Artificial Caries Lesion Characteristics after Secondary Demineralization with Theobromine-Containing Protocol

Developing artificial caries lesions with varying characteristics is needed to adequately study caries process in vitro. The objective of this study was to investigate artificial caries lesion characteristics after secondary demineralization protocol containing theobromine and fluoride. Sixty bovine enamel slabs (4 × 3 mm) were demineralized using a Carbopol-containing protocol for 6 days. A baseline area (2 × 3 mm) was protected with acid-resistant nail varnish, after which specimens were exposed for 24 h to a secondary demineralization protocol containing acetic acid plus one of four fluoride/theobromine combinations (n = 15): theobromine (50 or 200 ppm) and fluoride (0 or 1 ppm). Specimens were sectioned and analyzed using transverse microradiography for changes in mineral content, lesion depth, and surface layer mineralization. Data was analyzed using paired t-test and analysis of variance followed by Bonferroni test at 0.05 significance level. After secondary demineralization, fluoride-containing groups had significantly deeper lesions (p = 0.002 and 0.014) compared to the group with 0 ppm fluoride and 50 ppm theobromine. Mineral content and lesion depth were significantly different compared to baseline for all groups. Theobromine did not show an added effect on mineral uptake. Theobromine-containing groups exhibited particularly deep lesions with a more uniform mineral profile in the presence of fluoride.     

正交复合材料面层夹层板非线性理论及应用

针对复合材料面层夹层板的构造和变形特点，考虑横向剪应力在面层和芯层粘结处的连续条件，应用Ｈａｍｉｌｔｏｎ原理建立了基于五个未知函数的正交铺设复合材料面层夹层板的非线性精化理论。对静力学问题，控制方程化简为由四个基本未知函数表述。文中还分析了简支正交铺设复合材料面层夹层板的非线性弯曲，给出了载荷—挠度特征关系和板中应力的分布状况。数值计算表明，夹层板面层和芯层粘结处的层间剪应力在工程设计中是十分重要的。     

一种求解层合圆柱壳的杂交应力单元

根据修正的余能原理，推导出一种求解复合材料层合圆柱壳的杂交应力单元。取用六面体等参单元，此单元反映了各层材料性质不同及应力分布沿整个厚度不连续现象，同时计入横向剪切变形和法向挤压变形，适用于厚层壳体。文章通过实例说明此单元能准确求出各层内的应力值，实用价值高。     

Nonlinear static and dynamic analysis for laminated,annular, spherical caps of moderate thickness

Based on Timoshenko-Mindlin kinematic hypothesis, the shallow shell theory is extended to include the transverse shear deformation for the nonlinear axisymmetric dynamic analysis of the symmetric cross-ply shallow spherical shell. Using the orthogonal point collocation method and the Newmark scheme, an iterative solution is formulated. The numerical results for the nonlinear static and dynamic responses and dynamic buckling of these shallow spherical shells with circular holes under uniformly distributed static or dynamic normal impact loads are presented and compared with available data.     

Plane waves in a semi-infinite fluid saturated porous medium

The field equations governing the propagation of waves in an incompressible liquid-saturated porous medium are investigated and a general solution is presented. It has been revealed that coupled longitudinal and transverse waves propagate in the porous medium. The propagation of transverse waves in the fluid phase is completely due to the interaction between the solid and fluid phases. The dispersion relationship and attenuation features are discussed. Unlike other investigations, all explicit forms of the arguments are derived. The reflection of the plane harmonic waves at the plane, traction-free boundary, which shows the influence of the dissipation on the velocity, and the attenuation coefficients of the reflected waves is studied. It is of interest that pore pressure is produced in the process of reflection, even in the case of the incidence of transverse waves.     

Influence of surface and bulk layers on the crossover features for interaction parameters of a ferroelectric thin film

The phase diagram of a ferroelectric thin film is studied by using the usual mean-field approximation. The crossover features, from the ferroelectric-dominant phase diagram to the paraelectric-dominant phase diagram, for the physical parameters of the thin film are discussed. Special attention is devoted to the investigation of surface and bulk layers, and how to influence the crossover values of exchange interactions and transverse fields.     

电磁波在大面积等离子体片中传播特性的分析

脉冲磁约束线形空心阴极放电形成的大面积等离子体片可应用于等离子体天线、隐身及模拟超音速飞行器表面的等离子体鞘套. 本文首次利用实测等离子体片电子密度时空分布和横向场传播矩阵法, 研究了电磁波在等离子体片中反射率、透射率、吸收率随频率及脉冲放电时间的变化特征. 结果表明: 极化方向平行磁场的电磁波, 在小于截止频率的低频带内具有较高的反射率和吸收率, 增大电流, 反射率增加, 吸收率下降, 在大于截止频率的高频带内反射率和吸收率较低, 增大电流, 透射率下降, 吸收率升高; 极化方向垂直磁场的电磁波在高混杂谐振频率附近存在吸收率明显增强的吸收带, 谐振吸收峰值与放电电流无关; 脉冲放电期间, 电磁波的反射率、透射率与吸收率由不稳定过渡到稳定的时间约为100 μs, 过渡时间随着放电电流的增加而增大, 极化方向垂直磁场、小于截止频率的电磁波在稳定放电阶段谐振吸收较强. 本文的研究成果对利用等离子体片实现对电磁波的稳定高反射作用具有重要意义.     

多横模垂直腔面发射激光器及其波长特性

基于氧化限制型内腔接触垂直腔面发射激光器(VCSEL) 结构设计, 研究了VCSEL的多横模分布及其模式波长分裂特性与氧化孔径尺寸、形状的关系. 在实验基础上, 通过建立有效折射率模型, 并利用标量亥姆霍兹方程的迭代算法理论, 分别对椭圆形氧化孔径和圆形氧化孔径VCSEL的横向模式特性进行模拟研究, 计算得到不同形状孔径的多横模光场分布情况, 同时测量得到高阶横模多频输出光谱. 研究发现, 椭圆氧化孔形状不仅影响横模分布特性, 还会导致每个模式的波长产生分裂, 分裂值可达0.037 nm. 同时, 随着氧化孔径的增大, 波长分裂影响会逐渐减小, 直至趋近于圆形氧化孔径的分布特性. 研究结果为进一步实现氧化限制型VCSEL的多横模锁定提供了有益参考和借鉴.     

Unsteady boundary layers with small cross flows

Despite the intensive development of computer technology and methods of solving the Navier-Stokes and Reynolds equations, the unsteady problems of the three-dimensional boundary layer are of significant interest in aerodynamics. So far these problems have been little studied as a result of objective difficulties related with the large dimensionality of the system of equations and the complexity of its investigation [{xc1}]. Therefore, analytic results in this field are important. In the present study the unsteady three-dimensional boundary layer equations are investigated in the case of small cross flows using the perturbation method. An intermediate system of equations, which includes the basic three-dimensional effects but is significantly simpler than the initial system is derived. The features of the formulation considered are studied in relation to the important practical problems of boundary layer flow past slender wings and weakly asymmetric bodies at small angles of attack.     

FINITE LAYER ANALYSIS FOR SEMI-INFINITE SOILS (Ⅰ)——GENERAL THEORY

In the present paper a finite layer method is studied for the elastodynamics of transverse isotropic bodies. With this method, semi-infinite soils can be considered as an transverse isotropic half-space, its material functions varying with depth. Dividing the half-space into a series of layers in the direction of depth, the material functions in each layer are simulated by exponential functions. Consequently, the fundamental equations to be solved can be simplified if the Fourier transform with repsect to coordinates is used. We have obtained the relationship between the “layer forces” and “layer displacements”. This finite layer method, in fact, can also be called a semi-analytical method. It possesses those advantages as the usual semi-analytical methods do, and can be used to analyse the problem of the interaction between soils and structures. This paper is based on a portion of the author's dissertation submitted in partial fulfillment of the requirements of degree of Ph. D. at the Shanghai Institute of Appl. Math. & Mech., Shanghai.