REBOUNDING OF GALILEAN CANNON FROM A RIGID WALL1)

研究了Galilean炮——即若干个直径递增的弹性球组成的球链---撞击刚性壁回弹的问题。采用三种力学模型：分离刚体的多次"弹性"碰撞、多刚体的接触碰撞、以及有限元模拟，对球链撞击问题进行了分析，旨在给出碰撞结束后末端小球的飞离速度与入射速度的比值。研究表明：球链碰撞反弹后将会散开，末端小球的飞离速度明显大于球链入射速度；当入射球链间存在间隙时，末端小球的速度增幅更加明显。通过实验展现了这种末端小球回弹速度增加的现象。     

货运动车组装载门凹陷对隧道内会车压力波的影响

随着我国技术经济水平的提高，电子商务产业快速发展，货运动车组应运而生。采用有限体积方法和重叠网格方法，以及SST k-ω高雷诺数湍流模型，数值模拟研究时速350 km的货运动车组在隧道内交会的压力波，探究货运动车组车体结构即装载门凹陷对隧道内交会压力波的影响。实车试验结果验证了本文数值模拟方法的准确性。研究结果表明，凹陷的装载门使平直车身处的最大正压值增大约20%~30%，且有无凹陷的装载门中心最大正压值的差异百分比维持在35%~80%，最大负压值差异百分比在20%~25%。     

DYNAMIC RESPONSE OF HIGH SPEED TRAIN MEETING IN OPEN AIR,MEETING IN TUNNEL AND PASSING TUNNEL1)

明线会车、隧道会车和过隧道工况下的气动压力波对高速列车的动力响应和运行安全产生很大影响,本文建立了三辆编组的高速列车动力学模型,通过数值仿真得到了列车在三种工况下的车体所受的气动力,基于数值积分分析了列车的动力响应和脱轨系数。研究发现：明线会车和隧道会车工况相比,车辆的侧向运动相反。 明线会车和过隧道时,气动载荷对列车的脱轨系数影响较小,而隧道会车时,气动载荷作用对尾车的安全性影响较大。     

空化可压缩流动空穴溃灭激波特性研究

为深入研究空化可压缩流动中空泡/空泡团溃灭过程中激波产生、传播及其与空穴相互作用规律,本文采用数值模拟方法对空化可压缩流动空穴溃灭激波特性展开了研究.数值计算基于OpenFOAM开源程序,综合考虑蒸汽相和液相的压缩性,通过在原无相变两相可压缩求解器的控制方程中耦合模拟空化汽液相间质量交换的源项,实现了对空化流动的非定常可压缩计算.利用上述考虑汽/液相可压缩性的空化流动求解器,对周期性云状空化流动进行了数值模拟,并重点研究了空穴溃灭激波特性.结果表明:上述数值计算方法可以准确捕捉到空穴非定常演化过程及大尺度脱落空泡云团溃灭激波现象,大尺度脱落空泡云团溃灭过程分为3个阶段:(1) U型空泡团形成; (2) U型空泡团头部溃灭; (3) U型空泡团腿部溃灭.在U 型空泡团腿部溃灭瞬间,观察到激波产生,并向上游和下游传播,向上游传播的激波与空穴相互作用,导致水翼吸力面新生的附着型片状空穴回缩,直至完全溃灭.并且空穴溃灭激波存在回弹现象, 抑制了下一周期的空化发展.      

A practicable strategy for enrichment and separation of four minor flavonoids including two isomers from barley seedlings by macroporous resin column chromatography,medium‐pressure LC,and high‐speed countercurrent chromatography

Separation of minor compounds especially with similar polarities and structures from complex samples is a challenging work. In the present study, an efficient method was successfully established by macroporous resin column chromatography, medium‐pressure liquid chromatography, and high‐speed countercurrent chromatography for separation of four minor flavonoids from barley seedlings. Macroporous resin column chromatography and medium‐pressure liquid chromatography were used for enrichment of these four flavonoids. High‐pressure liquid chromatography analysis showed the total content of these four flavonoids increased from 2.2% in the crude extract to 95.3% in the medium‐pressure liquid chromatography fraction. It was indicated that the combination of macroporous resin column chromatography and medium‐pressure liquid chromatography could be a practicable strategy for enrichment of minor compounds from complex sample. Then, high‐speed countercurrent chromatography was employed for separation of these four flavonoids using ethyl acetate/n‐butanol/water (0.1% glacial acetic acid) (4:1:5, v/v/v) as solvent system. As a result, four flavonoids including two isomers with purities higher than 98% were obtained. Interestingly, two flavonoids existing in one high‐pressure liquid chromatography peak were also successfully separated. All these indicated high‐speed countercurrent chromatography had great potential for separation of compounds with similar structures and polarities. This study provides a reference for efficient enrichment and separation of minor compounds from complex sample.     

Evolution processes of coupled thermal qubits

We investigate the quantum speed limit time (QSLT) of quantum evolution before thermal equilibrium of two coupled qubits each of which is coupled to a separate thermal bath at the same temperature within the Born-Markov approximation. The evolution process in one particular initial state can change between speed-up and speed-down two times before reaching equilibrium. We call this double cusp behaviour. This behaviour is an anomalous phenomenon in evolution processes in the weak-coupling Markovian regime. We study QSLT corresponding to all pure initial energy eigenstates and categorise them. In addition, we also display the conditions for double cusp behaviour in terms of temperature, qubit interaction and frequency.     

Continuous separation of maslinic and oleanolic acids from olive pulp by high‐speed countercurrent chromatography with elution‐extrusion mode

In this work, a continuous high‐speed countercurrent chromatography method has been developed on the basis of elution‐extrusion mode and this method was successfully applied to the separation of maslinic and oleanolic acid from the extract of olive pulp. In the process of ‘elution’, the sample solution was continuously loaded into the column and the maslinic acid was steadily eluted out in this step while highly retained oleanlic acid always stayed in the column. In the process of ‘extrusion’, the oleanlic acid was pushed out of the column with the stationary phase. In this way, we achieved a large sample loading. A total of 120 mL sample solution (about 89.55% of the column volume) which contains 600 mg olive pulp extract was pumped in the apparatus by a constant‐flow pump and the maslinic and oleanolic acids were largely separated within 120 min. Both of these two compounds presented high yields and high purities (271.6 mg for maslinic acid with 86.7% and 83.9 mg oleanolic acids with 83.4%).     

Aeroelastic analysis of cantilever plates using Peters’ aerodynamic model,and the influence of choosing beam or plate theories as the structural model

In this paper, the aeroelastic analyses of a rectangular cantilever plate of varying aspect ratio is presented. The classical plate theory has been selected as the structural model. The main point that distinguishes this study from previously reported research is employing Peters’ theory to model aerodynamic effect which is not straightforward. The Peters’ aerodynamic model was originally developed to provide lift and moment, which is only applicable to the structural model based on the beam theories. In this study, using the basic concept of the Peters’ aerodynamic model in addition to utilizing the Fourier series, the pressure distribution is derived, which makes Peters’ model applicable to structural models based on plate theory. This combination provides a much simpler state–space aeroelastic model for plates in comparison to the prevalent panel methods, which could lead to a significant reduction in computational time. In addition, the aeroelastic response of the plate with respect to changes in the structural model from the beam theory to the plate theory is evaluated. By using data from an experiment carried out at Duke University, the theoretical results are evaluated. Furthermore, the differences in structural models obtained from the plate and beam theories can be divided into two distinct parts, which are responsible for differences in bending and torsional behaviors of the structure, separately. This approach enables us to measure the effects of differences of each behavior separately, which could provide with a new insight into the problem. It has been determined that the flutter speeds obtained from the beam and plate aeroelastic models are little affected by the difference in bending behavior, but rather is mainly caused by the difference in torsional frequencies.     

The deformation and fracture of balloons

Inflation of balloons provides a straightforward way of achieving large biaxial deformations. Previous studies have shown that when a balloon bursts, crack propagation occurs at very high speed – much higher than would be expected from the low strain modulus and elastic wave velocity of the rubber. The present paper is concerned with studies of the deformation and fracture of cylindrical balloons. On inflation, the deformations of such a balloon pass through an unstable region but subsequently increase monotonically with pressure. In this relatively high pressure region, the ratio of the longitudinal and circumferential extension ratios is broadly in accord with expectations from high-strain elasticity theory when the ratio of the corresponding stresses is taken into account. On bursting, crack speeds up to around 300 m/s in this region. It is shown that these speeds are in accord with large increase in incremental moduli for the highly-strained rubber. Marked changes in crack tip profile observed at very high crack speeds are consistent with control of the rate of growth by inertia rather than by the viscoelastic properties of the rubber (as is believed to be the case at lower speeds). Consistent with this, various elastomers having different glass transition temperatures show similar crack growth behaviour in the very high speed region.     

富里叶级数的收敛速度

对正弦和余弦富立叶级数,通过合并相邻同号项,使其重排成交错级数.讨论了重排形成的交错级数的敛散性.指出根据自变量x的不同取值,该交错级数可能是单调递减或周期递减的级数.按照莱布尼茨判定法提出了不同精度要求的级数项数的计算公式.选取一到三阶收敛的富立叶级数计算了不同比值精度及差值精度要求的级数项数.计算表明,在x的取值为2π的等分点时,富立叶级数的部分和随项数的增加单调地逼近其收敛值.在x的取值为其它点时,富立叶级数的部分和随项数的增加围绕收敛值上下变动,周期地逼近其收敛值.低收敛阶富立叶级数的收敛速度较慢.要达到0.01%的精度,一收敛阶富立叶级数需要数万项,二收敛阶富立叶级数也需要数百项.在不同计算点处,要达到相同的计算精度,需要的级数项数差别较大.