人教版高中化学教科书“研究与实践”栏目分析与实施策略*

对人教版高中化学教科书新设计的“研究与实践”栏目的主题内容、功能价值进行分析,就如何充分发挥该栏目的教学功能和价值,发展学生的化学学科核心素养,提出了创设教学情境线索、开发为研究性学习课题、开发为校本选修课程、开发为STEM课程等实施策略。     

Experimental and theoretical investigation of CO2 and air bubble rising velocity through kerosene and distilled water in bubble column

This paper concerns with developing of parameters which influence terminal velocities of air and CO₂ bubbles in distilled water and kerosene pools. The objective of this study is to validate and correct the formulas that were developed by previous investigators for prediction of terminal velocities. The investigation revealed that the terminal velocity of a single rigid spherical bubble in Newtonian fluids can be developed by balancing of mechanical forces acting on the bubble. However, for large bubbles, because of deforming of the bubble which is a result of interfacial tension, the effect of surface tension should be considered in the terminal velocity prediction formula. By using PSO algorithm and plotting experimental data of terminal velocity against the size of gas bubbles, the suitable equation for each of systems was chosen. Results showed that Jamialahmadi model is more practical for terminal velocity prediction. Jamialahmadi model requires a modification to be utilized for air-kerosene, CO₂-kerosene, air- distilled water and CO₂-distilled water systems. The developed PSO algorithm model is accurate for prediction of experimental data with an average R² value of 0.9722.     

Guidelines for tuning the macropore structure of monolithic columns for high‐performance liquid chromatography

The ability to control the external porosity and to tune the dimensions of the macropore size on multiple length scales provides the possibility of tailoring the monolithic support structure towards separation performance. This paper discusses the properties of conventional polymer–monolithic stationary phases and its limitations regarding the effects of morphology on kinetic performance. Furthermore, guidelines to improve the macropore structure are discussed. The optimal monolithic macropore structure is characterized by high external porosity (while maintaining ultra‐high‐pressure stability), high structure homogeneity, polymer globule clusters in the submicron range, and macropores with a diameter tuned toward speed (small diameter in the 100–500 nm range using short beds) or efficiency (larger macropores in the range of 500 nm–1 μm allowing the use of longer column formats). Finally, promising approaches to control the morphology are discussed.     

D3h‐Symmetric Porphyrin‐Based Rigid Macrocyclic Ligands for Multicofacial Multinuclear Complexes in a One‐Nanometer‐Sized Cavity

The one‐step synthesis of D_3h‐symmetric cyclic porphyrin trimers 1 composed of three 2,2′‐[4,4′‐bis(methoxycarbonyl)]bipyridyl moieties and three porphyrinatozinc moieties was achieved from a nickel‐mediated reductive coupling of meso‐5,15‐bis(6‐chloro‐4‐methoxycarbonylpyrid‐2‐yl)porphyrinatozinc. Although cyclic trimers 1 were obtained as a mixture that included other cyclic and acyclic porphyrin oligomers, an extremely specific separation was observed only for cyclic trimers 1 when using columns of silica gel modified with pyrenylethyl, cyanopropyl, and other groups. Structural analysis of cyclic trimers 1 was carried out by means of NMR spectroscopy and X‐ray crystallography. Treatment of an η³‐allylpalladium complex with a cyclic trimer gave a tris(palladium) complex containing three η³‐allylpalladium groups inside the space, which indicated that the bipyridyl moieties inside the ring could work as bidentate metalloligands.     

Comparison of different injection modes in edible oil minor components analysis

Waxes and fatty acid alkyl esters are minor components used as official parameters to control the authenticity and quality of a high‐value olive oil product. A poor measurement can lead to a misleading classification of the oil. The official method requires their analysis together by capillary gas chromatography equipped with a flame ionization detector and an on‐column injector to avoid discrimination and thermal degradation. The degradation can occur to a different extent if different (and not properly optimized) injectors are used. However, other injection techniques, such as programmed‐temperature vaporizer, are much more versatile and more widespread. The aim of the present work was to compare the performance of a programmed‐temperature vaporizer injector, in on‐column and splitless mode, with the on‐column injector to analyze alkyl esters and waxes. Discrimination among high‐boiling compounds was evaluated, as well as the occurrence of thermal degradation, especially of sterols and diterpene alcohol (phytyl and geranylgeraniol) esters. A proper optimization of a programmed‐temperature vaporizer injection, with particular attention to the liner selection, was proven to provide comparable results to the traditional on‐column injection. A performance comparison was carried out both on standard mixtures and on real oil samples.     

Separation of Photosynthetic Pigments by High-performance Liquid Chromatography: Comparison of Column Performance,Mobile Phase,and Temperature

High-performance liquid chromatography (HPLC) has been commonly used as method of separating and identifying photosynthetic pigments such as chlorophylls and carotenoids because of such advantages as speed, high resolution and sensitivity. In this technique, high separation relies largely on the type of column material. This study compared the efficiency of five reverse-phase columns, C8, C18, C18 monolithic, π-NAP, and cholester, for separation of photosynthetic pigments at several fixed conditions of mobile phase and temperature. This investigation also analysed the parameters of Δt_R and t_R ratio for selected pigments and resolution for structural isomers, such as α- and β-carotene. Among above columns tested, cholester column is suitable for separation of pigments not only for a broad range of polarity, but also for hydrophobic pigments in a simple mobile phase. This finding can help in the selection of column and HPLC parameters in separating photosynthetic pigments.     

Silica‐supported polymeric monolithic column with a mixed mode of hydrophilic and strong cation‐exchange interactions for microcolumn liquid chromatography

A novel sulfonic acid group containing hydrophilic strong cation‐exchange monolith was prepared by in situ coating 5 μm bare silica particles with the copolymers of glycidyl methacrylate and pentaerythritol triacrylate and further sulfonating the prepared polymer matrix with Na₂SO₃ inside a 150 μm id capillary. The preparation conditions were investigated, and the method was described in detail. The prepared column was characterized by comparing with its counterparts reported previously in terms of matrix morphology, preparation reproducibility, permeability, swelling–shrinking behavior, mechanical stability, hydrophilicity, binding capacity, and column efficiency. The swelling–shrinking behavior of the present column in solvents of different polarities was negligible, the hydrophobicity could be suppressed at the acetonitrile concentrations higher than 40% v/v, and the binding capacities were 256 μequiv/mL and 20.1 mg/mL for Cu²⁺ and lysozyme, respectively. The minimum theoretical plate heights were 8, 10, and 13 μm, and the values of the C term in van Deemter equation were 9, 12, and 35 ms for the test analytes of Na⁺, thiourea, and cytidine 5ʹ‐monophosphate, respectively. This column exhibited an excellent performance in the separations of monovalent inorganic cations, uncharged polar, and charged polar compounds.     

Polydopamine‐assisted immobilization of zeolitic imidazolate framework‐8 for open‐tubular capillary electrochromatography

In this work, we developed a capillary column modified with zeolitic imidazolate framework‐8 as a novel stationary phase for open‐tubular capillary electrochromatography. To immobilize zeolitic imidazolate framework‐8 onto the inner surface of silica capillary, a bio‐inspired polydopamine functionalization was used to functionalize the capillary surface with polydopamine. First, a polydopamine layer was assembled inside the capillary. Second, due to noncovalent adsorption and covalent reaction ability, polydopamine could attract and anchor zeolitic imidazolate framework‐8 onto the inner surface of capillary. It has been demonstrated that zeolitic imidazolate framework‐8 was successfully grafted on the inner wall of the capillary by scanning electron microscopy, and Fourier transform infrared spectroscopy. The electro‐osmotic flow characteristics of capillaries were also investigated by varying the pH value and acetonitrile content of mobile phase. The zeolitic imidazolate framework‐8 coating not only increased the phase ratio of open‐tubular column, but also improved the interactions between tested analytes and the stationary phase. Three groups of isomers including acidic, basic, and neutral compounds were well separated on the zeolitic imidazolate framework‐8 bonded column, with theoretic plate numbers up to 1.9 × 10⁵ N for catechol. The repeatability of the prepared columns was also studied, and the relative standard deviations for intra‐ and interday runs were less than 5%.     

基于捕集柱阵列的制备型二维液相色谱纯化烟草中的4个组分

二维液相色谱(2D-LC)因具有较高的峰容量,在复杂样品的分离分析中获得了广泛的关注。然而,制备型2D-LC以纯化高纯单体为目标,在方法开发和设备构成等方面与分析型2D-LC有较大的不同,目前尚未得到充分的开发,在大规模的制备纯化中应用较少。本文以一套制备液相色谱模块为分离系统,以稀释泵、切换阀和捕集柱阵列为接口,构建了新型的制备型2D-LC系统,旨在规模化纯化多个活性成分。以烟叶中可以用作医药原料的烟碱、绿原酸、芦丁和茄尼醇等组分为目标物,考察了不同类型填料对样品的捕集效率、过载条件下的色谱保留行为等,优化了制备色谱条件。进而利用在线2D-LC系统实现了烟叶提取物的纯化,通过一次运行获得了4个高纯化合物。该系统具有中压色谱纯化成本低、系统在线运行自动化程度高、稳定性好及容易放大等优点。烟叶中活性化学成分的回收利用对促进烟草行业的发展及带动地方农业经济开发具有重大的意义。     

Preparation of open tubular capillary column covalently coated with polystyrene sulfonate with 4,4′-Azobis(4-cyanopentanoyl chloride) as polymerization initiator for electrochromatographic separation of alkaloids,sulfonamides, and peptides

An open tubular capillary electrochromatography column covalently bonded with polystyrene sulfonate was prepared via in situ polymerization using functionalized Azo-initiator 4,4′-Azobis(4-cyanopentanoyl chloride). Scanning electron, fluorescence, and atomic force microscopy techniques showed the formation of a relatively rough layer of polymer. In addition, –CN and C = O stretching vibrations from infrared spectroscopy proved the successful immobilization of the azo-initiator through covalent bonding and X-ray photoelectron spectroscopy confirmed the elemental composition of the formed polymer layer. The prepared column was found to be appropriate for small and medium-sized molecules separation. Compared to bare fused silica capillary column higher selectivity and resolution were obtained for the separation of alkaloids, sulfonamides, and peptides as a result of the electrostatic and pi-pi stacking interactions between the small organic molecules and the coated column without compromising the electroosmotic flow mobility. Separation efficiency was also increased compared to the bare capillary for the separation of alkaloids (about 1.5 times). Moreover, intraday, inter-day, intra-batch, and inter-batch relative standard deviation values of retention time and peak area of peptides were within 2% and 10%, respectively, indicating good repeatability of the column preparation procedure. The developed method for the covalent bonding of polymers through a functionalized azo-initiator could represent a promising stable method for the preparation of an open tubular column.