A MODAL TESTING METHOD FOR CANTILEVER BEAM1)

基于欧拉-伯努利梁理论得到悬臂梁自由振动的振型函数。通过数值计算得出实验用的悬臂梁前五阶振型的节点位置及其与梁长的比值。考虑传感器对悬臂梁固有频率的影响,建立梁-传感器模型进行仿真分析并得出悬臂梁前五阶固有频率。基于节点位置和测点位置,在实验中选择激励点。将具体实验的结果与梁-传感器仿真模型结果进行对比,通过前五阶固有频率的误差分析,发现仿真分析结果与实验结果误差最高为 1.3%。研究完整地叙述了悬臂梁的模态测试流程,可为工程技术人员的模态测试起一定的指导作用。     

核电结构土-结相互作用分析分区混合计算方法

土-结构相互作用分析是核电结构进行抗震设计和安全评估的重要环节.在核电结构的土-结相互作用分析中,阻尼和非线性是影响结构反应的重要因素. 若采用频域分析,可以方便考虑阻尼,但需通过等效线性化来考虑非线性,不适合于强震作用下的土体非线性.若采用时域分析的逐步积分方法,适合于考虑非线性,但材料阻尼一般采用瑞利阻尼模型,除了紧靠指定阻尼比的少数几个振型外,其他振型的反应将受到瑞利阻尼模型所确定的大阻尼所抑制,造成地震反应与真实情形有较大差异.若采用时域分析的模态叠加法,可合理计入阻尼效应,但模态叠加法不能考虑非线性.因此,如何合理考虑阻尼和非线性是核电结构土-结相互作用分析需要关注的问题.基于此,本文提出一种模态叠加和时步积分结合的土-结相互作用分区算法.其中,出于安全性考虑,地震作用下核电主体结构一般不允许进入非线性,因此结构可采用模态叠加方法,以便合理考虑结构阻尼;土体和基础采用显式时步积分法,可考虑土体非线性;通过人工边界条件考虑无限域的影响 (辐射阻尼).通过简单算例对该方法进行了验证,并用于CAP1400核电结构的土-结相互作用分析中,对比分析了采用模态阻尼和瑞利阻尼时核电结构和场地反应的差异,结果表明结构阻尼模型对场地的反应影响不大,但对结构反应影响明显,在实际工程中应合理选取阻尼模型.      

Two-dimensional optical coherence tomography for real-time structural dynamical characterization

We present a two-dimensional optical coherence vibration tomography (2DOCVT) system with an ultra-precision displacement resolution of ~0.1 nm that is capable of in site real-time absolute displacement measurement of structural line vibrations. Experimental results of sinusoidal, sweep and impulse vibrations were reported. The key figures of merit such as the 2DOCVT system could obtain fast line vibration measurement without scanning and it also could be used to capture structural modal parameters in one single impulse excitation measurement without any vibration excitation input information, making it attractive for the application in low-frequency vibration measurement and response-only modal analysis.     

Effect of atmospheric pressure pulsed discharge spatial inhomogeneity on Ar I and H I lines: Electron number density study

The spatial inhomogeneity of pulsed atmospheric pressure discharge in argon is investigated using the electron number density N_e diagnostics procedure applied to asymmetrically broadened Ar I lines. A dedicated fitting procedure is used for describing Ar I 703.0 nm line shape recorded from argon gas discharge and H I (at 486.13 and 656.28 nm) lines recorded from Ar-H₂ gas mixture discharge. The results revealed the change in N_e in both axial and radial directions. The additional Ar I lines at 614.5, 710.7, 731.2, and 731.6 nm, recorded from integral spatial radiation, are analysed as well to confirm the results from the plasma column region. The possibility of using AlO (B²∑⁺–X²∑⁺) and CN (B²∑⁺–X²∑⁺) molecular bands for gas temperature T_g measurements in this type of gas discharge source is demonstrated and T_g used as an input parameter for the N_e diagnostics procedure. For the proper identification of molecular band spectral lines, the Fortrat parabolas are constructed. The results obtained from Ar I 703.0 nm line indicate three different N_e values, with N_e1 ≈ 0.6 × 10¹⁶ cm⁻³, N_e2 ≈ 3.6 × 10¹⁶ cm⁻³, and N_e3 ≈ 19 × 10¹⁶ cm⁻³ measured from the plasma column. These N_e values increase in the cathode and anode region.     

深海低声速沉积层简正波用于海底参数反演*

现有深海地声参数反演研究通常基于全波场理论,存在计算量大、多值性以及需要准确的水文环境信息等问题。针对这一问题,提出一种基于简正波频散特征的深海低声速沉积层海底参数反演方法。在南海北部大陆坡海域的一次实验中,坐底式水听器(深度约1740 m)接收的沉底弹信号中观察到一种低频成分先到而高频成分后至的到达结构,由被限制在低声速沉积层的简正波组成。通过匹配沉积层简正波60-220 Hz频段内的到达时间差对实验海域的低声速海底参数进行反演,得到沉积层厚度为16.4 m,沉积层声速为1450.5 m/s,与底质采样数据比较吻合,且具有较高的可信度,验证了所提方法的有效性。由于沉积层密度对简正波频散特征的敏感性较差,其反演结果可信度不是很高,需要进一步研究。     

Boosting Hydrogen Evolution at Visible Light Wavelengths by Using a Photocathode with Modal Strong Coupling between Plasmons and a Fabry-Pérot Nanocavity

Hot-hole injection from plasmonic metal nanoparticles to the valence band of p-type semiconductors and reduction by hot electrons should be improved for efficient and tuneable reduction to obtain beneficial chemical compounds. We employed the concept of modal strong coupling between plasmons and a Fabry-Pérot (FP) nanocavity to enhance the hot-hole injection efficiency. We fabricated a photocathode composed of gold nanoparticles (Au−NPs), p-type nickel oxide (NiO), and a platinum film (Pt film) (ANP). The ANP structure absorbs visible light over a broad wavelength range from 500 nm to 850 nm via hybrid modes based on the modal strong coupling between the plasmons of Au−NPs and the FP nanocavity of NiO on a Pt film. All wavelength regions of the hybrid modes of the modal strong coupling system promoted hot-hole injection from the Au−NPs to NiO and proton/water reduction by hot electrons. The incident photon-to-current efficiency based on H₂ evolution through water/proton reduction by hot electrons reached 0.2 % at 650 nm and 0.04 % at 800 nm.     

对胡海昌的小参数法的补充

专著提出了计算特征向量摄动的一种非模态展开法，本文对这一方法中参数μ或者矩阵μ如何选取的问题进行了研究，分析了μ的数学本质，并指出对于重特征值问题，μ只要是一个适当选定的标量常数既可，无需是个矩阵。     

转动盘一片系的循环对称模综

本文考察在任意恒定转速下叶片/轮盘系的固有模态分析,计及叶片预扭所引起的大变形效应.把群论算法用于子结构技术,通过联立迭代求出叶片/轮盘系在离心场中的平衡位置和应力分布,进而确定初应力刚度矩阵、大变形刚度矩阵,以及相应的动频模态.由于本方法考虑了叶片大变形的影响,且可消去子结构间的全体内连自由度。从而在确保精度的前提下,显著地压缩了计算的规模.实践证明本文提出的子结构联立迭代法有很好的收敛性,它使计算量有巨大的节省.     

应用结构传递函数计算高阶剩余模态

本文分析了高阶剩余模态的组成形式,提出了一种利用结构传递函数求解高阶剩余模态的方法.由于文中通过传递函数得到结构高阶剩余模态,因此实验模态技术能方便地引入模态综合之中,为模态综合技术更广泛地应用提供了方便.     

Bias in modal parameters using the direct and iterative RFP identification procedures

In the rational fraction polynomial method [1] the identification of modal parameters is obtained through a direct linear least-square optimization technique but a particular form of fitting error is minimized. An iterative algorithm has been recently developed which uses the true fitting error [2]. In this paper a statistical analysis is developed to estimate the bias effects on the identified parameters when the data are polluted with noise. Both the direct and iterative procedures are considered. Numerical simulations are used to validate the results predicted by the theoretical analysis, which shows that the iterative approach is by far more efficient than the direct method.A first version of this paper was presented at 17th Int. Seminar on Modal Analysis, Leuven (Belgium), 23–25 September 1992, and preprinted in the Proceedings.