一个R2上含双曲函数核的Hilbert型不等式

通过引入参数，构造了一个全平面上的、含双曲函数的非齐次核函数。利用正切函数的有理分式展开，建立了最佳常数因子与正切函数高阶导数相关联的Hilbert型积分不等式。 作为应用，通过赋予参数不同的值，建立了一些有意义的特殊结果。     

Negative thermal expansion in NbF_3 and NbOF_2:A comparative theoretical study

Thermal expansion control is always an obstructive factor and challenging in high precision engineering field. Here,the negative thermal expansion of Nb F_3 and Nb OF_2 was predicted by first-principles calculation with density functional theory and the quasi-harmonic approximation(QHA). We studied the total charge density, thermal vibration, and lattice dynamic to investigate the thermal expansion mechanism. We found that the presence of O induced the relatively strong covalent bond in Nb OF_2, thus weakening the transverse vibration of F and O in Nb OF_2, compared with the case of Nb F_3.In this study, we proposed a way to tailor negative thermal expansion of metal fluorides by introducing the oxygen atoms.The present work not only predicts two NTE compounds, but also provides an insight on thermal expansion control by designing chemical bond type.     

A MODAL TESTING METHOD FOR CANTILEVER BEAM1)

基于欧拉-伯努利梁理论得到悬臂梁自由振动的振型函数。通过数值计算得出实验用的悬臂梁前五阶振型的节点位置及其与梁长的比值。考虑传感器对悬臂梁固有频率的影响,建立梁-传感器模型进行仿真分析并得出悬臂梁前五阶固有频率。基于节点位置和测点位置,在实验中选择激励点。将具体实验的结果与梁-传感器仿真模型结果进行对比,通过前五阶固有频率的误差分析,发现仿真分析结果与实验结果误差最高为 1.3%。研究完整地叙述了悬臂梁的模态测试流程,可为工程技术人员的模态测试起一定的指导作用。     

核电结构土-结相互作用分析分区混合计算方法

土-结构相互作用分析是核电结构进行抗震设计和安全评估的重要环节.在核电结构的土-结相互作用分析中,阻尼和非线性是影响结构反应的重要因素. 若采用频域分析,可以方便考虑阻尼,但需通过等效线性化来考虑非线性,不适合于强震作用下的土体非线性.若采用时域分析的逐步积分方法,适合于考虑非线性,但材料阻尼一般采用瑞利阻尼模型,除了紧靠指定阻尼比的少数几个振型外,其他振型的反应将受到瑞利阻尼模型所确定的大阻尼所抑制,造成地震反应与真实情形有较大差异.若采用时域分析的模态叠加法,可合理计入阻尼效应,但模态叠加法不能考虑非线性.因此,如何合理考虑阻尼和非线性是核电结构土-结相互作用分析需要关注的问题.基于此,本文提出一种模态叠加和时步积分结合的土-结相互作用分区算法.其中,出于安全性考虑,地震作用下核电主体结构一般不允许进入非线性,因此结构可采用模态叠加方法,以便合理考虑结构阻尼;土体和基础采用显式时步积分法,可考虑土体非线性;通过人工边界条件考虑无限域的影响 (辐射阻尼).通过简单算例对该方法进行了验证,并用于CAP1400核电结构的土-结相互作用分析中,对比分析了采用模态阻尼和瑞利阻尼时核电结构和场地反应的差异,结果表明结构阻尼模型对场地的反应影响不大,但对结构反应影响明显,在实际工程中应合理选取阻尼模型.      

Two-dimensional optical coherence tomography for real-time structural dynamical characterization

We present a two-dimensional optical coherence vibration tomography (2DOCVT) system with an ultra-precision displacement resolution of ~0.1 nm that is capable of in site real-time absolute displacement measurement of structural line vibrations. Experimental results of sinusoidal, sweep and impulse vibrations were reported. The key figures of merit such as the 2DOCVT system could obtain fast line vibration measurement without scanning and it also could be used to capture structural modal parameters in one single impulse excitation measurement without any vibration excitation input information, making it attractive for the application in low-frequency vibration measurement and response-only modal analysis.     

Above,below, and in‐between the two glass transitions of ultrathin free‐standing polystyrene films: Thermal expansion coefficient and physical aging

In previous work we observed two simultaneous transitions in high molecular weight (MW) free‐standing polystyrene films that were interpreted as two thickness‐dependent reduced glass transition temperatures (T_gs). The weaker lower transition agreed well with the MW‐dependent T_g(h) previously reported, while the much stronger upper transition matched the MW‐independent T_g(h) previously observed in low‐MW free‐standing films. Here, we investigate the nature of these two transitions by inspecting the temperature dependence of the films' thermal coefficient of expansion (TCE) and present physical aging measurements using ellipsometry both below and in‐between the two transitions. TCE values indicate approximately 80 to 90% of the film solidifies at the upper transition, while only 10 to 20% remains mobile to lower temperatures, freezing out at the lower transition. Physical aging is observed at a temperature below the upper transition, but above the lower transition, indicative of the upper transition being an actual glass transition associated with the α‐relaxation. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 64–75     

基于泰勒级数展开的区间反演方法

实际结构或构件的几何与材料参数总包含不确定性,在对结构计算模型进行精确分析时,有时需要对参数不确定性进行量化。本文提出了一种用于区间参数识别的反演方法,即基于泰勒级数展开式分别建立参数与响应的区间中值、区间半径的对应函数关系,并通过构建两个反演问题来分步识别参数区间中值和半径,以避免区间扩张现象和简化优化反演过程。通过数值质-弹系统初步验证了方法的可行性,然后基于一组钢板的动测数据,识别了钢板的几何及材料特性参数的区间范围。研究结果表明,本文方法具有良好的区间反演精度,能有效地避免区间扩张现象,可以用于实际工程区间问题的求解。     

Soliton and other solutions to the (1+2)-dimensional chiral nonlinear Schrödinger equation

The (1+2)-dimensional chiral nonlinear Schrödinger equation (2D-CNLSE) as a nonlinear evolution equation is considered and studied in a detailed manner. To this end, a complex transform is firstly adopted to arrive at the real and imaginary parts of the model, and then, the modified Jacobi elliptic expansion method is formally utilized to derive soliton and other solutions of the 2D-CNLSE. The exact solutions presented in this paper can be classified as topological and nontopological solitons as well as Jacobi elliptic function solutions.     

乙基苯胺的转动光谱及分子结构

本文使用傅里叶变换微波谱仪研究了乙基苯胺类物质(邻乙基苯胺，间乙基苯胺，对乙基苯胺)的分子结构. 由于此类分子含氮原子(I¹⁴N=1)，因此跃迁谱线中都呈现出核四级裂分. 通过比较实验测定得到的分子结构，可总结苯胺环上不同位置乙基的取代对氨基及分子整体结构的影响.     

New interaction solutions and nonlocal symmetry of an equation combining the modified Calogero–Bogoyavlenskii–Schiff equation with its negative-order form

The nonlocal symmetry is derived for an equation combining the modified Calogero–Bogoyavlenskii–Schiff equation with its negative-order form from the truncated Painlevéexpansion method. The nonlocal symmetries are localized to the Lie point symmetry by introducing new auxiliary dependent variables. The finite symmetry transformation and the Lie point symmetry for the prolonged system are solved directly. Many new interaction solutions among soliton and other types of interaction solutions for the modified Calogero–Bogoyavlenskii–Schiff equation with its negative-order form can be obtained from the consistent condition of the consistent tanh expansion method by selecting the proper arbitrary constants.