel. 相似文献
10.